Vollrath 60038 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Vollrath 60038 (5 pagina's) in de categorie Overige keukenapparatuur. Deze handleiding was nuttig voor 9 personen en werd door 5 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/5
Operator's Manual
Part No. 354185-1 12/16/22
S V I C
Thank you for purchasing this Vollrath® product! Save this
manual for reference and the packaging in case shipping is
necessary.
SAFETY PRECAUTIONS
To help ensure safe use, please read and fully understand this
manual and all safety messages before operation!
WARNING
Warning indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Caution indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTICE: addresses practices not related to physical injury.
To reduce risk of injury or damage to the unit
• Use only grounded electrical outlets matching the nameplate-
rated voltage.
• Have equipment installed by qualified personnel in accordance
with local codes and ordinances.
• Use equipment in a flat, level position.
• The heating element is meant to be immersed in water and
is IPX7 rated, but the control head has no IP rating, is not
waterproof and must be installed such that the water level
cannot reach it.
• Do not use an extension cord with this equipment. Do not plug
this equipment into a power strip or multi-outlet power cord.
• The appliance is not intended to be operated by means of an
external timer or a separate remote-control system.
• If the supply cord is damaged, it must be replaced by the
manufacturer, service agent or similarly qualified persons in
order to avoid a hazard.
• Turn equipment o and unplug before cleaning, moving, or
removing from the water.
• After unplugging, the heating element and surrounding
components will remain hot and should not be touched or
placed on combustible surfaces.
• Do not spray controls or outside of equipment with liquids or
cleaning agents.
• Do not clean the equipment with steel wool.
• Keep equipment and power cord away from open flames,
electric burners, or excessive heat.
• Do not operate equipment in public areas and/or around
children. Equipment is not meant for use outside a commercial
kitchen environment.
Item Description
60038 Immersion Circulator (Head Only) 120V
60039 Immersion Circulator (Head, Bath, and Cover) 120V
60042 Immersion Circulator (Head Only) - Schuko plug 230V
• Children shall not play with the appliance or be allowed to clean
or maintain the appliance.
• This appliance shall not be used by children and persons with
reduced physical, sensory or mental capabilities or lack of
experience and knowledge.
• Do not operate if equipment has been damaged or is
malfunctioning in any way.
FUNCTION AND PURPOSE
This unit is intended to provide precise temperature control of
water for closed-loop circulation. This unit is intended for indoor
use at commercial food service establishments. It not intended
or designed to cook raw food, nor for household, industrial, or
laboratory use.
UNPACKING THE UNIT
1. Remove all packing material and tape, as well as any
protective plastic.
2. Clean any glue residue left over from the plastic or tape.
3. Place the unit in desired location..
60038
60042
60039
2
Sous Vide Immersion Circulators
FEATURES AND CONTROLS
time
temp
programs
settings
A
I
C
B
J
E
D
G
H
F
Figure 1. Front of Control Panel
A. Display — shows time and temperature during setup and
operation.
B. Temperature Indicator — illuminates when temperature is
displayed.
C. Time Indicator — illuminates when time is displayed.
D. Units Indicator — illuminates when temperature is displayed
as °C and does not when temperature is shown in °F.
E. Up Triangle — navigates programs and sets time and
temperature.
F. Down Triangle — navigates programs and sets time and
temperature.
G. Programs — selects and sets user programs.
H. Settings — cycles between time and temperature while
running or setting programs and switches temperature units.
I. Stop — cancels a current program or menu item.
J. Run — starts the selected program.
K. Power Switch — turns the unit on or o.
L. System Fuses — disconnects power during an abnormally
high current event.
M. Cover — closes the well.
N. Sous Vide Circulator — heats the well.
O. Drain Valve Lever — controls water flow from the drain valve.
P. Drain Valve — is where water empties from the well.
K
L
Figure 2. Back of Control Panel
N
M
P
O
Figure 3. Cover, Drain, and Drain Lever (Shown in the
"Open" position).
3
Sous Vide Immersion Circulators
OPERATION
WARNING
Burn Hazard.
Do not touch cookware, heating surface, food,
or liquid while heating.
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering
the unit. Liquid inside the unit could cause an
electrical shock.
NOTICE: Before operation, follow the CLEANING section
instructions to prepare the unit.
NOTICE: Monitor food temperature closely for food safety.
