Akg PZM-11LLWR Handleiding

Akg Microfoon PZM-11LLWR

Lees hieronder de 📖 handleiding in het Nederlandse voor Akg PZM-11LLWR (2 pagina's) in de categorie Microfoon. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
T
PRESSURE
ZONE
MICROPHONE
ÂŽ
he MPZ 11 LL WR is a weather-
resistant Pressure Zone Microphone
ÂŽ
with balaa nced, ne-level t t. A li ou pu
plastic membrane i ide thns e
microphone protects the mic capsule
from water damage. The mi mounts in a c
standard electrical outlet box. Applications
i l e fast-f d restaurants tdoonc ud oo , ou r
intercoms, tol t , bl boo hs ridges, theme park
security, home aut aom tion, and so on.
The microphone can be pl ed dugg irectly into a
VCR ne input - no cosli tly mic pr mp iea s
needed. Out t (via rew terminals) can bpu sc e
balanced or unbalanced. Powering is by 12 24- V
ACor DC. The unit can be factory-set for an- ph
tom powering by special order.
In the PZM11 LL WR, frequencies below the voice
range are rolled o to reduce trac rumble. The
hi - egh fr quency response is ted to helboos p
articulation. Because of s tait ilored response and
PZM constr tiuc on, the PZM11 LL WR will pick up
conversations or other desired sounds with extra
clarity.
The unit is “weather resistant,” ich mwh eans:
• The microphone will work during and after
rainfall.
• The mi s frec’ quency response will change
temporarily i the mef mbrane gets wet, but will
return to normal en dry. wh
• I watef r freezes on the membrane, the mic’s
frequency response will change, t will bu
return to rmal en the ice meno wh lts and the
membrane dries.
• Hi -pregh ssure water sprays directly on the
membrane (thr h the l ered wal plateoug ouv l )
may damage the membrane.
• The microphone is t desi ed to be sub- no gn
merged.
Installation
1. Pl se refer to Fi re 3 and l ate all the paea gu oc rts
shown. The electrical et x and cables aroutl bo e
not inc udl ed.
2. Run a 2-conductor shielded cable to the
surface where you intend to i tall the micro- ns
phone. I tall a stans ndard electrical et outl box
there (2-i h mini m depth). nc mu
3. The PZM11 LL WR can be powered by 12 24- V
ACor DC.
From r power source, run a twisted pair you
power cable to the mic l aoc tion. Run the power
cable thr h the le in the electrical oug ho box.
Service the end of the power cable.
Specifications
Transducer type: Electret condenser.
Frequency response (typical): 80 Hz to 10, 0 Hz 00
(see Fig. 1).
Polar pattern: Hemispherical.
I edance: mp 75 ohms, balanced. Recommended
minimum load i edamp nce 1000 ohms.
Open-circuit se itivity, tns ypical: 1.4 V/ . Pa
Power sensitivity, typical: +8 dBm/ . Pa
Equivalent ise level (self- ise): no no 26 dB SPL t icayp l
(0 dB = .0002 dyne/cm
2), A-wei ted. gh
S/N Ratio: 68 dB at 94 dB SPL.
Maxi m mu SPL: 100 dB SPL produces 3% THD at
maximum gain.
Operating vol ge: ta 12 24- V ACor DC, Phantom
powering by special order.
Pol ity: ar Positive pressure on diaphragm produces
positive voltage on audio+ terminal with respect to
audio– terminal
Current drain: 4 milliamperes.
Operating temperature range: –10 to +60 deg. C, 14
to 140 deg. F. The mic still works at –40 deg. Cbut
its sensitiv y is reduced. When the mic is returneit d
to normal eraop ting temperature, its sensitiv y will it
be within +/–3 dB of rmal. no
Output connector: Screw terminals labeled AUDIO+,
AUDIO– and GROUND.
Cable: None supplied. Use 2-conductor ielded mish c
cable and twisted-pair power cable.
Materials: St l plate and hi -i act plasee gh mp tic capsule
holder. Plastic membrane, part no. 127255-1.
Fini : sh Silver. If u paint the mic, take care yo not to
paint i ide the louvered wall plate. ns
Net wei t: gh 2.5 oz. (71 g).
Dimensions: 4.530 x 2.780 x 1. 2 inches (L72 WD)
(see Fig. 2).
* 1 pascal = 10 dynes/cm2 = 10 micr aob rs = 94 dB SPL.
Fig. 1
Fig. 2
Freque y Responsenc
Frequency in Hz
PZM11 LL WR
4. Run the mic cable thr h the le in thoug ho e
electrical box. Service the end of the mic cable.
5. Connect the mic cable’s aud hoio t l d to thea e
terminal labeled AUDIO+. Connect the audio cold
l d to the terminal labeled AUDIOea –. Connect the
cable shield to the terminal labeled GROUND.
6. Attach the power l ds to the ea screw terminals
marked ~“ ”. You can e - V ACor DCus 12 24 .
Polarity does not matter in either case.
7. Using the two shorter screws pr ided, aov ttach
the mic to the electrical box. Then use the other
two screws to secure the l ered wall plate touv o
the micr e. Do t remove or damage thophon no e
plastic membrane.
8. If the mic cable is run in metal conduit, ground
l s can occur that can caoop use hum. If hum is
present after i tans llation, return the it t un o
A K G / C r o w n s service dept. for gr - t ’ound lif
modifica . tion
Architects’ and Engineers’ Specifications
The micr e ophon shall be the A K G / C r o w n model
PZM11 LL WR or equivalent. It all be a Pres- sh
sure Zone Microphone, mountable in a wall or
ceili , and desi ed t to l k ke a ng gn no oo li
micr e. It all have a ne-level t t ophon sh li ou pu
(1.4 V/ Paunloaded) and be powered by
12 24- V ACor DC, or antom er. The ph pow
frequency response all be om 80 Hz to sh fr
10,000 Hz with a l - eow fr quency rollo to reduce
rumble and hi - egh fr quency boost for arti lacu tion.
The audio connector and power connector all sh
be rew terminalssc . Out t all be balapu sh nced,
low i edamp nce. The electret condenser
transducer all have a hemi- sphesh rical lar po
pattern when the micr e i mounted in a ophon s
wall or ceiling. The A K G / C r o w n PZM11 LL WR
micr e is ophon specied.
Warranty
A K G / C r o w n professi al micr es are on ophon
guarant uncondeed itionally agai t mans lfunction
from any cause for a period of three years from
date of original purchase. Pl se refer to the ea
enc osl ed full warranty statement for more detail.
Service
If the unit fails to rk, rewo check all r connec- you
tions as described in the I tans llation Section.
Check the cables and gain resistor. Also eck ch
the er supply to verify that it is supplyipow ng
correct age. If you determine that the volt
microphone product is defective, return the
complete product in its original packaging to
one of the addresses below For further .
assistance or technical support call the
international helpdesk at
3200 888.
AKG ACOUSTICS GMBH
LAXENBURGERSTRASSE 254
1230 VIENNA
AUSTRIA
AKG ACOUSTICS, U.S. SERVICE
24950 GROVE VIEW ROAD
MORENO VALLEY, CA 92551
U.S.A
Š 2015 HARMAN International Industries,
Incorporated. All rights reserved. is a AKG
trademark of Acoustics GmbH, registered in AKG
the United States and/or other countries.
Features, specications and appearance are
subject to change without notice.
www.akg.com
PZM11 LL WR

