Yakima DoubleDown Handleiding

Yakima Fietsendrager DoubleDown

Lees hieronder de 📖 handleiding in het Nederlandse voor Yakima DoubleDown (15 pagina's) in de categorie Fietsendrager. Deze handleiding was nuttig voor 49 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/15
DoubleDown
1033617E-1/15
For Your
Safety
Warranty
Registration
on-line
YAKIMA.com
TOOLS REQUIRED:
ADJUSTABLE WrEnchES
RUBBER STRAP (12X)
DOUBLEDOWN (1X)
HEX WRENCH (1X)
BASE (1X)
SAFETY CLIP (1X)
PIVOT BOLT (1X)
HITCH BOLT (1X)
PIVOT WASHER (2X)
PIVOT NUT (1X)
LOCK WASHER (1X)
WASHER(1X)
WRENCH (1X)
SAFETY STRAP (1X)
IMPORTANT WARNING
I t Is crItIcal that all yakIma racks and accessorIes be properly and securely attached to your vehIcle mproper attachment could result In . I
an automobIle accIdent, and could cause serIous bodIly Injury or death to you or to others . y ou are responsIble for securIng the racks and
accessorIes to your car, checkIng the attachments prIor to use, and perIodIcally InspectIng the products for adjustment, wear, and damage.
therefore, you must read and understand all of the InstructIons and cautIons supplIed wIth your yakIma product prIor to InstallatIon or use.
I
f
you
do not understand all of the InstructIons and cautIons, or If you have no mechanIcal experIence and are not thoroughly famIlIar wIth
the InstallatIon procedures, you should have the product Installed by a professIonal Installer such as a qualIfIed garage or auto body shop .
PURCHASE
SEPARATELY:
TubeTop
Required for bikes with step-
through/Ladies frames or
bikes with slanted top tubes.
Part #8002531
DeadLock
Locks bikes to carrier, and
carrier to vehicle.
Part #8002411
HitchSki
-for DoubleDown 4 & 5 ONLY-
Carries up to 6 pr. skis or 4
snow boards.
Part #8002418
To purchase any Yakima
accessory visit Yakima.com
or contact your local dealer.
DO NOT USE THIS PRODUCT
WITH HITCH EXTENDERS.
Use only yakima adapters with
this prodUct. do not Use any
other brand tongUe adapter.
1033617E-2/15
If your vehIcle's hItch Is 1 1/4":
remove the 2" hItch aDapter,
anD the plastIc sleeve.
Remove the bolt from
the adapter using
the hex wrench.
Remove the
adapter, and
sleeve from the
tongue.
for 2" hItches: proceeD
to next step.
Install tongue.
Push the tongue into the hitch
plate, aligning the holes.
• Install hex bolt and a at washer.
• Add a second washer, attach a nut.
Insert tongue Into
vehIcle's hItch.
IF SPARE TIRE CAUSES
INTERFERENCE, DO NOT
USE THIS PRODUCT!
Align the holes in the receiver
to the holes in the tongue.
Install large bolt, lock-washer, anD washer.
NOTE: Flat washer may
be discarded on some
1-1/4" receivers if there
are clearance issues
with receiver.
• TIGHTEN with adjustable wrench.
• Install safety pin.
• Install bolt, lock-washer, and washer
from right side of receiver.
Washer must be
used on 2" receivers!
1033617E-3/15
EXTEND ARMS. RAISE ARMS COMPLETELY.
Pull the lever to
release the arms
from locked-down
position.
Arms will lock
into position.
CAUTION
Keep ngers away from
ALL moving parts!
LOAD HEAVIEST BIKE FIRST.
• Always load rst bike with
chain away from vehicle.
• Expand the cradle against
the bike.
A Yakima
TubeTop (see
cover page) may
be required to
carry your bike
safely.
Failure to load
bikes properly can
result in property
damage, personal
injury, or death.
Bikes should be as level as possible to avoid ground
clearance issues and possible ejections
Unhook one end
of each rubber
strap as shown.
PREPARE STRAPS
FOR LOADINg.
CRADLE
POSITIONING
To slide cradles along the
carrier arms, close cradle
and stabilizer.
Close cradles while
loading bikes.
Always use the
cradles closest
to the vehicle.


Product specificaties

Merk: Yakima
Categorie: Fietsendrager
Model: DoubleDown

Heb je hulp nodig?

Als je hulp nodig hebt met Yakima DoubleDown stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fietsendrager Yakima

Handleiding Fietsendrager

Nieuwste handleidingen voor Fietsendrager