CyberData Systems 011523 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor CyberData Systems 011523 (2 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Quick Reference 931750A © 2020, CyberData Corporation, ALL RIGHTS RESERVED.
Parts
FIts 24-inches x 24-inches and 24-inches x 48-inches ceiling tile
(1) Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker Assembly
Dimensions
23.8 [605]
23.8 [605]
Dimensions are in Inches [Millimeter]
3.6 [92]
Approximately
Contacting CyberData
Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: (831) 373-2601 ext. 136
RMA Email: RMA@CyberData.net
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA

Phone: 831-373-2601
Fax: 831-373-4193
http://www.cyberdata.net/
The IP Endpoint Company
Installation Quick Reference
Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker

011523
© 2020, CyberData Corporation, ALL RIGHTS RESERVED. 931750A Quick Reference
Installation Procedure
To install the Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker, complete the following steps while referencing the
figure below:
1. Remove the Ceiling Tile (the figure below shows a 2 x 2 Grid) from the Ceiling Grid. Cut the 2 x 4 Ceiling Tile in
Half if using a 2 x 4 Grid.
2. Place the Cross T* in the Middle for Support (Only on a 2 x 4 Grid).
3. Use a Flat Blade Screwdriver to Pry the Seismic Tether Bracket(s) on the 2 x 2 Auxiliary Ceiling Tile Speaker
Assembly.
4. Install Eyebolt(s) or Nail(s) to the Joist.
5. Connect the Speaker Wire(s) to the Blinding Posts on the 2 x 2 Auxiliary Ceiling Tile Speaker Assembly.
6. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s). Place the 2 x 2 Auxiliary
Ceiling Tile Speaker Assembly on to the Ceiling Grid and the Cross T* (see Step 2).
Installing the Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
*
*
*
*
Speaker Assembly
2 x 2 Auxiliary Ceiling Tile
Steel Wire
*
Remove
Ceiling Tile
1
Drop-in the 2 x 2 Ceiling Tile Speaker Assembly
6
3
4
5
Cross T
Install Cross T (Not Included)
Only on a 2 x 4 Grid
2


Product specificaties

Merk: CyberData Systems
Categorie: Speaker
Model: 011523

Heb je hulp nodig?

Als je hulp nodig hebt met CyberData Systems 011523 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker CyberData Systems

Handleiding Speaker

Nieuwste handleidingen voor Speaker