Audio-Technica AT-HS6 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Audio-Technica AT-HS6 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Safety precautions
Keep the product out of the reach of small
children to avoid accidental ingestion of
screws, nuts and washers, or damage to
product.
Do not use the product for any purpose other
than to mount a phono cartridge.
Do not put the product in a location where it
is exposed to direct sunlight, near heating
devices, or in places with high temperatures,
high humidity, or high concentrations of dust.
Do not attempt to disassemble or modify the
product.
Do not subject the product to strong impact.
User Manual / Headshell
Thank you for purchasing this Audio-Technica
product. Before using the product, read through this
user manual to ensure that you will use the product
correctly. Please keep this manual for future
reference.
Name of each part
Specifications
Material : Aluminum
Weight
(excluding cartridge
installation screws)
: Approx. 9.3 g (0.33 oz) (including
lead wires)
Approx. 8.4 g (0.30 oz) (excluding
lead wires)
Dimensions
(excluding connector
and protrusions)
: 13.0 mm (0.51”) × 21.4 mm (0.84”)
× 48.9 mm (1.93”) (H × W ×D)
Accessories : Cartridge installation slotted screw
(M2.6) (10 mm × 2 and 8 mm × 2),
Nut x 2, Plastic washer x 2
Specifications are subject to change without notice due to
improvements.
How to install
1. Mount a cartridge onto the headshell using
the cartridge installation slotted screw and
plastic washer provided, and tighten lightly so
that cartridge position can be adjusted.
• When using a cartridge without threaded inserts,
use screws and nuts to install the cartridge.
• Take care that the screws are short enough so as
not to touch and damage the record.
• Read the user manual of the cartridge.
2. Slide the lead tips over the cartridge
connections.
• Do not apply heat.
• Use tweezers, small pliers, and non-magnetic
screwdriver(s) to mount the headshell/cartridge.
•If a lead tip is loose, flatten it out slightly to attach it.
Layout of headshell leads
3. Loosen screws with a non-magnetic
screwdriver and adjust for overhang. Tighten
the screws firmly when position is fixed.
Audio-Technica Corporation
2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan
www.audio-technica.com
©2019 Audio-Technica Corporation
Global Support Contact: www.at-globalsupport.com
ver.1 2018.08.01
162501280-01-02 ver.2 2019.08.01
AT-HS6
If you are unsure about the overhang
adjustment, align the stylus tip with the stylus
on the cartridge that originally came with the
turntable (see figure below).
4. Attach the headshell to the tonearm.
5. Refer to the turntable's user manual and
adjust the tonearm balance, tracking force
and anti-skate.
Other language versions of this manual are
available for download at
http://eu.audio-technica.com/
Top vie
Cross section of screw hole
Screw holes
Side view Rubber washer
Lead tip
Lead wire
Connector
Cartridge installation
slotted screw
Plastic washer
Front view
(left channe
n
t channel / –)
Overhang adjustment
Loosen screws
and adjust the
position
(Unit : mm)
21.419.6
10.5
1.5
2.5
48.9
13.0
Threaded insert
Cartridge that came
with turntable
Make this
distance as
exact as
possible.
Connected cartridge
AT-HS6
W
(left channe t channel / +)
安全上の注意
本製品は安全性に充分な配慮を設計していすが、
使いかを誤と事故が起があます
然に防ため記の内容を必守りださ
警告 の表示は「取り扱いをた場合使用者
が死また重傷を可能があす」
意味いま
注意 の表示は「取り扱いをた場合使用者
う、
可能性がます
幼児の手の届かなろに置かないでださい。
付けビス、ーなの誤飲事故の因に
ートり付け途以外には使しな
い。破損や事故の原因ます
直射日光の当る場所暖房器具の近高温多湿や
の多い場所に置ださい。故障や不具合の
原因に
分解や造はい。故障の原にな
強い衝撃を与故障の原因にな
AT-HS6
取扱説明書 /
い上げあ使の前にこの
扱説明書を必ずえ、使。•
読め場所に保管
各部の名称
ニカデー
材質 : ア
質量
(取付けス除: 約9.3g線含
約8.4gド線除
外形寸法コネター
部、起部除く
: 13.0×21.4×48.9mm(H×W×D
付属 : 取り付ビス(M2.6)(10mm×2、8mm
×2)×2、
×2
改良め予告な更すがあ
接続しかた
1. 本製(別売)属の取付け
使用して仮し、
ます
埋め込み式)の付いいカ
使用る場合使用
を取付け
り付ビスを上から通し固定場合は、コーに取
付けが当注意い。
ご使用扱説明書併せご確認
2. 線の先端にあプを
込み接続
絶対に熱なを加えい。
カーけに市販の
ルペや非磁性マバーを使用
付け
ードプが緩い場合は、少しつぶて接続ださい。
線の配列
3. 2カの取付けビスを非磁性マ
で緩オーバーング調整調整終
は取り付ビスを本締い。
株式会社オテクニ
〒194-8666 東京都町田市西成瀬2-46-1
www.audio-technica.co.jp
©2019 Audio-Technica Corporation
不明な場ンテ最初付い
カー置に合わせ
(下図
4. ターンテーに本製品を接
5. ターテーの取扱説明書参照平バ
ス、圧、ンチケーテグの調整を行
サースについ
本製品ご家庭用取扱説明や接続注意書沿った
使用おいて万が一、製造上の原因にる品質不良が発生した場
合は品と取り換えしまれ以外のはごださい。
お取り換の際は、お買い上げの確認のため領収書またはシー
が必要にので大切保管ださい。
い合わせ先(電話受付/ 平日900〜1730)
製品の仕様使いたや修理品の相談い上
当社窓サポお願
客様相談窓口(製品の仕様使いかた)
0120-773-417
(携帯電話PHSご利用は 03-6746-0211
FAX042-739-9120•
Esupport@audio-technica.co.jp
サービター(修理部品)
0120-887-416
(携帯電話PHSご利用は 03-6746-0212
FAX042-739-9120•
Eservicecenter@audio-technica.co.jp
ポー
www.audio-technica.co.jp/atj/support/
天面
ビス穴部面図
側面 ャー
ドチ
(単mm
サー
(埋め込み式)
前面
ネル チンネ+)
左チンネ チ−)
ーバーハグ調
2カり付
ビスを緩めて調
テ ル付
の距離を
け正確に合
接 ー
S6
21.419.6
10.5
1.5
2.5
48.9
13.0


Product specificaties

Merk: Audio-Technica
Categorie: Niet gecategoriseerd
Model: AT-HS6

Heb je hulp nodig?

Als je hulp nodig hebt met Audio-Technica AT-HS6 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Audio-Technica

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd