Hager JK106BGSPD Handleiding

Hager Niet gecategoriseerd JK106BGSPD

Lees hieronder de 📖 handleiding in het Nederlandse voor Hager JK106BGSPD (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2

JK1 Surge Protection Instructions

Instruction leaflet for fitting 125A Surge

Protection

4 pole busbar to be fitted after fitting incomer and phase links (see

incomer instructions).

Please refer to the incomer fitting instructions for fitting of incomer links.

Ensure that all electrical connections on the incomer device are

tightened to 3.5Nm.

Ensure the copper link upper connection points are tightened to 5Nm.

JK101SPD

JK102SPD

Pozidrive

PZ2

2.5mm

8mm

Socket

1ZD0 - Issue 0 -1868 1 8 9

ZD00868ZD0868

Clip the odule device 4 m surge protection to the

dinrail next to the chosen incomer. (If 3 pole

substitute the neutral connection block with the

KRN199, copper neutral link and M6 carp nut and

tighten the nut to 5Nm.

M s tightened ake ure the phase not links are fitted but

into the incomer terminals.

P KB phaslace the 663E 4 busbar pole into the e

and neutral of the and terminals main switch tighten

the main switch screws. Push the shroud of the

busbar down onto the surge device making sure to

keep it level all and tighten 8 screw terminals to

3.5Nm.

Place the copper earth component into the bottom

two cage terminals and secure to 3.5Nm.

Connect the opposite end to the enclosure using the

2 hex head high-tourqe screws to 3.5Nm.

and fit the shroud provided with the incomer kit by

cutting out the extra modules to accommodate the

surge protection device.

1. 1 x Type I+II or Type II Surge

Protection device

2. 1 x Copper Earth Link

3. 2 Hex head Earth screws x

4. 1 x KB663E Busbar (4 pole)

5. 1 x KRN199 Terminal block

6. 1 x ZB0220 M6 Carp Nut

7. 1 x Neutral link

Parts list:

The device may only be connected and installed by an electrically skilled person. National standards and safety regulations must be observed.

The device must be checked for external damage prior to installation. If any damage or other defects are detected in this check, the device must not be installed.

Its use is only permitted within the limits shown and stated in the installation instructions.

Opening or otherwise tampering with the device invalidates the warranty.

•Disconnect protective g the plu before conducting insulation