Harley Davidson J03893 (2005) Handleiding

Bekijk gratis de handleiding van Harley Davidson J03893 (2005) (2 pagina’s), behorend tot de categorie Motor. Deze gids werd als nuttig beoordeeld door 15 mensen en kreeg gemiddeld 4.3 sterren uit 4 reviews. Heb je een vraag over Harley Davidson J03893 (2005) of wil je andere gebruikers van dit product iets vragen? Stel een vraag

-J03893REV. 2005-08-10

FLHTCUSE HEATED SEAT KIT

GENERAL

Kit Number

51718-06

Models

This kit fits 1997 and later FLHT/I (Electra Glide

®Standard),

FLHTC/I (Electra Glide Classic) and FLHTCUI (Ultra Classic®

Electra Glide), and 1998 and later FLTR/I (Road Glide®)

models.

Additional Parts Required

If another accessory is already using the accessory circuit

connector [4] (under the seat, see Figure 1), the Heated Seat

Kit will require a Switched Circuit Adapter Harness (Part No.

70264-94A), available separately from a Harley-Davidson

dealer.

Electrical Overload

It is possible to overload your motorcycle's charging

system by adding too many electrical accessories. If your

combined electrical accessories operating at any one time

consume more electrical current than your vehicle's

charging system can produce, the electrical consumption

can discharge the battery and cause vehicle electrical

system damage. See a Harley-Davidson dealer for advice

about the amount of current consumed by additional

electrical accessories, or for necessary wiring changes.

(00211b)

When installing any electrical accessory, be certain not

to exceed the maximum amperage rating of the fuse or

circuit breaker protecting the affected circuit being modi-

fied. Exceeding the maximum amperage can lead to elec-

trical failures, which could result in death or serious injury.

(00310a)

The Heated Seat requires up to additional current4.2 Amps

from the electrical system.

Kit Contents

Table 1.Kit Contents

Part NumberDescription (Quantity)

Not Sold SeparatelyHeated seat

51479-06Grab strap

INSTALLATION

1. For 2006 and later FLHT/I/C/CI/CUI, and ALL FLTR

models:

a.Follow the instructions in the Owner's Manual to

remove the left-side and right-side saddlebags

b.Remove the bolts and flat washers to remove the

passenger grab strap and saddlebag front mounting

brackets from the chrome frame tube covers.

c.Remove the passenger grab strap.

2. ALL models:Follow the instructions in the Owner's

Manual to remove the seat.

To prevent accidental vehicle start-up, which could cause

death or serious injury, disconnect negative (-) battery

cable before proceeding. (00048a)

3.Follow the instructions in the Owner's Manual to remove

the negative (-) battery cable from the battery.

4.See Figure 1. Identify and remove the plug from the

accessory circuit connector [4] in front of the battery.

is01034

Figure 1. Accessory Circuit Connector [4] (2004 and Later

Shown)

5.Locate the heated seat connector on the underside of the

heated seat.

-J038931 of 2

Product specificaties