Whelen 01-0772131-00 Handleiding

Bekijk gratis de handleiding van Whelen 01-0772131-00 (4 pagina’s), behorend tot de categorie Verlichting. Deze gids werd als nuttig beoordeeld door 10 mensen en kreeg gemiddeld 4.1 sterren uit 6 reviews. Heb je een vraag over Whelen 01-0772131-00 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Page 1

Aviation

Installation Guide/ICA

Model P36DUO

P/N:01-0772131-00

LED Landing&Taxi Light Assembly

INSTALLATIONPROCEDURES:The following

information provides guidelines for theinstallationof the

WAT LED PAR Lights listed above. Please refer to the

OEM manual for your aircraft for specific removal and

installation instructions.

1.Choose the appropriate replacement light assembly.

Note:Itis not required to change allPAR lights or

Taxi lights to the new LED PAR lights.

2.Place the lighting switch in the OFF position.

3.Inspect the housing, attachment points and retainer

for any signs of abnormal wear or damage.

4.Loosen or remove the hardware holding the lamp in

place. Take steps to ensure the retainer doesn't fall

from the lamp

assembly before itisready tobe

removed.

5.Place retainer screws in a safe place.

6.Remove the lamp from the holder.

7.Note there are two wires connected to the (existing)

lamp.Using a multi-meter, identify the negative wire

by measuring continuity to ground. Place a piece of

black electricaltape aroundthe wireidentified as

ground. This is your negative lead.

8.Identify the positive wire as the remaining wire lead.

The LED light assembly is polarity sensitive,

howeveryou will notdamagetheunitby reversing

the polarity.

9.While holding the lamp, loosen the screws holding

the attached wires. Remove eac

h wire from the

lamp.

MODEL LIST

10.Secure the LED Light.

11.Attach wiring using diagram on page 3.

12.If required, install the rubber gasket included with

your new LED Light around the LED Light assembly.

A light application of a common hand soap on the

rubber may aid in its fit into the light housing.

13.Place the LED light into the housing ensuring the

key(of the assembly)matchesthe keyof the

housing. Proper orientation of the lamp is necessary

for beam orientation to be left and right of centerline

whilein operation. Fora Taxi light, the ‘lines’ of the

inner optic should

be orientated vertically to produce

a horizontal light beam.

14.Secure the retainer. Care should be taken to tighten

the screw only to the point the retainer does not turn

withhandpressure.Over-tightening may stressthe

polycarbonate lens of the LED Light.

15.Place the light switch in the ON position and verify

proper operation of the WAT LED lamp.

16.Determine that the Landing or Taxi light

characteristicshave notbeen substantiallyaffected,

per 14CFR 23.1383.

17.If required, update aircraft records utilizing FAA

Field Approval (Form 337) or equivalent.

*NOMINAL

Phone: (860) 526-9504

Fax: (860) 526-2009

Internet: www.flyWAT.com

Sales/Service e-mail: info@flyWAT.com

ModelPart #StyleApplicationWeight VDCInputCurrent

P36DUO01-0772131-00PAR36Landing&Taxi0.85lb11~32VDC

Landing: 3.50A @14V

Taxi : 4.15A @14V

1.55A @28V

1.80A @28V

Product specificaties