BeamZ S1200 MKII 160.491 Handleiding

BeamZ Mes S1200 MKII 160.491

Lees hieronder de 📖 handleiding in het Nederlandse voor BeamZ S1200 MKII 160.491 (12 pagina's) in de categorie Mes. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12

Ref. Nr. 160.491

S MKII 1200

INSTRUCTION MANUAL

GEBRUIKSAANWIJZING

BEDIENUNGSANLEITUNG

V1.1

- 2 -

- 3 -

Warning

- The smokemachine must be placed at least 100 cm away from inﬂammable materials such as curtains,

books, etc. Make sure that the housing cannot be touched by accident.

- For indoor use only.

- During installation, nobody should stand beneath the mounting area.

- Prior to the ﬁrst use, have the unit checked by a qualiﬁed person.

- The unit contains voltage carrying parts. DO NOT open the smokemachine

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualiﬁed technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains

outlet. It needs to be repaired by a qualiﬁed technician.

- Only connect this unit to an earthed mains outlet of 230Vac/50Hz .

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside the housing.

Please let the unit reach room temperature prior to use.

- When you unplug the unit from the mains always pull the plug, never the lead.

- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid

chain, a steel cable, etc. which has to be fastened separately from the mounting bracket.

- The supplied bracket is the main ﬁxing and must be used to solidly mount the light effect.

- In order to avoid accidents in public premises, the local legal requirements and safety

regulations/warnings must be fulﬁlled.

- Keep out of the reach of children.

Safety

Plug the smoke machine only in an earthed mains outlet or extension cord! ATTENTION: the powercord can

only be replaced by an original replacement, supplied by Tronios. Be careful when ﬁlling the ﬂuid tank. First of

all, unplug the mains lead! Then unscrew the cap on the tank and ﬁll it by means of a funnel. Only use the

original Beamz smoke ﬂuid which is environmental friendly and, if used correctly, leaves no residues. Do not

obstruct the openings on top of the case to guarantee a good ventilation. The heating element of the smoke

machine generates heat which needs to be removed. Don’t put any objects on the smoke machine.

Installation and Use

Unpack the fog machine. Fill the ﬂuid tank by means of a funnel. Plug the unit into a mains outlet. Thus the

heating element is automatically switched on. Depending on the room temperature, it takes about 5 until the

working temperature is reached. Then the thermostat is clicking and the LED on the manual control lights up.

Push the switch once and the smoke machine will produce a nice thick fog. Once the smoke machine has

reached its working temperature (the LED is lit) the smoke machine can produce continuously fog during about

1 minute.

After this period of time, the fog generator is cooled so much down that the thermostat switches oﬀ. Wait a few

minutes until the working temperature is reached again. It is recommended to produce smoke with small pauses

in between so that the temperature is maintained and the thermostat doesn’t switch off.

Location

Select a location where it is easy to ﬁll the tank. It is also possible to hang the unit by means of the supplied

holder and ﬁxing screws.

Switching the unit oﬀ

Switch the unit oﬀ by unplugging it from the mains. Otherwise the 1200W heating element will draw

unnecessarily current.

Timer remote control

After some warm-up time, the device is ready for use, the LED will light up on the remote. During use, it may

happen that the machine stops, in this case the LED will go out, indicating that the machine is warming up.

Timer function:

Press the yellow button and set the interval, duration and volume controls to the desired level.

Interval: time between the smoke moments (10-200 seconds)

Volume: amount of smoke (0-100%)

Product specificaties

Merk:	BeamZ
Categorie:	Mes
Model:	S1200 MKII 160.491
Kleur van het product:	Grijs
Gewicht:	5000 g
Snoerlengte:	3 m
Vermogen:	1200 W
Afstandsbediening:	Bedraad
Op afstand bedienbaar:	Ja
Opwarmtijd:	5 min
Productafmetingen (B x H x D):	470 x 255 x 200 mm
AC-ingangsspanning:	220-240 V
AC-ingangsfrequentie:	50 Hz
Vloeistoftank capaciteit:	0.9 l
Hoeveelheid rook uitstoot:	215 m³/min
Bedrijfsvloeistof:	Water