Product specificaties

Merk: Akg
Categorie: Microfoon
Model: PZM-11LLWR

Heb je hulp nodig?

Als je hulp nodig hebt met Akg PZM-11LLWR stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Microfoon Akg

Akg

Akg CK 61-ULS Handleiding

20 Februari 2024
Akg

Akg EC 82 MD Handleiding

20 Februari 2024
Akg

Akg CK47 Handleiding

19 Juni 2023
Akg

Akg C 3000 B Handleiding

17 Juni 2023
Akg

Akg C417 Handleiding

10 Juni 2023
Akg

Akg C417 PP Handleiding

18 Mei 2023
Akg

Akg H600 Handleiding

15 Mei 2023
Akg

Akg PERCEPTION 220 Handleiding

10 Mei 2023
Akg

Akg Perception live Handleiding

10 Mei 2023
Akg

Akg C 480 B Handleiding

2 Mei 2023

Handleiding Microfoon

Nieuwste handleidingen voor Microfoon

Sony

Sony F-115B Handleiding

26 April 2024
Sony

Sony ECM-66BC Handleiding

26 April 2024
Sony

Sony ECM-GZ1UBMP Handleiding

26 April 2024
Sony

Sony ECM-77LM Handleiding

26 April 2024
Sony

Sony ECM-77BC Handleiding

26 April 2024
Shure

Shure AXT910 Handleiding

17 April 2024
Shure

Shure ADX3 Handleiding

17 April 2024
DAP Audio

DAP Audio CM-95 Handleiding

9 April 2024
DAP Audio

DAP Audio WPS Guitar Handleiding

9 April 2024
Audix

Audix M55D Handleiding

9 April 2024