JL Audio AP300/4 Handleiding

Bekijk gratis de handleiding van JL Audio AP300/4 (12 pagina’s), behorend tot de categorie Receiver. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 4.4 sterren uit 5 reviews. Heb je een vraag over JL Audio AP300/4 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

JL AUDIO

®

AP AMPLIFIERS

Installation Instructions

Important Safety Information

WARNING

See the guide in the product box for product warnings and other Important Safety and Product Information

important information.

This device must be installed according to these instructions. Failure to install this device in accordance with

these instructions could result in serious personal injury, damage to the device and/or vessel, or poor product

performance.

Disconnect the power supply to the vessel's audio system before beginning to install this device. To avoid

possible serious personal injury or damage to the device and vessel, disconnect the power supply to the

vessel's audio system before beginning to install the device.

Continuous exposure to sound pressure levels over 100dBA may cause permanent hearing loss. The volume

is typically too loud if you cannot hear people speaking around you. Limit the amount of time you listen at high

volume. If you experience ringing in your ears or muffled speech, stop listening and have your hearing checked.

The wiring from the power source to the amplifier must run through an inline fuse or circuit breaker (not

included) as close to the power source as possible. You must connect the positive wire to the fuse or circuit

breaker. Connecting the amplifier to power without an inline fuse or circuit breaker may result in a fire if there is

a short in the cable.

CAUTION

Install in a dry, well-ventilated location that does not interfere with your factory-installed systems. Mount this

product securely to prevent damage or injury in severe conditions. Carefully route all system wiring away from

moving parts and sharp edges; secure with cable ties or wire clamps and use grommets and loom where

appropriate to protect from sharp edges.

To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,

cutting, or sanding.

NOTICE

Only use this product with 12 volt, negative-ground electrical systems. This product is not certified or approved

for use in aircraft.

For ABYC

®

and NMEA

®

applications, circuit protection is required within 18 cm (7 in.) of the battery, unless the

cable is an enclosure or a conduit.

This product is water-resistant. Do not submerge the device or subject it to high-pressure water spray. Exposure

to water pressures beyond the listed water rating can damage the device.

When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.

It is strongly recommended that you have your audio system installed by a professional installer to ensure

optimum performance.

You must read all installation instructions before beginning the installation. If you experience difficulty during

the installation, go to for product support.support.garmin.com

After installing an audio system, you should run the connected speakers and subwoofers at low to medium

volumes during their first few hours of use. This helps to improve the overall sound by gradually loosening

up the moving components in the new speakers and subwoofers, such as the cone, spider, and surround.

See the installation instructions provided with your speakers, because there may be more details about the

recommended low-to-medium volume usage time for each model.

January 2026GUID-825043EC-AB52-4D71-959C-5ABABAC34D9B v3

Product specificaties