Forte Lighting 2664-04 Handleiding
Pagina's 1 Verlichting
Bekijk de handleiding van Forte Lighting 2664-04 gratis online of download de PDF. 11 mensen vonden deze handleiding nuttig. Vraag over dit model? Stel een vraag
2664-04
Secure glass shade (Q) onto the socket (P) by screwing socket
ring (R) tightly. Install light bulb (not included) in accordance
with the fixture’s specifications. Do not exceed the recommended
maximum wattage.
There are two 18 inch rods (K), two 12 inch rods (L), and
two 6 inch rods (M) included for each fixture. Determine
the correct number of rods needed for proper hanging height.
To lengthen the fixture, add additional rods. If additional
rods are needed, contact the place of purchase to order. To
shorten the fixture, trim the wires to the desired length,
leave at least 8 to 10 inch of wire in addition to the desired
length and slide any excess rods off the fixture’s wires to
discard. Keep in mind that you must use at least the provided
6 inch rods (M) to hang the fixture. Thread the wires through
the rods and pull the wires until taut before connecting the
rods together. Screw bottom rods (M) onto nipples (N) on the
fixture. Screw the nipples of the top rods into swivel posts (I)
of canopy (F). Pull the fixture wires through the top of the
canopy.
Carefully remove all contents from the carton. See the
important notes above. Shut off the power at the circuit
breaker and completely remove the old fixture from the
ceiling, including the old crossbar. Remove the crossbar
assembly from the bag. Crossbar (B) contains several
pairs of threaded holes. Find the pair of holes that matches
the spacing of the holes on the junction box and the fixture’s
canopy. Two mounting screws (A) should be attached to
crossbar (B). You may need to tighten nuts (C) to hold
these screws in place. Pull the house wires through the
center of crossbar (B). Place crossbar (B) over the junction
box so that mounting screws (A) are vertical and aligned
with the hole locations on the fixture’s canopy (F). Secure
crossbar (B) to the junction box by tightening the screws.
screw (E) on crossbar (B) and wrap the fixture’s ground
wire around the green ground screw (E). Use screwdriver
to secure ground screw (E) onto crossbar (B). Tuck all wires
neatly into the junction box.
Product specificaties
| Merk: | Forte Lighting |
| Categorie: | Verlichting |
| Model: | 2664-04 |
Heb je hulp nodig?
Als je hulp nodig hebt met Forte Lighting 2664-04 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Verlichting Forte Lighting
Forte Lighting 2404-04 Handleiding Forte Lighting 5745-04 Handleiding Forte Lighting 2763-01 Handleiding Forte Lighting 2179-01 Handleiding Forte Lighting 7116-01 Handleiding Forte Lighting 2760-03 Handleiding Forte Lighting 5748-02 Handleiding Forte Lighting 7117-02 Handleiding
Alle Forte Lighting Verlichting handleidingen
Populair in Verlichting
Forte Lighting 2679-01 Handleiding Forte Lighting 5743-04 Handleiding Forte Lighting 5535-01 Handleiding