Logik L20CTH18 Handleiding

Logik Kachel L20CTH18

Lees hieronder de 📖 handleiding in het Nederlandse voor Logik L20CTH18 (4 pagina's) in de categorie Kachel. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

Safety Warnings

For your continued safety and to reduce the risk of injury or electric shock, please

follow all the safety precautions listed below. Read all instructions carefully before

using the unit and keep them for future reference.

• Retain the manual. If you pass the unit onto a third party, make sure to include this

manual.

• This appliance is intended for indoor household use and similar applications such

as:

– farm houses and by clients in hotels, motels and other residential type

environments;

– bed and breakfast type environments;

– catering and similar non-retail applications.

• Make sure your home voltage matches the voltage displayed on the appliance. If

you are not sure, contact an electrician.

• Do not kink or wrap the mains cable and plug around the appliance, as this

may cause the insulation to weaken and split, particularly where it enters the

appliance.

• Ensure the mains cable is fully extended before use and arrange it so that it is not

in contact with any part of the appliance.

• Do not pull on the mains cable. Never move, carry or hang the appliance by the

mains cable.

• Always position the appliance with the mains plug in an accessible position and

avoid the use of an extension cable as it may overheat and create a potential re

risk.

• The appliance must have a minimum 50 cm clearance around all sides of the

appliance.

• Ensure that the unit is used on a stable and level surface. If the oor surface is

uneven there is a risk that the appliance could tip over. Also, excessive vibration

and noise may occur. If the appliance should be accidentally tipped over, please

immediately disconnect from the power supply.

• Do not use the appliance in wardrobes or near fabrics or clothing. Do not stand the

appliance on deep pile carpets.

• Do not use the appliance in areas where petrol, paints or other ammable

substances are used or stored.

• Do not use in very dusty areas as dust may accumulate on the heating elements

and cause overheating.

• Do not use if there are any visible signs of damage to the appliance.

• Do not operate the appliance in direct sunlight, near heat sources, humid

environments or in places near water or other liquids such as bathrooms, showers

or swimming pools.

• Do not operate with wet hands or spill water or other liquids on to the appliance,

the mains cable or plug.

• Always unplug the appliance when not in use.

• Never leave the appliance unattended when in use.

• CAUTION: Some parts can become very hot and cause burns. Particular

attention has to be given where children and vulnerable people are present.

• The heater must not be located immediately below a mains socket.

• Do not allow children to play with the appliance or sit, stand, or climb on it.

• Do not leave children alone or unattended in the area where the appliance is in

use.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service

agent or similarly qualied person in order to avoid a hazard.

• This appliance can be used by children aged from 8 years and above and persons

with reduced physical, sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction concerning use of

the appliance in a safe way and understand the hazards involved. Children shall

not play with the appliance. Cleaning and user maintenance shall not be made by

children without supervision.

• Children of less than 3 years old should be kept away unless continuously

supervised.

• Children aged from 3 years and less than 8 years shall only switch on/o the

appliance provided that it has been placed or installed in its intended normal

operating position and they have been given supervision or instruction concerning

use of the appliance in a safe way and understand the hazards involved. Children

aged from 3 years and less than 8 years shall not plug in, regulate and clean the

appliance or perform user maintenance.

• Do not block or restrict the airow around the appliance. Position the unit so that

the air inlet and exhaust grilles are not blocked or restricted in anyway.

• Do not push any objects in the air inlet and exhaust grilles.

• Do not use the appliance with a programmer, timer or any other device that

switches the appliance on automatically. A re risk exists if the appliance is covered

or positioned incorrectly.

WARNING

In order to avoid overheating, do not cover the appliance.

IT IS HAZARDOUS FOR ANYONE OTHER THAN AUTHORISED SERVICE

PERSONNEL TO CARRY OUT SERVICING OF REPAIRS WHICH INVOLVE THE

REMOVAL OF COVERS.

TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT REPAIRS

YOURSELF.

