Electro Harmonix Spectral Decomposer Handleiding

Bekijk gratis de handleiding van Electro Harmonix Spectral Decomposer (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.0 sterren uit 4 reviews. Heb je een vraag over Electro Harmonix Spectral Decomposer of wil je andere gebruikers van dit product iets vragen? Stel een vraag

ATOMIC

CLUSTER

User Manual

Spectral Decomposer

Tap Tempo

The footswitch can be used to set the refresh

speed. Press and release the footswitch at least

twice, in time with your music, to set the tempo.

The LED blinks at the tempo to confirm the

speed is set by tap-tempo. To turn off

tap-tempo, simply turn the SPEED knob to

reset the refresh speed.

You can completely disable tap-tempo by

following these steps:

1. Power down the Atomic Cluster.

2. Press and hold the footswitch while

reapplying power.

3. Continue to hold the footswitch for about

two seconds, the LED will slowly blink

through all three colors twice.

4. Release the footswitch and tap-tempo is

now disabled.

5. Repeat this process to re-enable tap-tempo.

Tap-tempo on/off is recalled through power

cycles so you can set it and forget it.

Dynamics Control

By default, the different oscillations have

different volumes, based on the input signal.

You can also flatten the dynamics to force all

oscillations to have the same volume for a

more synthetic effect. To switch between these

two modes, hold the MODE button for about

a second. The LED will flash through three

colors, either slowly or rapidly. The slower blink

cycle indicates you are in flat-dynamics mode,

while the rapid blink cycle indicates you are in

normal, full-dynamics mode. The state of this

mode is recalled through a power cycle.

NOTE: upon entering flat-dynamics mode the

volume of the effect signal may change depending

on the input level of your signal and the number of

ATOMS used.

Questions about this product?

Email: [email protected]

ATOMIC

CLUSTER

User Manual

Spectral Decomposer

Tap Tempo

The footswitch can be used to set the refresh

speed. Press and release the footswitch at least

twice, in time with your music, to set the tempo.

The LED blinks at the tempo to confirm the

speed is set by tap-tempo. To turn off

tap-tempo, simply turn the SPEED knob to

reset the refresh speed.

You can completely disable tap-tempo by

following these steps:

1. Power down the Atomic Cluster.

2. Press and hold the footswitch while

reapplying power.

3. Continue to hold the footswitch for about

two seconds, the LED will slowly blink

through all three colors twice.

4. Release the footswitch and tap-tempo is

now disabled.

5. Repeat this process to re-enable tap-tempo.

Tap-tempo on/off is recalled through power

cycles so you can set it and forget it.

Dynamics Control

By default, the different oscillations have

different volumes, based on the input signal.

You can also flatten the dynamics to force all

oscillations to have the same volume for a

more synthetic effect. To switch between these

two modes, hold the MODE button for about

a second. The LED will flash through three

colors, either slowly or rapidly. The slower blink

cycle indicates you are in flat-dynamics mode,

while the rapid blink cycle indicates you are in

normal, full-dynamics mode. The state of this

mode is recalled through a power cycle.

NOTE: upon entering flat-dynamics mode the

volume of the effect signal may change depending

on the input level of your signal and the number of

ATOMS used.

Questions about this product?

Email: [email protected]

Product specificaties