Wolf SRT486C Handleiding

Wolf Fornuis SRT486C

Lees hieronder de 📖 handleiding in het Nederlandse voor Wolf SRT486C (25 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/25
Sealed Burner Rangetop
Installation Guide
SPECIFI CATI ONS, IN STALLATIO N ,
AND MORE
2 | Wolf Customer Care 800.222.7820
Sealed Burner Rangetop
Contents
3 Specifications
6 Installation
7 Troubleshooting
Features and specifications are subject to change at any
time without notice. Visit wolfappliance.com/specs for the
most up-to-date information.
Important Note
To ensure this product is installed and operated as safely
and eciently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or prod-
uct damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
wolfappliance.com | 3
Rating plate location
RATING PLATE
Specifications
Planning Information
When installing against a combustible surface, a minimum
5" (127) riser is required for model SRT366, and a minimum
10" (254) riser is required for 36" and 48" sealed burner ran-
getops with a charbroiler or griddle. Follow all minimum
clearances to combustible surfaces shown in the illustra-
tion on page 5. Models SRT362W and SRT484W cannot be
installed against a combustible surface.
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply within the shaded area shown
in the illustration on page 5. A separate circuit servicing
only this appliance is required. A ground fault circuit inter-
rupter (GFCI) is not recommended and may cause inter-
ruption of operation.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 110/120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type
Power Cord 6' (1.8 m)
Product Information
Important product information, including the model and
serial number, are listed on the product rating plate. The
rating plate is located on the bottom of the control panel,
at the far right. Refer to the illustration below.
If service is necessary, contact Wolf Factory Certified
Service with the model and serial number. For the name of
the nearest Wolf Factory Certified Service or for questions
regarding the installation, visit the Product Support section
of our website, wolfappliance.com, or call Wolf Customer
Care at 800-222-7820.


Product specificaties

Merk: Wolf
Categorie: Fornuis
Model: SRT486C

Heb je hulp nodig?

Als je hulp nodig hebt met Wolf SRT486C stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fornuis Wolf

Wolf

Wolf WX60-10B Handleiding

6 Januari 2024
Wolf

Wolf WX24-4B Handleiding

5 Januari 2024
Wolf

Wolf WX36-6B Handleiding

5 Januari 2024
Wolf

Wolf DF3045S Handleiding

23 Augustus 2023
Wolf

Wolf DF3045P Handleiding

22 Augustus 2023
Wolf

Wolf C48S-4B24G Handleiding

18 Augustus 2023
Wolf

Wolf C72SC-6B36G Handleiding

17 Augustus 2023
Wolf

Wolf WICM36 Handleiding

17 Augustus 2023

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis