NAV-TV NTV-KIT175 Handleiding
Bekijk gratis de handleiding van NAV-TV NTV-KIT175 (6 pagina’s), behorend tot de categorie Dashcam. Deze gids werd als nuttig beoordeeld door 71 mensen en kreeg gemiddeld 4.7 sterren uit 36 reviews. Heb je een vraag over NAV-TV NTV-KIT175 of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/6
BHM
01/13/13
NTV-DOC166
Agreement End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for :
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
1 | P a g e
3950 NW 120th Ave, Coral Springs, FL 33 TEL 561-955-9770 FAX 561-955-9760 065
www.nav-tv.com info@nav-tv.com
GVIF-JAG
NTV-KIT175
Overview
The GVIF- Kit allows the user to add up to 3 video inputs and a backup camera input to the JAG
factory media screen in select Jaguar vehicles Audio integraon requires that the vehicle have .
a factory audio input.
Kit Contents
AV Input Harness
Power/CAN Harness
GVIF Video cable
GVIF- Interface JAG
Remote
RGB Input cable
Input Toggle Switch
IR Eye Harness
BHM
01/13/13
NTV-DOC166
Agreement End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for :
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
2 | P a g e
Interface Connectors
Dip Switch Sengs* Congure prior to installaon
Dip SW:
1
2
3
4
5
6
7
8
UP
Enables
RGB
Enables
V1
Enables
V2
Enables
V3
Resoluon
adjust
Aermarket
NAV
Factory or
no Rev-Cam
N/A
DOWN
Skips
RGB
Skips
V1
Skips
V2
Skips
V3
Resoluon
adjust
Factory
NAV
Acvates
aermarket
Rev-Cam
N/A
AV IN/OUT
Power/CAN
Dip Switches
Status LEDs
*Note: If the dip switches are not congured prior to
installaon you must remove power to the unit prior to
making adjustments to the dip switches. When power is
reconnected aer the dip switch adjustment the new
sengs will be stored into memory.
LCD IN/OUT
(LVDS Cable)
Touch
IN/OUT
TX/RX
BHM
01/13/13
NTV-DOC166
Agreement End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for :
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 | P a g e
Installaon
1. Locate the factory navigaon drive and gain access to the connectors. The drive usually
can be found in the trunk. Disconnect any connected harnesses to the NAV drive
temporarily .
2. Gather the provided from the GVIF- kit. Connect the ‘Power/CAN Harness’ JAG
following wires to the car:
Note: CAN connecon is not supported at this me. You must connect the GRAY wire
to a reverse lamp for reverse acvaon!
3. Disconnect the factory GVIF cable from the NAV drive, this is a
square, blue connector.
4. Connect the X provided male side (labeled ‘L IN’) of the GVIF video
cable to the NAV drive .
5. Connect the free end (removed in step 3) of the factory GVIF
video cable to the female side of the provided GVIF video cable (labeled ‘LXOUT’).
6. Connect the white end of the GVIF video cable to the interface at the port labeled ‘GVIF
IN/OUT’.
7. Connect the AV Input cable to the port on the GVIF- interface labeled JAG ‘AV IN/OUT’.
If you’re only connecng a reverse camera (and no other
inputs), the signal input from the camera must connect
to the RCA labeled . Refer to the dip-‘REAR-C’
switch sengs chart to skip/enable AV sources
upon toggle switch presses (oponal. Page 2 ).
8. Ad JAGjust dip switches on the GVIF- interface properly, refer to the chart on page 2 for
qualicaons.
9. Connect the white plug from the to the port on the GVIF- ‘Power/CAN Harness’ JAG
interface labeled ‘Power/CAN’.
Interface wires
Connect to car
Black (GND)
Chassis Ground
Red (ACC)
Accessory
Gray (Rear)
Reverse lamp 12v (if adding rear camera)
Product specificaties
| Merk: | NAV-TV |
| Categorie: | Dashcam |
| Model: | NTV-KIT175 |
Heb je hulp nodig?
Als je hulp nodig hebt met NAV-TV NTV-KIT175 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Dashcam NAV-TV
12 November 2022
12 November 2022
12 November 2022
12 November 2022
12 November 2022
12 November 2022
12 November 2022
12 November 2022
12 November 2022
12 November 2022
Handleiding Dashcam
- Nanocam+
- Cobra
- Audiovox
- Roadeyes
- Pyle
- Nordval
- BlackVue
- Minolta
- Mobileye
- EchoMaster
- Skytronic
- Garmin
- Scosche
- Hertz
- Maginon
Nieuwste handleidingen voor Dashcam
29 Juli 2025
15 Juli 2025
1 Juli 2025
30 Juni 2025
10 Juni 2025
9 Juni 2025
9 Juni 2025
8 Juni 2025
22 Mei 2025
2 Mei 2025