DSG Retail Ltd. (co. no. 504877)

1 Portal Way, London, W3 6RS, UK

The symbol on the product or its packaging indicates that this product must not be disposed

of with your other household waste. Instead, it is your responsibility to dispose of your waste

equipment by handing it over to a designated collection point for the recycling of waste

electrical and electronic equipment. The separate collection and recycling of your waste

equipment at the time of disposal will help conserve natural resources and ensure that it is

recycled in a manner that protects human health and the environment.

For more information about where you can drop o your waste for recycling, please contact

your local authority, or where you purchased your product.

All trademarks are the property of their respective owners and all rights are acknowledged.

IB-L20CTH18-180627V1

Visit Partmaster.co.uk today for the easiest way to buy electrical spares and

accessories. With over 1 million spares and accessories available we can deliver

direct to your door the very next day. Visit www.partmaster.co.uk or call 0344 800

3456 (UK customers only). Calls charged at National Rate.

Thank you for purchasing your new product.

We recommend that you spend some time reading this instruction manual in order that

you fully understand all the operational features it oers.

Read all the safety instructions carefully before use and keep this instruction manual for

future reference.

Ceramic Tower Heater

Instruction Manual

L20CHT18

This product is only suitable for well-insulated spaces or occasional use.

For general information about this appliance and handy hints and tips, please visit:

www.TeamKnowhow.com/discover 0344 561 1234 or call

Product Overview

Unpacking

Remove all items from the packaging. Retain the packaging. If you dispose of it please do so

according to local regulations.

The following items are included:

• Main Unit

• Front Base

• Rear Base

• Screw x 4

Heating Function

Position the heater upright on the oor away from curtains, furniture or wall coverings before

plugging your heater into the mains socket.

• Connect the heater to the mains socket. Be sure the mains plug ts tightly in the mains

socket. A loose t will cause overheating and damage the mains plug.

• Switch the heater on by turning the Power Dial, the power indicator will illuminate.

: The heating element is o, only the fan is operating.

The heater will blow cool air out from the air outlet.

Lo: The heater is in low heat mode.

Hi: The heater is in high heat mode.

• The heater is equipped with an oscillation feature. To obtain a wider fan and heat circulation,

turn the Power Dial to the fan and heat symbols with on top.

• Adjust the Thermostat Dial to the desired position. It is recommended to select the “Max”

position to get the heater to heat up. When the heater temperature is higher than the room

temperature, the heater will continue working, but when the room temperature is higher

than the heater temperature, the heater will turn o automatically.

• To switch the heater o, turn the Power Dial 0 to “ ” position. Remove the mains plug from

the mains socket.

Cleaning

Your heater should be cleaned regularly to prevent dirt and dust from building up which will

aect its performance. Ensure the air inlet and the air outlet are not blocked. This can be done

with a vacuum cleaner, using the brush attachment.

Hints & Tips

My heater does not work when I turn it on

• Check that your heater is plugged in and the power is turned on at the mains socket.

• The heater may be overheating. Switch it o and allow it to completely cool down for at least

30 minutes, then switch it on again.

• Check that your heater is in an upright position.

• Check if the thermostat setting is too low.

• If the heater still does not work, do not try to repair the heater yourself.

If your heater’s power is automatically cut o follow the steps

below:

1. Unplug your heater and allow it to cool down for at least 30 minutes.

2. Inspect your heater. Clean your heater, if necessary. If there is any sign of physical damage

(e.g. melting or burning of the case), do not attempt to use your heater. Please leave all

maintenance work to qualied personnel.

3. Plug in the heater and switch it on again. If it cuts o again, leave all maintenance work to

qualied personnel.

Installation

1. Lay down the unit on a at stable surface, with the rear side facing up.

2. Unscrew the mains cable guard from the rear base.

3. Fit the rear base on the unit. Guide the

mains cable through the centre of the

rear base and t it into the groove of

the rear base. Screw the mains cable

guard onto the mains cable to secure

it on the rear base.

4. Connect the front base with the rear base.

5. Fix the front and rear base onto the unit by

screwing the four screws securely.

Safety Protective Devices

Overheat Protection System

The power to the heater will automatically cut o if the temperature of the heater exceeds a

certain limit. In the event of overheating, the heater will stop operating. Switch the heater o

and allow it to completely cool for at least 30 minutes. The heater will then resume operating as

normal.

