JL Audio Stealthbox SB-GM-C6CONV/8W3v3 Handleiding

JL Audio Niet gecategoriseerd Stealthbox SB-GM-C6CONV/8W3v3

Lees hieronder de 📖 handleiding in het Nederlandse voor JL Audio Stealthbox SB-GM-C6CONV/8W3v3 (3 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3

INSTALLATION

D I F F I C U L T Y :

I N S T A L L A T I O N G U I D E

for the

SB-GM-C6CONV/8W3v3

SKU# 94330

2005 - 2013 Chevrolet C6 Corvette Convertible

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper installation, your new vehicle-

specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio dealer. The installation

professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle

properly. Also, keep in mind that your warranty coverage extends to 1 year if your system is installed or approved by your

authorized JL Audio dealer. If you prefer to perform your own installation, please read this installation guide completely

before beginning the process.

If you choose to perform the installation yourself, it is absolutely vital that

the Stealthbox ® be properly mounted to the vehicle according to these

instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure

caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision

or sudden deceleration.

S T E P 1

Place the convertible top in the down position, keeping the

protective lid open.

Position the seats all the way forward.

Remove the pair of rear speakers.

Continued on Next Page

S T E P 2

Pull out the pair of plastic push-in retainers. These hold the

painted interior trim piece to the rear bulkhead.

S T E P 3

Remove the pair of Allen head screws from the top side of

the painted interior trim piece.

Remove the painted interior trim piece out of the vehicle.

SB-GM-C6CONV/8W3v3 INSTR_SKU#011225

OUT

Continued on Next Page

SB-GM-C6CONV/8W3v3 INSTR_SKU#011225

S T E P 7

Position each Stealthbox® into their mounting location, with

the leg to the middle of the vehicle.

Firmly press each Stealthbox ® into the rear bulkhead.

Remove each Stealthbox® carefully, leaving the wax squares

in place. The head of the bolt will leave an impression on

each wax square.

Remove the 3/8” hex bolt from each Stealthbox ®.

S T E P 6

Fully thread in each supplied 3/8” hex head bolt into each

Stealthbox®.

S T E P 5

Place a supplied wax squares onto the driver’s side of the rear

bulkhead.

The middle of the wax square should measure 3-1/2 inches

from the top of the rear bulkhead and 3 inches from the right

of the stand out, as seen in the picture at left.

S T E P 4

Place a supplied wax square onto the passenger’s side of the

rear bulkhead.

The middle of the wax square should measure 3-1/2 inches

from the top of the rear bulkhead and 3 inches from the left

of the stand out, as seen in the picture at left.

Page 2 • JL Audio, Inc 2016

S T E P 9

With a drill and a 1/2-inch drill bit, drill through the

impression made in the wax square and into the vehicle’s

wheel well. Remove the wax squares and cut the carpet

from the area around the drilled hole, as seen in the

picture at left.

S T E P 1 1

Place a supplied 3/8” lock washer, supplied 3/8” flat washer

and supplied 3/8” fender washer onto each supplied 3/8” hex

head bolt.

Place each bolt assembly through the drilled hole from

STEP 8 & 9. This is from the back side of the rear bulkhead, into

the threaded insert of each Stealthbox ®, as seen in the picture

at left.

Using an 9/16-inch open end wrench or socket, secure the

bolt assembly. Do not over thighten the bolt assembly.

S T E P 1 0

Cut enough speaker wire to allow the run from the each

Stealthbox® location to the amplifier location.

Attach the speaker wire to the wire terminal on each

Stealthbox®. Check the woofer for proper operation.

Place each Stealthbox® into their mounting position. Bring

the speaker wire through the factory speaker mounting

holes.

S T E P 8

Note: Before drilling, make sure that you are not going

to be drilling into any gas lines, brake lines, transmission

lines, electrical wiring, or anything else that might

cause a reduction in your weekly pay. Always wear eye

protection when drilling!

With a drill and a 1/2-inch drill bit, drill through the

impression made in the wax square and into the vehicle’s

rear bulkhead. Remove the wax squares and cut the carpet

from the area around the drilled hole, as seen in the

picture at left.

3 inches

3 1/2 inches

3 inches

3 1/2 inches

SB-GM-C6CONV/8W3v3 INSTR_SKU#011225

C O N G R A T U L A T I O N S

You have completed the installation for this model!