The United States Public Health Service recommends that hot
food be held at a minimum of 140 ºF (60 ºC) to help prevent
bacteria growth. Maintain correct water level and temperature
setting. Protect your hands, remove food containers, and
check water level about every two hours.
NOTICE: Heat water only. Other liquids may become unstable
and hazardous.
NOTICE: Vacuum-packed food creates a low oxygen
environment. With improper handling or preparation, bacteria
can grow. Following an HCAPP program and U.S. Food and
Drug Administration guidelines is recommended.
1. For units with baths, ensure the Drain Valve Lever (O) is
closed.
2. For clamp-on units, ensure that you are using a container
that is stable and not tall or narrow. The container should
have a minimum volume of 10qt (10L) and maximum volume
of 37qt (35L). Failure to use a large enough stable container
could result in the unit tipping over and causing damage to
the unit or an electrical hazard.
"Open"
"Closed"
O
O
P
P
Figure 4. Drain and Drain Lever Positions
3. Fill the bath or vessel with clean, fresh water so that it is
about 2" (50mm) from the top. Add one tablespoon of
vinegar per 10 qts (10L) of water to reduce calcification of the
heating element.
4. Add food to the water bath in a vacuum-sealed bag or
waterproof container. Adjust water as needed to prevent
overflow.
5. Plug electrical power cord into a grounded outlet matching
the nameplate-rated voltage.
6. Press the Power Switch (K) to turn the unit ON — See
Figure 2
Immersion Circulator Head Operation
• Running a simple temperature program:
This program has a set temperature and no time limit.
1. Turn the unit on and wait until STBY is displayed.
2. Press UP or DOWN triangles to set the temperature; this
number will be saved if the unit turns o.
3. Press RUN to start the program.
4. Press STOP to end the program.
• Running a saved user program:
The machine has 5 user-definable programs that are saved
in memory and have time and temperature components.
1. Turn the unit on and wait until STBY is displayed.
2. Press PROGRAM.
3. Press UP or DOWN triangles to select a program.
4. Press RUN to start the program.
5. Press STOP to end the program.
6. The program will end when time runs out.
• Changing a program:
NOTICE: User-defined programs can be saved and edited.
1. Turn the unit on and wait until STBY is displayed.
2. Press PROGRAM to select an option.
3. Select a program.
4. Press and hold PROGRAM for 3 seconds to edit.
5. Press SETTINGS to cycle between time and temperature.
6. Use UP and DOWN triangles to change values.
7. To finish changing the program, wait 5 seconds with no
actions, or press and hold PROGRAM for 3 seconds, or
press STOP.
• Changing temperature units:
1. Press and hold SETTINGS for 3 seconds to change units
to or from °F and °C.
• Changing the display:
1. Press SETTINGS while a simple temperature program
is running to show the set temperature. The display will
read, in succession:
– Temperature (solid on TEMP INDICATOR)
– Temperature edit (flashing TEMP INDICATOR)
2. Press SETTINGS while a user program is running to cycle
between time and temperature. The display will read, in
succession:
– Temperature (solid on TEMP INDICATOR)
– Time (solid on TIME INDICATOR)
– Temperature edit (flashing TEMP INDICATOR)
– Time edit (flashing TIME INDICATOR)
Product specificaties
| Merk: | Vollrath |
| Categorie: | Overige keukenapparatuur |
| Model: | 60038 |
Heb je hulp nodig?
Als je hulp nodig hebt met Vollrath 60038 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Overige keukenapparatuur Vollrath
10 Juni 2025
Handleiding Overige keukenapparatuur
- Overige keukenapparatuur Swan
- Overige keukenapparatuur Healthy Choice
- Overige keukenapparatuur Electrolux
- Overige keukenapparatuur Hamilton Beach
- Overige keukenapparatuur Sana
- Overige keukenapparatuur Princess
- Overige keukenapparatuur Riviera And Bar
- Overige keukenapparatuur Mercury
- Overige keukenapparatuur Excalibur
- Overige keukenapparatuur Imarflex
- Overige keukenapparatuur LG
- Overige keukenapparatuur Techno Line
- Overige keukenapparatuur Whirlpool
- Overige keukenapparatuur Privileg
- Overige keukenapparatuur V-Zug
Nieuwste handleidingen voor Overige keukenapparatuur
11 Juni 2025
10 Juni 2025
10 Juni 2025
10 Juni 2025
10 Juni 2025
10 Juni 2025
10 Juni 2025
9 Juni 2025
9 Juni 2025
9 Juni 2025