Imarflex IB-655GC Handleiding

Imarflex Blender IB-655GC

Lees hieronder de ๐Ÿ“– handleiding in het Nederlandse voor Imarflex IB-655GC (4 pagina's) in de categorie Blender. Deze handleiding was nuttig voor 4 personen en werd door 2.5 gebruikers gemiddeld met 4.4 sterren beoordeeld

Pagina 1/4
+
SPECIFICATION
MODEL NO. : -655GC IB
RATED VOLTAGE : 230Va.c. 60Hz
POWER CONSUMPTION : 600 Watts
BOX DIMENSION : ______________
UNIT DIMENSION : ______________
GROSS WEIGHT : ______________
UNIT WEIGHT : ______________
RPM
: Medium Speed RPM_____
: Low Speed RPM________
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. Read all instructions thoroughly.
2. Before using the unit, check if the voltage indicated matches the
convenience outlet (230Va.c.).
3. Do not use the two-way socket with another appliance.
4. Do not use any appliance with a damaged cord or plug. If the
cord is damaged, it should be replaced with the same type and
size, or the unit should be taken to the nearest Imar๎›Šex
Authorized Service Center.
5. Do not place the unit near a gas stove, electric burner, or in a
heated oven.
6. Place the unit on a stable surface; keep it away from the edge of
the counter to avoid accidents.
7. Children should be supervised to ensure they do not play with
the appliance.
8. This appliance is not intended for use by persons (including
children) with reduced physical, sensory, or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
9. The maximum continuous operating time of the blender is one
minute only. Do not exceed this maximum operating time, as it
may cause damage to the unit.
10. To protect against electric shock, do not immerse the base in
water or any other liquid.
11. Extreme caution must be exercised when using an appliance
containing hot liquid in the blender, as it can be ejected due to
sudden steaming.
12. The use of accessories or equipment not supplied by the
manufacturer may cause damage or malfunction of your
appliance or result in injuries.
-1-
TROUBLE SHOOTING
REMINDER: Please do not forget to register your
product warranty through the warranty registration
website at
https://imar๎›Šex.ph
tributed By: Evergood Unlimited Corp.
901 G.Masangkay St., Manila
Made in China
-6-
PROBLEM
CAUSE
SOLUTION
Motor not
working
1. The convenience
outlet is not working.
2. The unit is
damaged.
1. Check if the outlet
the unit is plugged into
is working.
2. Inspect the unit for
any visible damage.
3. If the issue persists,
bring the unit to the
nearest Authorized
Imar๎›Šex Service
Center.
Motor stop during
operation
1. Overload protection
has been activated.
1. Unplug the unit and
allow it to rest for at
least 1 minute.
Smoke and burnt
smell occurred
1. The unit is being
used for the ๎›‰rst time.
1. This is normal
during the ๎›‰rst use.
Leak on the
bottom of the jar
1. The rubber packing
is not installed
properly.
2. The rubber is
damaged.
1. Turn o๎™ƒ the unit,
remove the jar, and
check the rubber
packing. Reassemble
the unit properly.
2. Replace the rubber
with a new one.
3. If the issue persists,
bring the unit to the
nearest Authorized
Imar๎›Šex Service
Center.
Attachment not
functioning
1. The attachment is
not properly installed.
1. Turn o๎™ƒ the unit,
check the attachment,
and ensure it is
correctly assembled.
5. Always wring excess water out of the cloth or sponge when
cleaning around the controls or any electrical components.
Lid/Center Lid
Wash in warm soapy water, rinse under clean running water, and dry.
Reassemble before use.
Container and Blade Assembly
Method #1
1. After use, add warm water and a splash of vinegar to the blender jar.
Turn the unit ON and let it run for about 30 seconds. Pour out the
liquid and rinse the blender jar well.
Method #2
2. Fill the blender jar halfway with warm water, add a small amount of
dish detergent, and turn the unit ON for about 30 seconds. Repeat if
needed. Rinse well.
Method #3
If the blender has been left sitting with dried, crusty food bits inside:
Fill the jar with warm, soapy water (or vinegar water) and let it sit for
about 30 to 60 seconds. Empty the water to about half, then blend in 30-
second intervals until clean.
1. Turn OFF the unit and wait for the blade and motor to stop.
2. Always unplug the unit after every use.
3. Remove the blade assembly by turning it counter-clockwise.
4. Wash the rubber packing and jar support with soap and water.
5. Turn the plastic jar upside down to remove excess water.
6. Wipe the plastic jar and blade with a soft cloth to dry. Be sure to
reassemble the unit properly before storing it.
7. Never leave food inside the blender jar for an extended period.
8. Store the blender in a dry, cool place.
NOTE: NEVER ALLOW THE BOTTOM OF THE BLADE TO GET WET.
-5-
13. Use on a hard, ๎›Šat, level surface only, to avoid obstruction of
air๎›Šow underneath the appliance.
14. Carry or move the blenderโ€™s glass jar only by its handle.
15. The blade is sharp handle it carefully. โ€”
16. Do not place the blade assembly on the base without the glass
jar.
17. Do not use the blender if the glass jar is cracked.
18. This appliance is not intended for outdoor use.
19. Never place the blender near hot surfaces.
20. In case of malfunctions, please take the blender to the nearest
Authorized Imar๎›Šex Service Center.
21. Avoid water spillage into the socket, connector, cord, or similar
components.
22. Switch o๎™ƒ the appliance before removing the glass jar from the
motor base.
23. Do not use this unit for anything other than its intended purpose.
24. For household use only; not intended for commercial purposes.
25. Save this instruction manual for future reference.
DESCRIPTION OF PARTS
Control Panel
-2-


Product specificaties

Merk: Imarflex
Categorie: Blender
Model: IB-655GC

Heb je hulp nodig?

Als je hulp nodig hebt met Imarflex IB-655GC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden