Forte Lighting 7120-05 Handleiding
Pagina's 1 Lamp
Bekijk de handleiding van Forte Lighting 7120-05 gratis online of download de PDF. 20 mensen vonden deze handleiding nuttig. Vraag over dit model? Stel een vraag
7120-05
Install light bulbs (not included) in accordance with the fixture’s
specifications. Do not exceed the recommended maximum wattage.
Carefully remove all contents from the carton. See the
important notes above. Shut off the power at the circuit
breaker and completely remove the old fixture from the
ceiling, including the old crossbar. Remove the crossbar
assembly from the bag. Crossbar (B) contains several
pairs of threaded holes. Find the pair of holes that matches
the spacing of the holes on the junction box and the fixture’s
canopy. Two mounting screws (A) should be attached to
crossbar (B). You may need to tighten nuts (C) to hold these
screws in place. Pull the house wires through the center of
crossbar (B). Place crossbar (B) over the junction box so
that mounting screws (A) are vertical and aligned with
the hole locations on the fixture’s canopy (F). Secure
crossbar (B) to the junction box by tightening the screws.
crossbar
crossbar
There are an 18 inch rod (K), a 12 inch rod (L), and a 6
inch rod (M) included for each fixture. Determine the correct
number of rods needed for proper hanging height. To lengthen
the fixture, add additional rods. If additional rods are needed,
contact the place of purchase to order. To shorten the fixture,
trim the wires to the desired length, leave at least 8 to 10 inches
of wire in addition to the desired length and slide any excess
rods off to discard. Keep in mind that you must use at least the
provided 6 inch rod (M) to hang the fixture. Thread the wires
Push canopy (F) up to the ceiling and tighten the deco nuts (H)
onto the exposed mounting screws (A).
through the rods and pull the wires until taut before
connecting the rods together. Thread bottom rod (M)
onto nipple (N) on the fixture. Thread the nipple of the
top rod onto swivel post (I) of canopy (F). Pull the fixture
wires through the top of the canopy.
SMOOTH
Product specificaties
| Merk: | Forte Lighting |
| Categorie: | Lamp |
| Model: | 7120-05 |
Heb je hulp nodig?
Als je hulp nodig hebt met Forte Lighting 7120-05 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Lamp Forte Lighting
Forte Lighting 2685-01 Handleiding Forte Lighting 2688-01 Handleiding Forte Lighting 7108-01 Handleiding Forte Lighting 7096-06 Handleiding Forte Lighting 2745-06 Handleiding Forte Lighting 2748-05 Handleiding Forte Lighting 2743-06 Handleiding Forte Lighting 2743-03 Handleiding
Alle Forte Lighting Lamp handleidingen
Populair in Lamp
Forte Lighting 2651-01 Handleiding Forte Lighting 2678-01 Handleiding Forte Lighting 7105-01 Handleiding
Handleiding Lamp
Nieuwste handleidingen voor Lamp
Home Creation 1364-HO Handleiding Neewer SF55Q Handleiding Cateye Nano G II TL-LD831G Handleiding Brennenstuhl VL 500 Handleiding Brennenstuhl HL 900 A Handleiding Defender Slimline E206012 Handleiding Brennenstuhl HLA 1000 ACW Handleiding V-Tac VT-41028 Handleiding Brennenstuhl HL 1200 AS Handleiding V-Tac VT-10187 Handleiding