Specications

Model L20CTH18

Mains supply 220-240V ~50Hz

Power consumption 1900W

Features and specications are subject to change without prior notice.

Rear Base

Front Base

Tip-over Protective Switch

When you use the heater in an upright position on a at and stable surface, the tip-over

protective switch will be on. In the event the heater is knocked over, the heater will stop

functioning automatically.

Mains Cable

Guard

Groove

Front

Base

Rear

Base

• If items are missing or damaged, please contact Partmaster (UK only).

• Tel: 0344 800 3456 for assistance.

• It is normal for the heater to emit some smell and fumes when it is turned on for

the rst time or when turned on after not being used for a long period of time. This

smell will disappear when the heater has been turned on for a short while.

• This unit will not operate if not positioned on a at stable surface or if the

thermostat setting is too low.

• Ensure you unplug your heater from the mains socket and wait for the heater to

cool down completely before cleaning.

• Do not use any detergents or abrasives and do not allow any water to enter the

heater.

Model L20CTH18

Item Symbol Value Unit Unit Item

Heat output Type of heat input, for electric

storage local heaters only (select

one)

Nominal heat

output

Pnom 1.9 kW Manual heat charge control

with integrated thermostat

Minimum

heat output

(indicative)

Pmin 1.093 kW Manual heat charge control

with room and/or outdoor

temperature feedback

Maximum

continuous heat

output

Pmax,c 2.112 kW Electronic heat charge control

with room and/or outdoor

temperature feedback

Auxiliary electricity consumption Fan assisted heat output no

At nominal heat

output

elmax 0.03 kW Type of heat output/room

temperature control (select one)

At minimum heat

output

elmin 0.03 kW Single stage heat output and

no room temperature control

In standby mode el

SB N/A kW Two or more manual stages, no

room temperature control

With mechanic thermostat

room temperature control

yes

With electronic room

temperature control

Electronic room temperature

control plus day timer

Electronic room temperature

control plus week timer

Other control options (multiple

selections possible)

Room temperature control,

with presence detection

Room temperature control,

with open window detection

With distance control option no

With adaptive start control no

With working time limitation no

With black bulb sensor no

Contact details DSG Retail Ltd. (co. no. 504877)

1 Portal Way, London, W3 6RS, UK

Product Fiche

Thermostat Dial

Base

Power

Indicator

Air Outlet

Power Dial (with

oscillation option)

The heater cannot be switched on when it is overheating. Allow it to cool down for at

least 30 minutes and then switch it on again.

• Do not override the tip-over protective switch as this may cause a hazard.

• Using the unit on a deep pile carpet may activate the tip-over protective switch.

Product specificaties

Merk:	Logik
Categorie:	Kachel
Model:	L20CTH18

Heb je hulp nodig?

Als je hulp nodig hebt met Logik L20CTH18 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Kachel Logik

Logik L18CTHB12 Handleiding

14 September 2023

Logik L20CTH10 Handleiding

14 September 2023

Logik L20ORW14E Handleiding

14 September 2023

Logik LBCONX17E Handleiding

14 September 2023

Logik L20CTH18 Handleiding

14 September 2023

Logik L15OFR15 Handleiding

14 September 2023

Logik L20CTH17 Handleiding

14 September 2023

Handleiding Kachel

Nieuwste handleidingen voor Kachel

Essentiel B ECHS 1502C Handleiding

9 April 2024

Essentiel B ECHB 933n Handleiding

9 April 2024

Essentiel B ECHS C1b Handleiding

9 April 2024

Essentiel B ECHC 2300P Handleiding

9 April 2024

Essentiel B ECSB 1500 Meca Handleiding

9 April 2024

Nobo NTL4Y Handleiding

19 Maart 2024

Alpatec PRMD 1000 Handleiding

15 Februari 2024

Alpatec PRMDT 1500 Handleiding

15 Februari 2024

Alpatec PRMDT 1000 Handleiding

15 Februari 2024

Alpatec PRMD 1500 Handleiding

14 Februari 2024