Joranalogue Select 2 Handleiding

Bekijk gratis de handleiding van Joranalogue Select 2 (6 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 49 mensen en kreeg gemiddeld 4.8 sterren uit 4 reviews. Heb je een vraag over Joranalogue Select 2 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

SELECT 2

DUAL GATED CONTROL PRECISION

VOLTAGE PROCESSOR

1

INTRODUCTION

A 'Swiss Army knife' for your modular system,

Select -2 provides two highly accurate gate

controlled voltage processors in 6 HP.These

allow you to create, switch, mute, hold, invert,

attenuatevoltages, , offset, add/and subtractmix

from slow control voltages (CVs) up to audio

frequencies.

Each processor features two signal inputs, with

the left input used by default. A gate on the

'select' input switches to the right signal input

instead. The signal inputs are normalised to the

precision +5 V reference (left) and 0 V (right).

Following the input section is a hold circuit. A

rising edge on the 'hold' input freezes the input

voltage at that moment, until the gate input

goes low again. While most sample/track--and

hold modules only manage a few seconds,

Select 2 ’s ‘low droop’ designenables it to store a

held voltage accurately for several minutes.

The end of the signal path consists of a gated

polariser/attenuverter. Using the knob, the

voltage at the output can attenuated and/or

inverted: the gain is −1 (inverted) at the minimum

setting, 0 at the centre and 1 (unity gain) at the +

maximum. The polariser can be disabled using

the 'unity' gate input. This unique ability enables

a variety of interesting gate-controlled signal

modulations. Dual-colour LEDs show the output

voltage of each processor.

Finally, if the A output left unsocket is used, the

signal is mixed together with the B output. This

enables signal offsetting, CV mixing, pitch

transposing etc.

CONTENTS

In the Select 2 box, you’ll find:

Product card, stating serial number and

production batch.

16---to10pin Eurorack power cable.

Mounting hardware: two black M3 x 6 mm

hex screws, two black nylon washers and a

hex key.

T he Select 2 module itself, in a protective

cotton bag.

If any of these items are missing, please contact

your dealer or support@joranalogue.com.

Product specificaties