Apc Smart-UPS SMX120BP Handleiding

Apc UPS Smart-UPS SMX120BP

Lees hieronder de 📖 handleiding in het Nederlandse voor Apc Smart-UPS SMX120BP (10 pagina's) in de categorie UPS. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/10
Installation Guide Smart-UPSâ„¢ X
External Battery Pack SMX120BP
Inventory
Inspect the contents upon receipt. Notify the carrier and dealer if there is damage.
Safety and General Information
Read the safety information below before installing the external battery pack.
• This external battery pack (XLBP) is intended for indoor use only.
• Do not operate this XLBP in direct sunlight, in contact with fluids, or where there is excessive dust or
humidity.
• The battery typically lasts for three to ve years. Environmental factors impact battery life. Elevated
ambient temperatures, poor quality AC power, and frequent short duration discharges will shorten
battery life.
• Before installing or replacing the batteries, remove jewelry such as wrist watches and rings. High
short circuit current through conductive materials could cause severe burns.
• The batteries are heavy. Remove the batteries prior to installing the unit in a rack.
• Use caution when closing and securing the battery compartment doors. Do not allow the battery cables
to be pinched by the battery compartment doors.
• Always install the XLBPs at the bottom of the rack. The UPS must be installed above the XLBPs.
• The UPS display interface will recognize as many as 10 external battery packs connected to the UPS.
However there is no limit to the number of XLBPs that can be used with the UPS.
Two bezels Tie brackets used to secure
multiple tower units together
1 pair rail cleats
8 pan head screws
1 pair rack-mount brackets
Use 8 flat head screws to secure rack-mount
brackets to the UPS
Use 4 ornamental screws to secure rack-mount
brackets to the rails
Install a cage nut in the rack to secure the top hole
of each rack-mount bracket in a four-post rack
1 screw to secure the battery connector to the
external battery pack
Rack-mount support brackets and hardware
1 pair support
brackets
two-post racks
10 screws
four-post racks
6 screws
6 washers
Smart-UPS SMX120BP External Battery Pack2
Specifications
For additional specifications, refer to the APC web site at www.apc.com.
Environmental
Remove the Batteries
Caution: Each battery weighs 23 kg (51 lbs). Remove the batteries before installation to prevent
possible injury.
Use the battery handle to lift and slide each battery out of the XLBP.
Temperature
Operating 0° to 40° C (32° to 104° F)
Storage -15° to 45° C (5° to 113° F)
charge UPS battery every six months
Maximum
Elevation
Operating 3,000 m (10,000 ft)
Storage 15,000 m (50,000 ft)
Humidity 0% to 95% relative humidity, non-condensing
 

su0790c
su0791c
su0792c
Smart-UPS SMX120BP External Battery Pack 3
Tower configuration
Warning: Two tie brackets must be installed between each unit.
Warning: The units are heavy. Prior to installing the tie brackets select a location sturdy enough
for the combined weight of the units.
Do not move the units once the tie brackets are installed. Doing so can cause personal injury, or
damage to the units. Remove the tie brackets prior to moving the units.
 
 

su0789a
su079
3a
su079
4a
su078
4c
su079
5a


Product specificaties

Merk: Apc
Categorie: UPS
Model: Smart-UPS SMX120BP

Heb je hulp nodig?

Als je hulp nodig hebt met Apc Smart-UPS SMX120BP stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding UPS Apc

Handleiding UPS

Nieuwste handleidingen voor UPS