Fender Hot Rod Deluxe IV Handleiding
Fender
Gitaarversterker
Hot Rod Deluxe IV
Lees hieronder de 📖 handleiding in het Nederlandse voor Fender Hot Rod Deluxe IV (24 pagina's) in de categorie Gitaarversterker. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/24
OWNER’S MANUAL
MANUAL DE INSTRUCCIONES
MODE D’EMPLOI
MANUALE UTENTE
BEDIENUNGSHANDBUCH
MANUAL DO PROPRIETÁRIO
オーナーズ・マニュアル
2
ENGLISH
Working guitarists everywhere prize Hot Rod amps for their great volume, reliability, responsiveness to eects pedals, and aord-
ability. The Hot Rod Deluxe IV is a scorching 40-watt 1x12” tube combo decked out with power and performance to spare, great
features and a classic look.
The Hot Rod DeVille is the standard for gigging guitarists worldwide and the ideal amp for crafting your own signature sound. The
Hot Rod DeVille IV combo delivers the goods and then some, with 60 watts of tube power driving a scorching pair of 12” speak-
ers, hot-rodded performance to spare, great features and a classic look.
Features include:
• Modied preamp circuitry for increased note denition in the overdrive channels
• Spring Reverb smoothness mod
• Celestion® 12” A-TYPE speakers
• Steel-reinforced strap handle
• Ivory pointer knobs
• Improved control panel texture and graphics
• Lightly aged silver grille cloth
• Pine cabinet for weight reduction
• Cover and two-button footswitch
MOR E
DR IVE
NO R MAL
BRIGHT
21
ON
OFF
ON
STANDBY
CHANNE L
SELECT
PRESENCEREVERBMASTERMIDDLEBASSTREBLEDRIVEVOLUME
INPUTS
POWER
AMP IN
PREAMP
OUT
FOOT
SWITCH
1
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
12 1
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
12
CONTROL PANEL
A. INPUT 1: Normal sensitivity input ideal for use with most
guitars. Either input jack can be used with any type of
guitar depending on the tonal character you prefer.
Experiment and use the input that sounds best to you.
B. INPUT 2: Lower sensitivity input (-dB) provides cleaner
response with high-output and pre-amplified guitars.
You
can use input 1 and Input 2 simultaneously with two
guitars or a guitar and a microphone, for example. Input
sensitivities become equal when used simultaneously.
C. NORMAL/BRIGHT: Press in to boost high-frequency
tones of NORMAL channel.
D. VOLUME: Adjusts volume of NORMAL channel.
E. MORE DRIVE: Press in to boost gain and distortion of
the DRIVE channel.
F. DRIVE: Increase DRIVE setting to produce more
distortion and sustain. Use lower DRIVE settings to
produce cleaner sounds.
G. CHANNEL INDICATOR: NORMAL
channel (off),
DRIVE
channel (yellow), MORE
DRIVE
channel (red).
H. TREBLE: Adjusts high-frequency tone.
I. BASS: Adjusts low-frequency tone.
J. MIDDLE: Adjusts mid-frequency tone.
K. CHANNEL SELECT: NORMAL channel (out), DRIVE
channel (in).
L. MASTER: Use to adjust loudness of the DRIVE and MORE
DRIVE channels in conjunction with DRIVE (F).
M. REVERB: Adjusts level of the reverb effect.
N. PRESENCE: Adjusts tone at a point in the signal path
after the preamp circuitry to provide unique ultra high-
frequency tone shaping.
O. PREAMP OUT/POWER AMP IN: Multi-functional
input/output jacks that can be used in a variety of
configurations:
Effects Loop: Connect PREAMP OUT to the input of your
effects device and connect effects output to the POWER
AMP IN jack.
Multiple Hot Rod Amps: Connect PREAMP OUT on
primary unit to POWER AMP IN on auxiliary unit. The
primary unit is used to control all auxiliary units, except
HOT ROD DEVILLE™ IV and HOT ROD DELUXE™ IV
3
ENGLISH
CHASSIS REAR VIEW
for REVERB and PRESENCE, which remain active on each
auxiliary unit.
Recording/Sound Reinforcement: Connect PREAMP
OUT to input jack of sound equipment.
Use instrument (shielded) cables with TS (tip-sleeve)
plugs for connections. Both PREAMP OUT and POWER
AMP IN jacks are located before Reverb and Presence in
signal path.
P. FOOTSWITCH: Connect included footswitch here to
enable remote selection of NORMAL/DRIVE/MORE DRIVE
channels. CHANNEL SELECT (K) button on control panel
is disabled when footswitch is connected. Speaker cable
(unshielded) is superior to instrument cable (shielded)
for connecting footswitch.
Q. POWER INDICATOR: Illuminates when unit is on.
Unscrew red jewel to access bulb (type T) for
replacement.
