Xzent XT10RVC Handleiding

Bekijk gratis de handleiding van Xzent XT10RVC (2 pagina’s), behorend tot de categorie Központi fűtés kazán. Deze gids werd als nuttig beoordeeld door 7 mensen en kreeg gemiddeld 4.8 sterren uit 8 reviews. Heb je een vraag over Xzent XT10RVC of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Please read this documentation carefully before you attempt to install and use this rear view camera model. Note that the given info

applies only to this particular model – installation by professionals is always highly recommended.

Do not damage tubing or wiring when drilling holes. Arrange the wiring so it is not crimped or pinched by sharp metal edges.

1. Mounting

The XZENT XT10RVC rear view camera can be mounted on almost any type of vehicle. Depending on the dimensions and shape of the

target vehicle, the camera may be installed in different locations.

The XT10RVC camera can be mounted in two different ways:

· Using the chrome plated bracket with the mounting ears (a)

· Flush-mount in the back door or the rear bumper (b)

For SUV and light truck vehicles, the ideal mounting height of the XT10RVC is in,

or right below the rear bumper – while for limousine and coupé type vehicles, a

higher position, just above the license plate holder will give better results.

After installation, the camera picture may be adjusted by untightening the lens

holding ring counterclockwise. Now you can turn the camera around its line of

sight in order to finetune the position. Instant success is guaranteed, if somebody

else is simultaneously checking the image position on the monitor.

Important: Once you are satisfied with the adjustments fasten the lens holder hand-tight, in order to keep the camera waterproof.

2. Electrical Connection

Most Navi-/Moniceivers feature a separate input to sense the state of the the reverse gear light (not to mix up with the taillights!).

Modern vehicle specific units (like the ZENEC E>GO series) do not even need that input signal, cause their design allows them to extract

this information directly from the vehicles CAN - Bus.

Please consult the manual and/or wiring of your specific device about how it switches to an alternative video input.

Use the included connection cables exclusively. Altering or replacing them, will void your warranty.

*Yellow RCA:Video Out of reverse cam, goes to RVC Video-In of Navi-/Moniceiver

*Red wire:Power connect to +12V switched by ignition key

3. Technical Specifications

This product and the accompanying manual is subject to change without notice

Image device8.4 mm/0.33’’ CMOS Sensor

Sensor resolution510 x 492 pixels

TV-system NTSC

IP Protection RatingIP67

Resolution of video420 TV lines

Automatic Gain ControlYes

Autom. Backlight CompensationYes

Signal/Noise ratio≥48 dB

Minimum illumination1 Lux

Video output75 Ohms/1Vp-p

Power supply12 V

Current consumption70 mA

Operating temperature-20 ºC - 65 ºC

Viewing angle170º

XT10RVC Rear View Camera Instructions

a b

Environmental Reference

If at any time in the future you should need to dispose

this product please note that waste electrical products

should not be disposed with the household waste.

Please recycle where facilities exist. Check with your

local authorities or retailer for recycling advice (Waste

Electrical and Electronic Equipment Directive).

Black wire GND 0V

*Red wire +12V

*Yellow RCA

Manual:Layout 1 21.07.2010 11:01 Uhr Seite 1

Product specificaties