Please refer to the Power Recommendation section for an

amplifier recommendation and basic set-up help.

S T E P 1 4

From the back side of the rear bulkhead, place the last pair of

bolt assemblies through the factory holes.

Place a supplied 5/16” flat washer onto each hex head bolt,

between the painted interior trim piece and in front of the

rear bulk head.

Hand tighten these bolt assemblies to the coupling nut that

is attached to the painted interior trim piece.

S T E P 1 3

Place the painted interior trim piece back into the vehicle.

Mount the painted interior trim piece with the Allen screws

that were removed in STEP 3.

S T E P 1 2

Place a supplied 5/16”lock washer and then a supplied 5/16”

flat washer onto each 5/16” hex head bolt.

From inside the trim piece, place two of these bolt assemblies

through the holes that are on the back side of the trim piece.

Place a supplied 5/16” flat washer onto each exposed 5/16”

hex head bolt. Hand tighten each supplied coupling nut onto

each 5/16” hex head bolt. Look to STEP 14 for a cross section

illustration.

Page 3 • JL Audio, Inc 2016

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered

trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

For more detailed information please visit us online at www.jlaudio.com.

(954) 443-1100

w w w . j l a u d i o . c o m

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A

I N C L U D E D H A R D W A R E

(2) 3/8 -16 x 1“ Hex Head Bolts 3/8” x 1-1/4” Fender Washers (2)

(4) 5/16” Split Lock Washers 3” x 3” Wax Squares (2)

(2) (2) 3/8” Split Lock Washers 5/16 - 18 x 7/8” x 9/16” Coupling Nuts

(4) (4) 3/8” x 2” Fender Washers 5/16 - 18 x 1/2” Hex Head Bolts

(8) 5/16” Flat Washers

S P E C I F I C A T I O N S

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: 8W3v3-4

Nominal Impedance: 2 ohm mono or 4 ohm stereo

Continuous Power Handling: 500 Watts

P O W E R R E C O M M E N D A T I O N

JL Audio recommends using a high quality amplifier such as the JL Audio XD300/1v2.

The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the XD300/1v2

when being used to power your Stealthbox ®.

The JL Audio XD300/1v2 is a very versatile audio component. Please consult the owner’s manual for even more

detailed information about installing and tuning this amplifier.

M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 10-inches / Front Doors

*Fits JL Audio Models: TR650CSi, TR650-CXi, C2-650, C2-650x,

C3-650, C5-650, C5-650x, & ZR650-CSi

*Speakers require custom adaptors for installation.

Rear Speaker Size / Location: 5.25-inches / Behind Seats

*Fits JL Audio Models: TR525-CXi, C2-525x, C3-525, & C5-525x

*Installation of Stealthbox® prevents installation of rear speakers

Product specificaties

Merk:	JL Audio
Categorie:	Niet gecategoriseerd
Model:	Stealthbox SB-GM-C6CONV/8W3v3

Heb je hulp nodig?

Als je hulp nodig hebt met JL Audio Stealthbox SB-GM-C6CONV/8W3v3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd JL Audio

JL Audio MediaMaster MM105-HR Handleiding

11 Maart 2024

JL Audio JLINK RX Handleiding

8 Januari 2024

JL Audio Stealthbox SBA-J-JK-FHB Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-GM-BURBCNSL/10W3v3 Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-F-SUPRDTY/10W1v3 Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-D-QDRAM/10W3v3 Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-GM-C6CONV/8W3v3 Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-J-JL4DDRV/10TW1-4 Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-F-F1502/10W3v3/TN Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-N-350/10W3v3 Handleiding

31 Augustus 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Playtive IAN 327221 Handleiding

1 Mei 2024

Samsung UN32J4001AF Handleiding

1 Mei 2024

Bauknecht KSI 18GF2 P2 Handleiding

27 April 2024

Fakir Artemis TS 150 Handleiding

26 April 2024

Sony UTX-M03 Handleiding

26 April 2024

Sony URX-P03 Handleiding

26 April 2024

Sony WRU-806B Handleiding

26 April 2024

Sony UTX-B03 Handleiding

26 April 2024

Sony UTX-P03 Handleiding

26 April 2024

Sony ODS-L10 Handleiding

26 April 2024