Extech DO603 Handleiding

Bekijk gratis de handleiding van Extech DO603 (1 pagina’s), behorend tot de categorie Meetapparatuur. Deze gids werd als nuttig beoordeeld door 14 mensen en kreeg gemiddeld 4.6 sterren uit 4 reviews. Heb je een vraag over Extech DO603 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

DO603 D.O. Membrane Kit

Installation Instructions

1.Turn meter power “off.”

2.Remove old cap from electrode by turning counter clockwise. Discard old cap.

3.Rinse electrode thoroughly with deionized water and dry.

4.botFill new cap with electrolyte to above tom of threads.

5.Tap gently to dislodge any air bubbles.

6.Immerse end of electrode into cap and gently swirl to dislodge any air bubbles.

7.Slowly screw cap onto electrode in a vertical orientation, allowing excess electrolyte to overflow.

8.CAUTION: If electrolyte does not overflow, it means an insufficient amount of electrolyte was added. Remove cap and add more to ensure

proper operation.

9.Clean excess electrolyte from exterior of probe.

10.Invert electrode and check for air bubbles. Repeat process if air is present inside probe.

11.Turn meter “on”, and allow probe to polarize for at least 10 minutes before use.

Electrode Storage Instructions

Store in cap, with sponge moistened in Deionized water.

For furUser Manual. ther instructions, see the meter’s

This probe is compatible with:

DO600 ExStik

®

DO Meter

Contact Customer Support

Customer Support Telephone List: https://support.flir.com/contact

Calibration, Repair, and Returns: repair@extech.com

Technical Support: https://support.flir.com

Copyright © 2021 Teledyne FLIR LLC

All rights reserved including the right of reproduction in whole or in part in any form

www.extech.com

Product specificaties