Chief SSM7720 Handleiding

Bekijk gratis de handleiding van Chief SSM7720 (2 pagina’s), behorend tot de categorie Projector accessoire. Deze gids werd als nuttig beoordeeld door 38 mensen en kreeg gemiddeld 4.0 sterren uit 5 reviews. Heb je een vraag over Chief SSM7720 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

INSTALLATION INSTRUCTIONS

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use

of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or

implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

8802-000092 Rev01

©2009 Milestone AV Technologies,

a Duchossois Group Company

05/09

SSB-7720, SSM-7720, SLB-7720 and SLM-7720 Interface Brackets

SSB-7720, SSM-7720, SLB-7720 and SLM-7720 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the

specific installation instructions provided with the mount for additional installation information.

Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT!DO NOT substitute hardware. Use only hardware supplied by manufacturer!

Installation Instructions

WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.

NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.

1.Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.

2.Turn projector upside down on a flat surface.

3.Remove the front adjustable foot on projector by lifting up the finger tab and sliding it in the direction of the finger tab (see Figure 1).

(1) Interface Bracket(2) Screw, Phillips Pan Head, M4 -20mm

(4) 10-24 Thumb Nuts **(1) Screw, Flat Head, M3x 16mm

(1) All-Points Security Kit(2) Washer, Flat, M4

(3) Spacer, Nylon, .500 x .194 x .500

**Only used when installing SLB/SSB interface brackets.

NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the

encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style

interface bracket installation.

SLB-7720 SLM-7720

Towards front of

projector

Towards front of

projector

(Note: SSB-style interface bracket connections

a

r

e

e

n

c

i

r

c

l

e

d

)

(Note: SSM-styleinterface bracket connection

s

are encircled)

Product specificaties