Chamberlain 041-0203-000 Handleiding

Bekijk gratis de handleiding van Chamberlain 041-0203-000 (4 pagina’s), behorend tot de categorie Verlichting. Deze gids werd als nuttig beoordeeld door 27 mensen en kreeg gemiddeld 4.7 sterren uit 8 reviews. Heb je een vraag over Chamberlain 041-0203-000 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Integrated LED Light Module

Replacement

Repair Parts 041-0200-000, 041-0201-000,

041-0202-000 and 041-0203-000

To prevent possible SERIOUSINJURY or DEATH: 

• Disconnect ALL electric and battery power BEFORE performing ANY

service or maintenance.

To prevent damage to the receiver logic board, DONOT touch printed  

circuit board of replacement receiver/logic board during installation.

ALWAYS wear protective gloves and eye protection when changing the

battery or working around the battery compartment.

WARNING: This product can expose you to chemicals including

lead, which are known to the State of California to cause cancer or

birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov.

Introduction

Use this instruction to replace the integrated LED light module. The images

throughout this manual are for reference only and your product may look

different.

You will need:

• 1/4" magnetic nut driver

•Long-nosed pliers

• 5/16" long-shafted magnetic nut driver and socket

•Flathead screwdriver

Instructions

1. Disconnect the electrical and battery power (if applicable) to the garage

door opener. Remove the battery and place in a safe location.

2. Remove the control door panel from both ends of

the opener. (A)

a. Separate the hinges in

opposite directions.

b. Remove the panels from

the hinge setting and

place in a safe location.

3. Disconnect the door control

wires from the RED and

WHITE terminals and the

safety reversal sensor wires

from the BLACK and WHITE

terminals. (B)

4. Remove the end panels from

both ends of the opener.

5. Remove the integrated LED

light module from the

opener. (C)

6. Disconnect the ORANGE and WHITE wire harness from plug to the

integrated LED light module and set aside cover / LED light module. (D)

7. Install the new integrated LED light module.

8. Connect the ORANGE and WHITE wire harness from the plug to the

Integrated LED Light Module. (D)

9. Align integrated LED light module to chassis screw holes.

10. Attach both end panels.

11. Reconnect the door control and safety reversal sensor wires. (B)

Door Control:

• WHITE wire into the WHITE terminal.

• WHITE/RED wire into the RED terminal.

Safety Reversal Sensors:

• WHITE wires into the WHITE terminal.

• WHITE/BLACK wires into the GRAY terminal.

12. Reattach the control door panels.

13. Reconnect power to the opener.

14. Test the Protector System.

RED

WHITE

WHITE

GREY

B

A

D

C

Integrated LED Light Module

Control Door Panel

End Panel

Product specificaties