Netgear GS308 Handleiding

Netgear Schakelaar GS308

Lees hieronder de 📖 handleiding in het Nederlandse voor Netgear GS308 (2 pagina's) in de categorie Schakelaar. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2

Installation Guide

Gigabit Ethernet Switch GS308

Estimated installation time: 5-10 minutes

Package Contents

This package includes:

•Gigabit Ethernet Switch GS308

•AC power adapter

•Installation Guide (this document)

Prepare to Install the Switch

Place the switch on a flat horizontal surface such as a table,

desk, or shelf. You can use wall-mounting screws (not provided)

to hang the switch in an open space on a wall.

Make sure the selected location is:

•Not in direct sunlight or near a heater or heating vent.

•Not cluttered or crowded. There must be at least 2 inches

(5 cm) of air space on all sides of the switch.

•Well ventilated (especially if it is in a closet).

You need a Category 3 (10 Mbps), Category 5 (100 Mbps), or

Category 5e (1000 Mbps) Ethernet cable with RJ-45 connectors

for each device you connect to the switch. Each Ethernet cable

must be less than 328 feet (100 meters).

Install the Switch and Connect Devices

1. Place the switch on a flat surface or hook it onto the screws.

2. For each device, insert one end of an Ethernet cable into a

port on the switch and the other end into the network port

on the device.

3. Connect the power adapter cord into the back of the switch

and then plug the adapter into a power source (such as a

wall socket or power strip).

4. Check the LEDs:

• Verify that the Power LED is lit.

• For each RJ-45 jack that is connected to a powered

device, check that the Link LED is lit, and it flashes when

activity occurs.

Note: If any LED does not operate as indicated go to the

Troubleshooting section.

Power

Modem

GS308 8-Port Firewall

Gigabit switch

Power

GS308_IG.fm Page 1 Tuesday, July 31, 2012 6:22 PM

July 2012

Troubleshooting

The Power LED is not lit.

• Make sure that the power cord is correctly connected.

• Make sure that the power adapter is connected to a

functioning power outlet or power strip.

• Make sure you that are using the NETGEAR power adapter

supplied with your switch.

The Port LED for a device is off or stays on continuously.

• Make sure that the cable connectors are securely plugged in

at the switch and the device.

• Make sure that the connected device is turned on.

• If the Ethernet cable is connected to a NIC or other Ethernet

adapter, make sure that the card or adapter is installed

correctly and is working.

•Make sure that the cable is less than 328 feet (100 meters).

Technical Support

Thank you for selecting NETGEAR products. After installing your

device, locate the serial number on the label of your product.

Use it to register your product at:

http://www.NETGEAR.com/register.

Registration is required to use our telephone support service.

For product updates, additional documentation, and support go

to: . http://support.netgear.com

For complete DoC, go to the NETGEAR EU Declarations of Conformity

website at:

http://support.netgear.com/app/answers/detail/a_id/11621.

WARNING: Do not stack equipment, or place equipment in tight

spaces, in drawers, or on carpets. Make sure your equipment is

surrounded by at least 2 inches (5 cm) of air space.

This symbol was placed in accordance with the European Union Directive

2002/96 on the Waste Electrical and Electronic Equipment (the WEEE

Directive). If disposed of within the European Union, this product should

be treated and recycled in accordance with the laws of your jurisdiction

implementing the WEEE Directive.

NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or

registered trademarks of NETGEAR, Inc. and/or its subsidiaries in the United States

and/or other countries. Information is subject to change without notice. Other brand

and product names are registered trademarks or trademarks of their respective

countries and Switzerland.

Technical Specifications

Standards compatibility IEEE 802.3i 10BASE-T Ethernet

IEEE 802.3u 100BASE-TX

IEEE 802.ab 1000BASE-T

IEEE 802.3x Flow Control

IEEE 802.1p and TOS priority,

WRR queuing

IEEE 802.3az

Network interface RJ-45 connector for 10BASE-T,

100BASE-TX, or 1000BASE-T

Power 12W max. and 12V @ 1.0A DC input

Power consumption (max.) 3.84W

Dimensions 158 x 102 x 26 mm

(6.22 x 4.02 x 1.02 in.)

Weight 465 g (1.03 lbs)

Operating temperature 0° to 40° C (32° to 104° F)

Operating humidity 90% maximum relative humidity,

non-condensing

Safety agency approvals

for the power adapter

CE mark, CB

Performance Specifications

Frame filter rate 14,880 frames/sec max. for 10M port

148,800 frames/sec max. for 100M port

1,488,000 frames/sec max. for 1000M port

Frame forward rate 14,880 frames/sec max. for 10M port

148,800 frames/sec max. for 100M port

1,488,000 frames/sec max. for 1000M port

Network latency (using

64-byte packets)

1000 Mbps: 3.193 s μ

100 Mbps: 10.167 s μ

10 Mbps: 82.819 s μ

Address database size 4K MAC addresses

Queue buffer 192 KB embedded

GS308_IG.fm Page 2 Tuesday, July 31, 2012 6:22 PM

Product specificaties

Merk:	Netgear
Categorie:	Schakelaar
Model:	GS308
Kleur van het product:	Grijs
Gewicht:	465 g
Breedte:	158 mm
Diepte:	102 mm
Hoogte:	26 mm
LED-indicatoren:	LAN, Power
Gebruiksaanwijzing:	Ja
Stroom:	0.5 A
Connectiviteitstechnologie:	Bedraad
Ethernet LAN:	Ja
Meegeleverde kabels:	AC
Certificering:	CE, CB
Netvoeding:	12 W
Ingangsspanning:	12 V
Ethernet LAN, data-overdrachtsnelheden:	10,100,1000 Mbit/s
Netwerkstandaard:	IEEE 802.1p, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3i, IEEE 802.3u
Power LED:	Ja
Rack-montage:	Nee
Netwerkfuncties:	Gigabit Ethernet
Bedrijfstemperatuur, bereik:	32 - 104 °F
Ethernet interface type:	Fast Ethernet, Gigabit Ethernet
Power over Ethernet (PoE):	Nee
Stapelbaar:	Nee
Max. overdrachtssnelheid:	1 Gbit/s
Ondersteunde data-overdrachtsnelheden:	10/100/1000 Mb/s
Switchingcapaciteit:	16 Gbit/s
MAC-adrestabel:	8000 entries
10G support:	Nee
Datastroombeheer:	Ja
Switch type:	Unmanaged
Aantal basis-switching RJ-45 Ethernet-poorten:	8
Netstekker:	DC-in ingang
Type basis-switching RJ-45 Ethernet-poorten:	Gigabit Ethernet (10/100/1000)
Packet buffergeheugen:	0.1875 MB
Jumbo Frames ondersteuning:	Ja
Buffergrootte:	128 KB
Stroomverbruik (typisch):	3.84 W
Bedrijfstemperatuur (T-T):	0 - 40 °C
Relatieve vochtigheid in bedrijf (V-V):	10 - 90 procent
Connectivity LEDs:	Ja
Jumbo frames:	9216
Latentie:	82.819μs/10.167μs/3.193μs