Dymo LabelWriter SE300 Handleiding

Dymo Labelprinter LabelWriter SE300

Lees hieronder de 📖 handleiding in het Nederlandse voor Dymo LabelWriter SE300 (132 pagina's) in de categorie Labelprinter. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/132
LabelWriter SE300
User Manual
Dymo-CoStar Corp.
599 W. Putnam Ave.
Greenwich, CT 06830-6092
ii
Declaration of Conformity
Manufacturer
Name: Dymo-CoStar Corporation
599 West Putnam Avenue
Greenwich, CT 06830
Phone: 203-661-9700
Fax: 203-661-1540
Equipment Information
Description: Direct Thermal Printer
Model: SE300
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC (Federal Communications Committee)
rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try correcting the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Use shielded cables to connect this device to computers.
• Consult the dealer or an experienced radio/TV technician for help.
You may find helpful the following booklet, prepared by the FCC: Interference
Handbook. This booklet is available from the U.S. Government Printing Office,
Superintendent of Documents, Washington, DC 20402-9325.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
CE Certification
This device has been tested and complies with the requirements of:
The EMC Directive
EN55022: Radiated and Conducted Emissions B
EN50082-1: Generic Immunity ESD, RF, and Transient Susceptibility
and
Low Voltage Directive
Product Safety EN60950


Product specificaties

Merk: Dymo
Categorie: Labelprinter
Model: LabelWriter SE300

Heb je hulp nodig?

Als je hulp nodig hebt met Dymo LabelWriter SE300 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Labelprinter Dymo

Handleiding Labelprinter

Nieuwste handleidingen voor Labelprinter