Metra 70-1786 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Metra 70-1786 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Receiver Wiring Adaptor
120 70-1786
Revision 05/08/18
STEP 1 -- MATCH & CONNECT WIRES
*120701786*
IMPORTANT
Before starting, compare items on your invoice with items
received. Thoroughly check packing materials. If an item
is missing, please call Crutchfield at 1-888-955-6000.
Copyright 2018 Crutchfield Corporation
Connect to RCA outputs on receiver
Yellow - 12 Volts Constant Power
Red - 12 Volts Switched Power
White - Left Front Channel
Violet - Right Rear Channel
Green - Left Rear Channel
Gray - Right Front Channel
Black - Chassis Ground
Orange/White - Illumination
Blue/White - Amplifier Turn-On
Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your
new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.
Your receiver illumination wire could be Orange or Orange/White. As with other wires, match this wire to the illumination wire in this harness
by function, not by color. If your receiver does not have an illumination wire, tape off the illumination wire.
Individually tape off any unused wires.
Make final wiring connections following instructions on the next page.
A.
B.
C.
D.
1999-'03 Mercedes E-Class may not have a match for this wire. If
not, splice the Red wire from the receiver to the Black/Yellow wire
at the factory cigarette lighter.
The wire that lines up with this slot must be
spliced into the antenna/amp remote wire
on the receiver wiring harness.
120 70-1786
Page 2
STEP 2 -- CONTINUED
A. Strip wires back 1/2”.
B. Twist wires together and
insert in crimp cap.
C. Squeeze middle of cap
for tight connection.
Copyright 2018 Crutchfield Corporation
STEP 3 -- APPLICATION
D. Complete crimp connections
for all necessary wires.
E. Be sure to wrap any wires from
the Wiring Adaptor that are
not necessary (wires with no
match from the new receiver)
with electrical tape.
STEP 2 -- CRIMP CONNECTIONS
Tools & Parts
Required
Wire Stripper/Crimp Tool Crimp Caps
Unused Wire (tape over bare wires)
Receiver Wiring Adaptor
Generic Illustration
Generic Illustration
Receiver Wiring Adaptor Connections
A. When ready to install the
receiver, plug the wiring
Adaptor from the new receiver,
or receiver assembly into the
factory radio harness(es) in the
vehicle dash.


Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: 70-1786

Heb je hulp nodig?

Als je hulp nodig hebt met Metra 70-1786 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Metra

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd