Chief SSM146 Handleiding
Chief
Projector accessoire
SSM146
Bekijk gratis de handleiding van Chief SSM146 (1 pagina’s), behorend tot de categorie Projector accessoire. Deze gids werd als nuttig beoordeeld door 23 mensen en kreeg gemiddeld 3.6 sterren uit 12 reviews. Heb je een vraag over Chief SSM146 of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-000135 RevB
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-146, SSM-146, SLB-146 and SLM-146 Interface Brackets
SSB-146, SSM-146, SLB-146 and SLM-146 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place interface bracket onto bottom of projector and align the mounting holes in bracket with the threaded inserts in projector.
4. Install the M4 x 10mm Philips pan head screws and flat washers through lower slotted mounting holes in interface bracket and into
mounting holes in projector.
5. Install the .5" spacer between bracket and projector and align spacer with mounting hole in projector and interface bracket.
6. Install the M4 x 20mm Philips pan head screw with flat washer through interface bracket, and the .5" spacer into projector mounting hole.
Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (4) Washer, Flat, M4
(4) 10-24 Thumb Nuts ** (3) Screw, Phillips Pan Head, Machine, M4 x 10mm
(1) All-Points Security Kit (1) Screw, Philips Pan Head, Machine, M4 x 20mm
(1) .5" x .194" x .5" Round Spacer
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-146 SLM-146
(
N
o
t
e
:
S
S
M
-
s
t
y
l
e
i
n
t
e
r
f
a
c
e
b
r
a
c
k
e
t
c
o
n
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(Note: SSB-style interface bracket con
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
Towards front of
projector
Towards front of
projector
Product specificaties
| Merk: | Chief |
| Categorie: | Projector accessoire |
| Model: | SSM146 |
Heb je hulp nodig?
Als je hulp nodig hebt met Chief SSM146 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Projector accessoire Chief
18 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
14 November 2024
Handleiding Projector accessoire
- Panasonic
- Optoma
- Kanto
- Lindy
- Projecta
- Peerless
- Nedis
- Vision
- Peerless-AV
- Tempest
- Elite Screens
- Manhattan
- SMK-Link
- AV:link
- Christie
Nieuwste handleidingen voor Projector accessoire
6 Juni 2025
6 Juni 2025
5 Juni 2025
4 Juni 2025
4 Juni 2025
3 Juni 2025
3 Juni 2025
3 Juni 2025
3 Juni 2025
3 Juni 2025