Apc Smart-UPS Ultra SRTL5KRMTF Handleiding

Apc UPS Smart-UPS Ultra SRTL5KRMTF

Lees hieronder de 📖 handleiding in het Nederlandse voor Apc Smart-UPS Ultra SRTL5KRMTF (12 pagina's) in de categorie UPS. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
Installation Guide APCâ„¢ Smart-UPSâ„¢ Ultra
Step-Down Transformer SRTL5KRMTF
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual contains important instructions that should be followed during
installation and maintenance of the Smart-UPS and batteries.
Read the instructions carefully to become familiar with the equipment before attempting to install, operate,
service or maintain the transformer.
The following special messages may appear throughout this manual or on the equipment to warn of potential hazards or
to call attention to information that clarifies or simplifies a procedure.
The addition of this symbol either to a "Danger" or "Warning" safety label indicates that an electrical
hazard exists which will result in personal injury if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury or death.
Product Handling Guidelines
In for matio n
DANGER
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate
injury.
NOTICE
NOTICE is used to address practices not related to physical injury.
<18 kg
<40 lb
18-32 kg
40-70 lb
32-55 kg
70-120 lb
>55 kg
>120 lb
Smart-UPS Ultra Step-down Transformer SRTL5KRMTF2
Safety Information
• Adhere to all national and local electrical codes.
• All wiring must be performed by a qualified electrician.
• Changes and modifications to this unit not expressly approved by Schneider Electric could void the
warranty.
• This transformer is intended for indoor use only.
• Do not operate this transformer in direct sunlight, in contact with fluids, or where there is excessive dust or
humidity.
• Be sure the air vents on the transformer are not blocked. Allow adequate space for proper ventilation.
• For a transformer with a factory installed power cord, connect the transformer power cable directly to an
output receptacle of the UPS. Do not use surge protectors or extension cords.
• The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.
• Always install the transformer directly above the UPS in the rack-mount configurations. The UPS must be
installed below the transformer.
• Always install peripheral equipment above the UPS in rack-mount configurations.
• Additional safety information can be found in the Safety Guide supplied with this unit.
Electrical safety
• The protective earth conductor for the transformer carries the leakage current from the load devices
(computer equipment). An insulated ground conductor is to be installed as part of the branch circuit that
supplies input power to the transformer. The conductor must have the same size and insulation material as
the grounded and ungrounded branch circuit supply conductors. The conductor will typically be green and
with or without a yellow stripe.
• The UPS input ground conductor must be properly bonded to protective earth at the service panel.
• If the UPS input power is supplied by a separately derived system, the ground conductor must be properly
bonded at the supply transformer or motor generator set.
• Be sure that all the covers and panels are installed before operating the transformer.
• Do not insert any metal object through the ventilation openings.
• Be sure to turn off the input to the transformer and check the voltage at the output terminals is zero before
attempting to service or maintain the transformer.
General information
• The model and serial numbers are located on a small, rear panel label. For some models, an additional label
is located on the chassis behind the front bezel.
• Recycle the package materials or save them for reuse.
FCC Class A radio frequency warning
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are intended to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Smart-UPS Ultra Step-down Transformer SRTL5KRMTF 3
Product Information
The APCâ„¢ Smart-UPSâ„¢ Ultra transformer is intended for use as an isolation transformer as well as a step down
transformer.
The transformer can be installed as a tower or in a standard 19-inch rack. For rack mount configuration use the
supplied rail kit.
Package Contents
Inspect the contents upon receipt. Notify the carrier and dealer if the unit is damaged.
Front bezel • Stabilizer foot 1 pair • Screw for securing transformer tie bracket
• Screw for securing on UPS mount of tie
bracket
• Stabilizer foot to the transformer - 4x • Tie bracket to secure the UPS to the
transformer
• 1 pair rack-mount brackets
• Flat head screws to secure rack-mount brackets - 6x
Rail kit
su04
34a


Product specificaties

Merk: Apc
Categorie: UPS
Model: Smart-UPS Ultra SRTL5KRMTF

Heb je hulp nodig?

Als je hulp nodig hebt met Apc Smart-UPS Ultra SRTL5KRMTF stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding UPS Apc

Handleiding UPS

Nieuwste handleidingen voor UPS