Metra 70-7307 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Metra 70-7307 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 7/30/18 INST70-7307
I N S TA L L AT I O N I N S T R U C T I O N S
70-7307
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink
• Tape • Wire cutter • Zip ties
TABLE OF CONTENTS
Connections ............................................................2
Hyundai/Kia Wiring Harness (with Base radio)
2017-up*
*Visit for up-to-date vehicle specific applications.MetraOnline.com
APPLICATIONS
Hyundai
Accent† 2018-up
Kia
Rio / Rio 5-door† 2018-up
Sedona† 2017-up
Soul† 2017-up
† Only for models with a Base “non-touchscreen” radio
HARNESS FEATURES
Wiring harness for installation of an aftermarket radio
Provides power and four speakers
Retains balance and fade
Provides NAV outputs (parking brake, reverse, speed sense)
Pre-wired ASWC-1 harness (ASWC-1 sold separately)
Retains the factory AUX-IN jack
Retains the factory backup camera
Retains the factory USB
OPTIONAL ACCESSORIES (sold separately)
Steering Wheel Control Interface: ASWC-1
12V TO 6V Step-Down: AX-CAM6V
Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 7/30/18 INST70-7307
I N S TA L L AT I O N I N S T R U C T I O N S
70-7307
CONNECTIONS
From the 70-7307 harness to the aftermarket radio:
Connect the wire, and also the wire labeled “Camera Ground”, to the ground wireBlack Black
.
Connect the Yellow wire to the battery wire.
Connect the wire to the accessory wire.Red
Connect the wire labeled “Camera Power 6V” to the Red Blue/Red wire from the AX-CAM6V
(sold separately).
Connect the wire to the power antenna turn-on wire.Blue
Connect the wire to the illumination wire, if applicable.Orange
Connect the wire to the right front positive speaker wire.Gray
Connect the Gray/Black wire to the right front negative speaker wire.
Connect the wire to the left front positive speaker wire.White
Connect the wire to the left front negative speaker wire.White/Black
Connect the wire to the left rear positive speaker wire.Green
Connect the wire to the left rear negative speaker wire.Green/Black
Connect the wire to the right rear positive speaker wire.Purple
Connect the to the right rear negative speaker wire.Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
Connect the wire to the parking brake wire.Light Green
Connect the wire to the VSS/speed sense wire.Blue/Pink
Connect the wire to the reverse wire.Green/Purple
If retaining the factory AUX-IN jack is desired, connect the & RCA jacks to the Red White
AUX-IN jacks.
Connect the Yellow RCA jack to the jack designated for a backup camera input.
If retaining the factory USB is desired, connect the USB cable to USB input.
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the ASWC-1 (sold separately) to retain steering wheel
audio controls. If the ASWC-1 is not being used, disregard this harness. If it is to be used,
please refer to the ASWC-1 instructions for radio connections and programming. Disregard the
harness that comes with the ASWC-1.
Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 7/30/18 INST70-7307
I N S T R U C C I O N E S D E I N S TA L A C I Ó N
70-7307
HERRAMIENTAS REQUERIDAS
Herramienta de engarzado y conectores, o pistola
de soldadura, soldadura y termocontracción
• Cinta • Cortacables • Zip lazos
INDICE
Conexiones .............................................................2
Hyundai/Kia Arnés de Cableado
(con radio Base)
2017 y mas*
* Visite MetraOnline.com para aplicaciones específicas de vehículos actualizadas.
¡PRECAUCIÓN! Todos los accesorios, interruptores,
paneles de controles de clima y especialmente las
luces del indicador de las bolsas de aire deben estar
conectados antes ciclar la ignición. Además, no
quite el radio de fábrica con la llave en la posición o
de encendido ni con el vehículo funcionando.
APLICACIONES
Hyundai
Accent† 2018 y mas
Kia
Rio / Rio 5-door† 2018 y mas
Sedona† 2017 y mas
Soul† 2017 y mas
† Solo para modelos con radio base “sin pantalla táctil”
CARACTERÍSTICAS DEL ARNÉS
Arnés de cableado para la instalación de una radio no original
Proporciona potencia y cuatro altavoces
Retiene el balance y la intensidad
Proporciona salidas de NAV (freno de mano, reversa, silencio,
sensor de velocidad)
Arnés ASWC-1 precableado (el ASWC-1 se vende por separado)
Retiene la conector AUX-IN de fábrica
Retiene la cámara de reversa de fábrica
Retiene USB de fábrica
ACCESORIOS OPCIONALES (se vende por separado)
Interfaz de control en volante: ASWC-1
12V a 6V de bajada: AX-CAM6V


Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: 70-7307

Heb je hulp nodig?

Als je hulp nodig hebt met Metra 70-7307 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Metra

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd