Coleman Pegasus Handleiding

Coleman Tent Pegasus

Lees hieronder de đź“– handleiding in het Nederlandse voor Coleman Pegasus (2 pagina's) in de categorie Tent. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Pegasus™17’x10’
1Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with front
door facing desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners only, using
the stake loops. Keep the floor taut.
(illus. 2)(Intermediate loops will be
staked later.)
– Assemble main tent poles by
interlocking shock-corded poles.
(two poles)
– Insert the main poles into pole
sleeves.The poles should cross
forming an ”X” in the middle of tent.
(illus. 1)
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard
or sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions,
position the end of tent into the wind.
Assembled Main poles
inserted through
pole sleeves
Instructions apply to Part Number 9161-171C
illus. 1
illus. 2
Tent stake
through stake loop
illus. 4
Tent center
frame set-up
Side Pole
Main pole
Side pole
sleeve
Main pole
Part No. 9161-1051
Part No. 9161-1061
illus. 3
Insert pin into pole end
Rainfly
Part No.
9161-1091
(2) Main Tent Poles
(Black)
(2) Side Poles
(Gray)
(1) Rainfly Main Pole
Part No. 9161-1071
(2) Rainfly Side Poles
Part No. 9161-1081
POLE ASSEMBLY PARTS
Connect Frame to Tent
– Insert pin near tent corner into the end of
main tent pole. (illus. 3, illus. 4)
– Go to opposite end of pole and gradually
apply pressure to the pole forming an arch
until you are able to insert the pin into the
pole end. Repeat for second main pole.
(illus. 3, illus. 4)
– Assemble gray side shock-corded poles and
insert through side pole sleeves. (illus. 4)
– Insert one pin into the end of side tent pole
at tent center. (illus. 3, illus. 4)
– At the opposite pole end gradually apply
pressure to the pole forming an arch until
you are able to insert the pin into the pole
end. Repeat for second side pole.(illus. 4)
3
4illus. 5 Assembled tent without rainfly.
Note the frame clips located on edge of tent.
illus. 6
Frame clips
illus. 7
Underside of
Rainfly
Grommets for
side rainfly poles
Front of Rainfly
Rainfly Main Pole
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
PRINTED IN CHINA Rev. 11/06
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage material
and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the
flammability requirements of CPAI-84. The fabric may burn
if left in continuous contact with any flame source. The
application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
illus. 9 Completed tent with rainfly.
Guyline
Attach Rainfly
– Assemble rainfly pole by
interlocking shock-corded pole.
– Insert main rainfly pole into reinforced
pockets located at the center edges of the
underside of rainfly. (illus. 7), (illus. 8)
– Attach rainfly pole to the underside of
rainfly with the pole ties. (illus. 8)
– Insert the two rainfly side poles through
the pole sleeves at the sides of the
rainfly. (illus. 7)
– Drape rainfly over tent frame, pole side
down. Main rainfly pole should point out
over door and rear window.
– Connect the four elastic loops
with “S” hooks, (found at the
rainfly corners) to rings at end of poles
(illus. 9)
– Secure rainfly with attachments
located on underside of fly. (illus. 8)
– Insert the tips of the side rainfly poles
into the grommets on either side of the
side windows.(illus. 9)
Attach Frame Clips
– Attach frame clips to frame poles. (illus. 5, 6)
– Stake out all additional loops.
Insert Side Rainfly
pole through pole
sleeve on underside
of rainfly.
illus. 8
Attach rainfly to
tent with velcro
attachments


Product specificaties

Merk: Coleman
Categorie: Tent
Model: Pegasus

Heb je hulp nodig?

Als je hulp nodig hebt met Coleman Pegasus stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Tent Coleman

Handleiding Tent

Nieuwste handleidingen voor Tent