HQ EL-PIRLA90 Handleiding

HQ Bewegingsdetector EL-PIRLA90

Lees hieronder de 📖 handleiding in het Nederlandse voor HQ EL-PIRLA90 (75 pagina's) in de categorie Bewegingsdetector. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/75

29-02-2012

EL-PILRLA90

MANUAL (p. 2)

Solar sensor lamp ANLEITUNG (S. 7)

Solar-Sensorleuchte

MODE D’EMPLOI (p. 12)

Lampe à détecteur et panneau solaire GEBRUIKSAANWIJZING (p. 17)

Sensorlamp met zonnepaneel

MANUALE (p. 23)

Lampada a sensore solare MANUAL DE USO (p. 28)

Lámpara de sensor solar

HASZNÁLATI ÚTMUTATÓ (o. 33.)

Szolár mozgásérzékelő lámpa KÄYTTÖOHJE (s. 38)

Liiketunnistin

BRUKSANVISNING (s. 43)

Solcellsdriven utelampa med

rörelsedetektor

NÁVOD K POUŽITÍ (s. 48)

Solární senzorové osvětlení

MANUAL DE UTILIZARE (p. 53)

Lampă solară cu senzor ΕΓΧΕΙΡΙΔΙΟ XPHΣ ΣH (σελ. 58)

Ηλιακό φωτιστικό με αισθητήρα κίνησης

BRUGERVEJLEDNING (s. 63)

Soldreven sensorlampe VEILEDNING (s. 68)

Solcellelampe

ENGLISH

Solar sensor lamp

Installation Guide

HIGH SENSITIVITY from motion activity coming across the detector.

Fluctuation angle adjustment

LOW SENSITIVITY from motion activity coming towards the detector.

Rotation angle adjustment

• The light fixture should be installed on a flat and stable surface.

• Avoid placing objects in front of the motion detector that may affect detecting performance.

• Avoid installing the light near an air conditioner, a central heater, or any high voltage system.

• Avoid placing the motion detector head facing toward street traffic or other movements. This will

result in a false trigger that will prompt the light to illuminate excessively and drain the battery life.

• Motion detection is most sensitive to movement across the device and less sensitive to motion

moving towards or away from it (see pictures below).

• The solar charger board should be set in a sunny area where the maximum amount of sunlight can

be collected. Typically, the solar board should face in a direction (south) where sunlight can charge

the board for at least 3 hours per day (5 hours per day if behind glass). It is recommended that you

charge the light for 24 hours before its first use.

• Use a soft wet cloth to periodically (at least once a year) clean the charger board to avoid the

reduction of power output due to accumulated dust.

Sensor Information

Quick Setup Procedure

Warning! 1. Please keep the product away from children.

2. This product can installed for outdoor use, but we recommend

against that for rain/storm & high lights.

15m

Correct angle

180°

Detection angle

Note: Please bring the following tools

Pencil Electric drill Hammer Screwdriver

1. Mark the wall where you wish to mount the light.

2. Drill all four holes.

Place the mount on the wall with nylon anchors (if needed) and screws.

3. Please connect the battery according to the diagram in the warning part of the instruction book,

and assemble the battery cover as it was.

4. Slide the light into the mount, then screw in the bottom bolt.

5. Mount the solar board with screws. Adjust the direction it faces.

Product specificaties

Merk:	HQ
Categorie:	Bewegingsdetector
Model:	EL-PIRLA90
Kleur van het product:	Grijs
Gewicht verpakking:	1640 g
Montagewijze:	Muur
Afmetingen verpakking (BxDxH):	215 x 255 x 245 mm
Type beeldsensor:	Passieve infraroodsensor (PIR)
Ingangsspanning:	7.8 V
Maximumbereik:	8 m
Bedrijfstemperatuur (T-T):	-20 - 40 °C