Logik L15BSS13 Handleiding

Logik Blender L15BSS13

Lees hieronder de 📖 handleiding in het Nederlandse voor Logik L15BSS13 (2 pagina's) in de categorie Blender. Deze handleiding was nuttig voor 61 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Thank you for purchasing your new Logik Blender.
We recommend that you spend some time reading this instruction manual in
order to fully understand all the operational features it oers.
Read all the safety instructions carefully before use and keep this instruction
manual for future reference.
GB-4 GB-5
DSG Retail Ltd. (Registered in England no. 504877)
Maylands Avenue, Hemel Hempstead, Hertfordshine, HP2 7TG, UK
Visit Partmaster.co.uk today for the easiest way to buy
electrical spares and accessories. With over 1 million
spares and accessories available we can deliver direct
to your door the very next day. Visit www.partmaster.co.uk or call 0844 800 3456 (UK
customers only) Calls charged at National Rate.
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the end of its
life separately from your household waste. There are separate collection
systems for recycling in the EU. For more information, please contact the
local authority or your retailer where you purchased the product.
QSG-L15BSS13-130131V1
Instruction Manual
Blender
L15BSS13
OPERATION
1. Make sure the jug and the lid are secure and in the Locked position.
2. Turn the Speed Dial to ‘0’.
3. Plug your blender into the mains socket and switch on the power.
Do not run the appliance continuously for more than 3 minutes.
After a full 3 minute cycle allow the blender to rest for another 5
minutes before using it again.
Operation
Select the desired operating speed. There are 2
speeds. Move the Speed Dial progressively to the
right to increase the speed. When you start
blending use a low speed to begin and gradually
increase the speed if necessary.
To stop, turn the Speed Dial back to ‘0’.
Use this mode when ingredients need to be
blended in small repeated bursts.
Turn the Speed Dial to ‘P’ and hold it there for a
short time.
To stop the operation, release the Speed Dial will
automatically return to ‘0’.
Continuous (Normal)
Pulse
AFTER USE
After you have nished blending:
1. Set the Speed Dial to ‘0’.
2. Hold the jug by the handle and carefully turn it clockwise (towards you) to
release the jug. (This may be easier with one hand on the base and one hand
holding the jug handle).
3. To pour out the contents, rotate the lid of the jug anticlockwise to free it and
then lift o the lid. Pour or spoon the contents out carefully.
4. Unplug the blender from the mains socket.
• Do not run the appliance continuously for more than 3 minutes.
After a full 3 minute cycle allow the blender to rest for another 5
minutes before using it again.
• Never blend very hot liquids in the blender. This is dangerous as
the contents may erupt.
• If you spill liquid on the blender base immediately switch off and
wipe dry.
During blending, you can feed in small amounts of food or liquid through the
jug lid. To do this:
1. Hold the lid.
2. Turn the stopper slowly anti-clockwise to free it and then lift it out.
3. Gradually feed pieces of food or liquids into the jug through the feeder.
4. Fit the stopper back when you have nished.
CLEANING
Cleaning the blender jug:
1. Pour about 500ml of warm soapy water into the jug and place the jug on the
base.
2. Turn and hold the Speed Dial to ‘P’ for a few seconds to loosen any food
particles and free them from the blades.
• Remove the jug, pour away the water and rinse in fresh running water.
Repeat 1 and 2 with fresh water.
• Alternatively the jug may be immersed in warm soapy water and cleaned
using a long handled brush. Do not touch the blades when cleaning.
Wash the lid and stopper separately in warm soapy water, rinse and allow to
dry.
• DO NOT wash the jug or attachments in a dishwasher.
Cleaning the base:
• Ensure the blender is switched off and unplugged from the mains.
Wipe the outer surface of the motor unit with a damp cloth. Never use abrasive
cleaners or scouring creams.
Always operate blender with cover in place.
The jug body should be handled carefully. The jug contains moving
parts - do not leave the jug immersed in water for any longer than
necessary to clean it or you may aect the operating performance of
the blender.
STORAGE
After all the components have been washed and dried, re-assemble the blender and
store it out of direct sunlight and out of the reach of children.
The cable may be wound around the lugs at the bottom of the appliance for easier
storage.
SPECIFICATIONS
Power : 230V~50Hz, 450W
Capacity of Jug : 1.5 litres max.
Duty Cycle : 3 minutes ON; 5 minutes OFF
We continually strive to improve our products, specications may change without
prior notice.
GB-3GB-1
SAFETY FIRST!
Please follow all the safety precautions listed below for safety
and to reduce the risk of injury or electrical shock.
