Kenwood SJM160 series Handleiding

Kenwood Waterkoker SJM160 series

Lees hieronder de 📖 handleiding in het Nederlandse voor Kenwood SJM160 series (77 pagina's) in de categorie Waterkoker. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/77
English 2 - 4
Nederlands 5 - 8
Français 9 - 12
Deutsch 13 - 16
Italiano 17 - 20
Português 21 - 24
Español 25 - 28
Dansk 29 - 32
Svenska 33 - 35
Norsk 36 - 38
Suomi 39 - 42
Türkçe 43 - 45
Ïesky 46 - 49
Magyar 50 - 53
Polski 54 - 57
Русский 58 - 61
Ekkgmij 62 - 66
Slovenčina 67 - 70
Українська 71 - 74
Head Office Address:
Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK
www.kenwoodworld.com
Designed and engineered by Kenwood in the UK
Made in China 19695/1
SJM150 series
SJM160 series
´¸∂w
57 -77
UNFOLD
Measure 1 cup to boil faster and
save energy.
before using your Kenwood
appliance
Read these instructions carefully and
retain for future reference.
Remove all packaging and any
labels.
safety
Always use the filter and never
overfill - boiling water may splash
out.
Avoid contact with steam coming
out of the spout area when pouring
and out of the lid or spout area
when refilling.
Beware: the metal body of the kettle
will get hot during operation.
Never let the cord hang down where
a child could grab it.
Always unplug your kettle
when not in use.
Never put the kettle, powerbase,
cord or plug in liquid.
Never use a damaged appliance.
Get it checked or repaired: see
‘service and customer care’.
Caution: Do not operate the kettle
on an inclined surface.
Only use the powerbase supplied
and keep it clean and dry.
Make sure the lid is secure before
switching the kettle on.
Warning: Do not open the lid while
the water is boiling.
Take care when opening the lid -
droplets of hot water may be
ejected.
Make sure the kettle is switched off
before lifting or pouring.
Remove the kettle from the base
before filling or pouring.
Never put the kettle near or on
cooker hot plates or gas burners.
This kettle is for boiling water only.
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
ensure that they do not play with the
appliance.
Only use the appliance for its intended
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first time
1 Wrap any excess cord around the
bracket on the underside of the
powerbase .
2 Clip the into place if using
: see “using the kettle with the
”.
Your kettle can be safely used
without the , just lift out
using the central divider and use
the kettle as normal.
3 Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.
English
2
dcb
a
key
spout
finger pad
flip top lid
lid release button
water level windows
on/off switch with indicator light
360° powerbase
cord wrap
filter
a clips
b compartment
c central divider
d bypass
to use your kettle
1 Fill the kettle through either the
spout or lid. To open the lid, press
the lid release button. The water
level must be between ‘MAX’ and
1 cup (200-250mls).
Be economical: do not boil more
water than you need.
To improve the quality of your drinks
always use fresh water.
Empty the kettle after each use.
2 Check the lid is closed. Close the lid
by pushing down on the finger pad
area .
3 Plug in and switch on. The indicator
light will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
If you experience problems
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
“descaling”.
Your kettle is fitted with a filter to
hold back limescale particles.
If you find drops of water under your
kettle, don’t worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
using the kettle with the
1 Ensure the is clipped
into place correctly.
2 Pour the water into the
compartment until level with the
top of the central divider for a 1
cup measure. Adjust your fill rate to
match your required cup measure.
If the is fitted and you wish
to measure more than 1 or 2 cups,
pour the water directly into the
bypass opening .
care and cleaning
Before cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
Even though your kettle comes with
a filter, you still need to clean the
inside (and the filter) regularly.
Lift the out using the central
divider .
Wash in warm soapy water, dry and
refit by clipping back into position.
the filter
1 Open the lid.
2 Slide the filter out .
3either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 Slide the filter back in to refit.
3


Product specificaties

Merk: Kenwood
Categorie: Waterkoker
Model: SJM160 series

Heb je hulp nodig?

Als je hulp nodig hebt met Kenwood SJM160 series stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Waterkoker Kenwood

Handleiding Waterkoker

Nieuwste handleidingen voor Waterkoker