R. STANDBY: Use STANDBY instead of switching power off
during short breaks to avoid having to wait for tubes
to warm up when you want to start playing again.
Also, keep amplifier on STANDBY for first seconds
when you first switch power on to give tubes a gentle
warm up cycle. will extend lifespan of Using STANDBY
amplifier’s tubes by reducing shock of heat-up / cool-
down cycle on tube filaments.
S. POWER: Turns amplifier on and off.
T. POWER CORD: Connect to a grounded outlet in
accordance with the voltage and frequency ratings
specified on the rear panel of your amplifier.
U. FUSE: The fuse protects the unit from electrical faults.
Replace fuses only with the type and rating specified on
the fuse holder. If the unit repeatedly blows fuses, have the
unit tested at an authorized Fender Service Center.
V. MAIN SPEAKER JACK: One of the following speaker
configurations (internal or external) must always be
connected when the unit is ON to prevent damage to the
amplifier:
Deluxe IV DeVille IV
* Insert an open plug (without speakers connected) into Main
Speaker jack (V) for configuration three.
W. EXTERNAL SPEAKER JACK: This jack is wired in parallel with
the main speaker jack and must only be used with a speaker
load or an open plug connected to the main speaker jack, as
shown above in the MAIN SPEAKER JACK diagram.
X. TUBES: Your new Fender amplifier comes equipped
with the highest quality tubes available, sourced from
various manufacturers worldwide. Because of occasional
irregularities in supply, the specific tube type used in each
amplifier is subject to change without notice.
When replacing output tubes, please note the specific tube
markings on the original tubes factory supplied with your
amplifier. For example, L output tube types used by Fender
include, but are not limited to: LGC; LWXT; LC; LGE;
etc. The installation of a different type may require significant
adjustment by a qualified technician to avoid reduction in
performance and tube life.
Additionally, Fender tests and sorts many of our output
tubes based on their measured performance. The sorted
tubes are marked with a label on the base with coarse
ratings of blue, white and red plus fine ratings of -.
If your amp came supplied with, for example, a pair of
matched GT-L-GE power tubes ranked at white-, then
any pair of GT-L-GE power tubes marked with a course
rating of white will be a good replacement. If the tube
replacements are marked as white-, they will be a perfect
direct replacement.
If you have questions or concerns, contact your Fender
dealer or authorized service center.
Y. PREAMP TUBE STABILIZER: A vibration-absorbing
stabilizer is installed around the preamp tubes to minimize
the tube microphonics that normally develop over
time. The stabilizer can be used with all preamp tubes
compatible with your Hot Rod amplifier.
1.
2.
3.*
1.
2.
3.*
2
Product specificaties
| Merk: | Fender |
| Categorie: | Gitaarversterker |
| Model: | Hot Rod Deluxe IV |
Heb je hulp nodig?
Als je hulp nodig hebt met Fender Hot Rod Deluxe IV stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Gitaarversterker Fender
9 Juli 2023
8 Juli 2023
7 Juli 2023
7 Juli 2023
7 Juli 2023
6 Juli 2023
6 Juli 2023
4 Juli 2023
4 Juli 2023
Handleiding Gitaarversterker
- Gitaarversterker Yamaha
- Gitaarversterker Ampeg
- Gitaarversterker Behringer
- Gitaarversterker Boss
- Gitaarversterker Hartke
- Gitaarversterker Line 6
- Gitaarversterker Marshall
- Gitaarversterker Peavey
- Gitaarversterker Orange
- Gitaarversterker Vox
- Gitaarversterker Harley Benton
- Gitaarversterker ART
- Gitaarversterker Valeton
- Gitaarversterker TC Electronic
- Gitaarversterker Blackstar
- Gitaarversterker Electro Harmonix
- Gitaarversterker Markbass
- Gitaarversterker Hughes & Kettner
- Gitaarversterker Laney
- Gitaarversterker Ashdown Engineering
- Gitaarversterker Bugera
- Gitaarversterker Palmer
- Gitaarversterker Empress Effects
- Gitaarversterker Dimavery
- Gitaarversterker Fishman
- Gitaarversterker AER
- Gitaarversterker EBS
- Gitaarversterker Rivera
- Gitaarversterker Suhr
- Gitaarversterker Two Notes
- Gitaarversterker GR Bass
- Gitaarversterker Voodoo Lab
- Gitaarversterker AMT
- Gitaarversterker DACS Audio
- Gitaarversterker DV Mark
- Gitaarversterker Budda
Nieuwste handleidingen voor Gitaarversterker
10 April 2024
8 April 2024
8 April 2024
8 April 2024
8 April 2024
27 Maart 2024
13 Maart 2024
13 Maart 2024
12 Maart 2024
12 Maart 2024