• Read all the instructions carefully before using your appliance
and keep them for future reference.
• Unplug the appliance from the mains supply when not in use,
when removing or attaching the blender jug, or before clean-
ing any part of the appliance.
This appliance is for household use only. Do not use it for
professional catering.
• Do not use the appliance outdoors.
• Do not immerse the appliance base unit or the mains cable or
plug in liquids.
• Do not use the appliance near a source of heat or on an
unstable surface.
• Do not use your appliance in damp or wet conditions.
• Never let children operate this appliance. Close supervision is
necessary when this appliance is used near children.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have
been given supervision or instructions concerning the use of
the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• Ensure that the mains cable does not touch any hot surface
and that it does not overhang the edge of your work surface.
There are no user serviceable parts in your appliance.
• Do not operate the appliance with a damaged mains cable or
mains plug or after the appliance or any attachment has been
damaged. Seek qualied technicians for assistance.
• If the mains cable is damaged it must be replaced by the
manufacturer, its service agent, or similarly qualied persons
in order to avoid a hazard.
• Do not use attachments or accessories which are not recom-
mended by the manufacturer. They may cause malfunction or
injury.
• Store the appliance away from direct sunlight and out of the
reach of children.
When operating your blender:
• Do not place your hand in the blender jug. The sharp blade
may cause injury.
• Never insert any hard object or implement into the blender
jug when it is operating. This may cause damage to the appli-
ance and personal injury.
• Do not place meat containing bones or fruits with large hard
stones in the blender jug.
• If the blender becomes clogged, switch off and unplug the
mains cable from the mains socket before cleaning the
obstruction. Check carefully for damage.
• Do not use the appliance for any purpose not expressly speci-
ed in this manual.
GB-2
If items are missing or damaged, please contact Partmaster (UK only).
Tel: 0844 800 3456 for assistance.
* All images in this instruction manual are for indication only; please refer to your
individual unit for details.
UNPACKING
Remove all packaging from the blender. Retain the packaging. If you dispose of it
please do so according to any local regulations.
The following items are included:
The Base Unit Blender Jug
Blender Jug Cover Stopper
P 0 1 2
3
4
5
1500
1400
1300
1200
1100
1000
900
800
700
600
500
FIRST TIME USE
1. Before using your blender for the rst time, wash the jug, blade assembly, lid and
stopper. Rinse throughly and dry.
2. Place the base unit on a stable surface, free from heat and moisture and within
easy reach of a mains socket. The mains cable should not be taut.
PRODUCT OVERVIEW
P 0 12
3
4
5
Stopper
Mains Cable
Blade Assembly
Handle
Base Unit
Speed Dial
Fill Level
Safety Lid
1500
1400
1300
1200
1100
1000
900
800
700
600
500
PREPARING AND FILLING THE INGREDIENTS
1. Cut the ingredients into 25mm (1”) cubes before placing them into the blender
jug. If the food is very solid or dry, cut the pieces into smaller cubes.
2. Fill the blender jug with the ingredients.
3. Do not overll the jug. The maximum capacity is 1500 ml. If you are preparing
a large quantity use several smaller batches.
4. If the ingredients are very dry, put some liquid into the jug. You should never
try to reduce dry ingredients in the blender.
FITTING THE LID
1. Place the lid on the top of the jug and pull the lid.
• Always operate blender
with cover in place.
FITTING THE JUG TO THE BASE UNIT
Place the jug on the blade assembly as shown.
The jug will t only one way round. If the jug is
not properly tted to the base the blender will
not start.
The lid must be secured to the jug
and the jug to the base otherwise
the blender will not operate!
FITTING THE STOPPER
The stopper has an integral measuring
cup useful for measuring small amounts of
ingredients.
Place the stopper in the slots in the lid and
turn anticlockwise to lock.
To avoid splashing, always operate the
blender with the stopper rmly in place.
1500
1400
1300
1200
1100
1000
900
800
700
600
500
P 0 12
3
4
5


Product specificaties

Merk: Logik
Categorie: Blender
Model: L15BSS13

Heb je hulp nodig?

Als je hulp nodig hebt met Logik L15BSS13 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Blender Logik

Logik

Logik L100BW16E Handleiding

14 September 2023
Logik

Logik L15BSS13 Handleiding

14 September 2023
Logik

Logik L100BR16E Handleiding

14 September 2023
Logik

Logik L16BSS10 Handleiding

14 September 2023
Logik

Logik L600BK17E Handleiding

14 September 2023

Handleiding Blender

Nieuwste handleidingen voor Blender