Geba Tronic DC 2 EN ECO Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Geba Tronic DC 2 EN ECO (27 pagina's) in de categorie Garagepoortopener. Deze handleiding was nuttig voor 32 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/27
DC 2 – EURO ECO
DC 2 – EURO deluxe
Installation
Manual
EURO ECO / EURO deluxe
DC 2
DC 2 - Control Unit
conforms to DIN EN 12453
Installation Manual
DC 2 – EURO ECO
DC 2 – EURO deluxe
Installation
Manual
Table of contents
Security instructions and technical data p2
DC – 2 EURO ECO
1-phase 230VAC motor and build-in-starters p3
Layout p4
Programming p5
Optional programming radio control p6
Troubleshooting p7
DC – 2 EURO deluxe
1-phase 230VAC motor and build-in-starters p3
Layout p8
Status display p9
Programming p10-11
Troubleshooting p12
Connection and Accessories for DC – 2 EURO ECO and DC – 2 EURO deluxe
Limit switches p13
KDT 2 / M-Series 2T and KDT 3 push button p14
M-Series 1T, emergency stop / KDT 1 and ES Series p15
J Series and J Series with Stop p16
LS 1 and LS 2 photo beams p17
Safety-edge Pro-Sec-O p19
Connection and Accessories for DC – 2 EURO deluxe only
LS 2 and LS 3 reflector photo beams p18
LS 4 Photobeam and 8k2 resistorΩp19
Signal light 230VAC and Court light 230VAC p20
Cody wiring and programming p21-22
Transponder wiring and programming p23-24
Radio control programming p25-26
1
DC 2 – EURO ECO
DC 2 – EURO deluxe
Installation
Manual
The door control DC 2 EURO is designed for hold to run control of power operated doors. The basic version is
designed for hold to run operation only, and you are not allowed to use the automatic function without using
additional safety devices.
Safety Directions
•
In case of using DC 2 EURO with a permanent mains connection, an all-pole main switch with an appropriate back-up fuse must
be provided.
•
Before operation, check whether the permissible mains voltage range of the device corresponds to the local mains voltage.
•
Please note that the door control as well as the motor are for indoor installation only.
•
During installation, initial operation, maintenance and testing of the DC 2 EURO it is necessary to observe the safety and accident
prevention regulations valid for the specific application. Only trained electrical craftsmen should work on electrical equipment.
Appliance according to the regulations
The door control DC 2 EURO is provided for the operation of sectional-, rollershutter-, folding- and swingdoors.
The manufacturer of the complete installation is responsible. He must take care that the relevant standards and
guidelines (e.g. DIN 1986, EN 12050) have to be respected.
He must take care that a technical documentation of the whole installation is made available.
The technical documentation must be added to the door unit.
Installation, operating and use of the unit against this manual or the described technical specifications causes danger for
persons and produces a liability- and obligations release.
National and regional precautions and standards for the installation, as well as safety precautions of local technical
standards have to be respected.
Technical data
Model DC 2 – EURO deluxe DC 2 – EURO ECO
Supply voltage 230VAC 4,5VA 230VAC 4,5VA
Frequency 50 Hz 50 Hz
Protection class IP 54 IP 54
Outputs motor 3x NO relay contact 230 V / 5 A
2x NO relay contact 230 V / 2 A
1x unregulated supply voltage
24V DC, max. 50mA
3 x NO relay contact 230 V / 5 A
1x unregulated supply voltage
24V DC, max. 50mA
Wiring 1,5 mm² max. 1,5 mm² max.
Operating temperature - 10 C° to + 55 C° - 10 C° to + 55 C°
2


Product specificaties

Merk: Geba Tronic
Categorie: Garagepoortopener
Model: DC 2 EN ECO

Heb je hulp nodig?

Als je hulp nodig hebt met Geba Tronic DC 2 EN ECO stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Garagepoortopener Geba Tronic

Handleiding Garagepoortopener

Nieuwste handleidingen voor Garagepoortopener