Vango Velocity 400 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Vango Velocity 400 (1 pagina's) in de categorie Tent. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/1
IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER or
AMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland. PA14 6TD.
UK Consumer Hotline: 0844 811 0535 E-Mail: info@vango.co.uk
Calls to our Customer Hotline cost 5p per minute. Calls from mobile phones, cable networks or public payphones will generally cost more.
INNER ATTACHMENT
• Open out inner tents inside ysheet and position
doorway to correspond with the living area.
• Starting from the rear corners of the tent, attach the
hooks on the inner groundsheet to
corresponding rings on the tent groundsheet.
• Suspend the inner by attaching toggles of inner tent
through rings on inside of ysheet. Do the rear rst
and work forward.
TENSION BAND SYSTEM
• When required, remove Tension Band System from
pockets and clip into the buckles in the ceiling of the
tent.
• Adjust the straps until they are taut but do not over-
tension.
TO DEFLATE THE AIRBEAM TENT
• Unscrew the valve fully from the beam, taking care as the
valve will be under pressure from the air inside the tube.
IN THE UNLIKELY EVENT OF A PUNCTURE
• Note: Most apparent punctures are a result of the valve
not being screwed in correctly. Please check valves
before changing AirBeam tube.
• eate the AirBeam. Unzip the internal ysheet sleeve D
which contains the aected beam.
• Remove the tube and its protective outer.
• The zips for the protective outer are cable tied together
to prevent accidental access. Cut the cable tie and open
the zip. DO NOT open these zips when tube is inated.
• Remove the clear rubberised tube from the protective
sleeve taking care when removing the valve from the
sleeve.
• Partially inate the tube and pass through a bucket or
basin of water, looking for air bubbles. This will indicate
location of puncture.
• Use the repair patch provided and cover hole, using
instructions on patch. Re-insert tube into protective
outer, closing zip from both ends, so that zip pullers are
in the centre of the sleeve, and then replace into the
ysheet sleeve. (This may be easier with the tube
partially inated)
FLYSHEET FIRST PITCHING/COMBINED PITCHING
• Unpack and position the tent in the required direction.
• Peg out the 4 corners using the pegs supplied.
• Locate inating points at the base of each beam.
• Access the beams through the zipped entry points and
through the side door.
• For the rst use of the tent, fully unscrew all valves from
the AirBeams and screw back in carefully - this ensures
that the valve is not cross-threaded.
• Remove smaller screw-cap on valve and insert largest
pump nozzle of the Vango AirBeamâ„¢ pump supplied.
• Inate all tubes to 7psi. The tubes MUST be guided into
an arch as they are inated.
• Final tube pressure MUST NOT exceed 8psi.
DO NOT OVER-INFLATE THE BEAMS
• Start with the centre tube and guide the beam into an
upright position while it is inating.
• Inate the other beams.
• Remove pump and tighten screw-cap. Ensure both parts
of valve are well tted so it is air tight but do not over
tighten.
• Ensure the tent is in a straight line. The groundsheet
should be at and wrinkle free.
• Secure the tent by pegging out the sides using all the
pegging points available.
• Peg out ALL the guy lines, ensuring that they are in line
with the beam or seam they are attached to.
• Re-position and adjust tensioning where necessary.
CORRECT PUMP SETUP
Pump Body -> Pressure Valve -> Pressure Gauge -> Hose
(Ensure Valve/Gauge/Hose are connected to Ination
port of pump)
CORRECT AIRBEAM VALVE SETUP
Ination Deation
Velocity
Product specificaties
| Merk: | Vango |
| Categorie: | Tent |
| Model: | Velocity 400 |
Heb je hulp nodig?
Als je hulp nodig hebt met Vango Velocity 400 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Tent Vango
26 Maart 2024
26 Maart 2024
26 Maart 2024
26 Maart 2024
26 Maart 2024
26 Maart 2024
26 Maart 2024
26 Maart 2024
26 Maart 2024
26 Januari 2024
Handleiding Tent
- Tent Philips
- Tent IKEA
- Tent Asaklitt
- Tent Babymoov
- Tent Bestway
- Tent Dometic
- Tent Dwt-Zelte
- Tent Eureka
- Tent Fiamma
- Tent Gerjak
- Tent Perel
- Tent Rocktrail
- Tent Rollei
- Tent Skandika
- Tent Thule
- Tent Trigano
- Tent Velleman
- Tent Ventura
- Tent Walker
- Tent Woods
- Tent Jamet
- Tent Obelink
- Tent Crivit
- Tent Edges
- Tent Kayoba
- Tent Hamron
- Tent Big Agnes
- Tent Black Diamond
- Tent Camp Master
- Tent Carl Denig
- Tent Chinook
- Tent Coleman
- Tent De Waard
- Tent Easy Camp
- Tent High Peak
- Tent Hilleberg
- Tent Jack Wolfskin
- Tent Kelty
- Tent Khyam
- Tent Mountain Hardwear
- Tent Nigor
- Tent Nomad
- Tent Outwell
- Tent OZtrail
- Tent Raclet
- Tent Robens
- Tent Sierra Designs
- Tent Trimm
- Tent Vaude
- Tent Vrijbuiter
- Tent Wechsel
- Tent Wilderness Equipment
- Tent Wynnster
- Tent Zempire
- Tent Aart Kok
- Tent Cabanon
- Tent Holtkamper
- Tent Goldcamp
- Tent Isabella
- Tent Kathmandu
- Tent Sorara
- Tent MSR
- Tent TOOLPORT
- Tent Helsport
- Tent Casaria
- Tent Black Wolf
- Tent Nordisk
- Tent Grand Canyon
- Tent San Hima
- Tent Gazebo Penguin
Nieuwste handleidingen voor Tent
30 April 2024
26 April 2024
26 April 2024
26 April 2024
20 April 2024
20 April 2024
20 April 2024
20 April 2024
20 April 2024
20 April 2024