Electro Harmonix Micro Metal Muff Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Electro Harmonix Micro Metal Muff (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 143 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
MICRO METAL MUFF
- DESCRIPTION -
Congratulations on your purchase of the MICRO METAL MUFF! Electro-
Harmonix gave you an instant classic in the Metal Muff with Top Boost. The
MICRO METAL MUFF offers the same heavy metal sound in a smaller, easier
to use package.
- CONTROLS -
VOLUME CONTROL – sets the output level.
TONE CONTROL – provides up to 15dB of cut and boost in the middle
frequency range.
DISTORTION CONTROL – adjusts the amount of input gain.
TOP BOOST TOGGLE SWITCH – provides two settings for an extra ‘bite’
by boosting a narrow band of high frequencies. In the down position a low
amount of Top Boost is engaged. In the up position a high amount of Top
Boost is engaged. In the middle position no Top Boost is engaged.
FOOTSWITCH – Selects whether the MICRO METAL MUFF is engaged or in
buffered bypassed. The corresponding LED will be lit when the pedal is
engaged, and dark when bypassed.
INPUT Jack – This ¼” jack is the audio input to the MICRO METAL MUFF.
OUTPUT Jack – ICRO METAL This ¼” jack is the audio output from the M
MUFF. When the MICRO METAL MUFF is in Bypass mode, the OUTPUT jack
is connected to the INPUT jack through a buffer.
- OPERATION AND WARNINGS -
Power, from the internal 9-volt battery or external battery eliminator, is
activated by plugging into the input. The input cable should be removed
when the unit is not in use to avoid running down the battery. The input
impedance presented at the Input Jack is 1Mohm. The output impedance at
the Output Jack is 600 ohms.
The barrel connector on the front of the MICRO METAL MUFF is for a 9-volt
battery eliminator capable of delivering 100 mA of current. The inner ring of
the 9-volt battery eliminator must be negative, the outer ring positive. The
unit’s battery may be left in or taken out when the eliminator is in use.
To achieve its biting distortion, the MICRO METAL MUFF has very high
maximum gain. This requires that both the pickups and cables be well
shielded and properly grounded to avoid excessive hum when high sustain
control settings are used.
To change the 9-volt battery, you must remove the 4 screws on the bottom
of the MICRO METAL MUFF. Once the screws are removed, you can take off
the bottom plate and change the battery. Please do not touch the circuit
board while the bottom plate is off or you may damage a component.
The optional 9V power supply from Electro-Harmonix is US96DC-200BI
(same as used by Boss ™ & Ibanez™) 9.6 volts/DC 200ma. The barrel
connector on the front of the MICRO METAL MUFF is for the 9-volt battery
eliminator capable of delivering 100 mA of current. The inner ring of the 9-
volt battery eliminator must be negative, the outer ring positive. The unit’s
battery may be left in or taken out when the eliminator is in use.
- WARRANTY INFORMATION -
Please register online at http://www.ehx.com/product-registration or
complete and return the enclosed warranty card within 10 days of purchase.
Electro-Harmonix will repair or replace, at its discretion, a product that fails
to operate due to defects in materials or workmanship for a period of one
year from date of purchase. This applies only to original purchasers who
have bought their product from an authorized Electro-Harmonix retailer.
Repaired or replaced units will then be warranted for the unexpired portion
of the original warranty term.
If you should need to return your unit for service within the warranty period,
please contact the appropriate office listed below. Customers outside the
regions listed below, please contact EHX Customer Service for information on
warranty repairs at info@ehx.com or +1-718-937-8300. USA and Canadian
customers: please obtain a (RA#) from Return Authorization Number
EHX Customer Service before returning your product. Include with your
returned unit: a written description of the problem as well as your name,
address, telephone number, e-mail address, and RA#; and a copy of your
receipt clearly showing the purchase date.
United States & Canada
EHX CUSTOMER SERVICE
ELECTRO-HARMONIX
c/o NEW SENSOR CORP.
47-50 33RD STREET
LONG ISLAND CITY, NY 11101
Tel: 718-937-8300
Email: info@ehx.com
Europe
JOHN WILLIAMS
ELECTRO-HARMONIX UK
13 CWMDONKIN TERRACE
SWANSEA SA2 0RQ
UNITED KINGDOM
Tel: +44 179 247 3258
Email: electroharmonixuk@virginmedia.com
This warranty gives a purchaser specific legal rights. A purchaser may have
even greater rights depending upon the laws of the jurisdiction within which
the product was purchased.
To hear demos on all EHX pedals visit us on the web at www.ehx.com
Email us at info@ehx.com


Product specificaties

Merk: Electro Harmonix
Categorie: Niet gecategoriseerd
Model: Micro Metal Muff

Heb je hulp nodig?

Als je hulp nodig hebt met Electro Harmonix Micro Metal Muff stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Electro Harmonix

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd