Uline H-8771 Handleiding

Bekijk gratis de handleiding van Uline H-8771 (21 pagina’s), behorend tot de categorie Airco. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 4.6 sterren uit 6 reviews. Heb je een vraag over Uline H-8771 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

PAGE 1 OF 21 0122 IH-8771

H-8771, H-8772

INDUSTRIAL AIR

CONDITIONER

1-800-295-5510

uline.com

INSTALLATION

Before installing and using the industrial A/C system,

read these instructions carefully for proper usage and

all safeguards. Keep them for future reference.

AIR CHUTE

A/C systems come equipped with air chutes.

1. Remove air chutes from accessories box. Place

unfinished end of air chute onto collar. Clamp with

supplied clamp using a 5/16 nut driver or a flat

screwdriver. (See Figure 1)

CONDENSATE TANK

The system comes standard

with an internal 3.5-gallon

condensate tank. (See Figure 2)

The internal condensate tank

is equipped with a float switch

that shuts the unit down and

alerts operators with an alarm.

It displays CF (Condensate

Full) when the condensate

tank is full. This prevents

accidental water overflow on

floor. To continue operation, the collection bottle must

be removed, emptied and re-installed. Turning the A/C

unit off will stop the alarm.

1. Remove the float switch jack by pulling it straight

back. Remove the condensate bottle by pushing

the front of the bottle slightly downward and then

pull the bottle out.

2. Remove the cap threaded onto the bottle by turning

counterclockwise. Empty collected water and

return cap back onto bottle by turning clockwise.

Do not cross thread cap upon installation. Tighten

cap to the point where the angle connector on the

condensate bottle aligns with the nipple extending

out from the drain pan on the A/C unit. Insert bottle

by pushing down slightly to clear extended drain

pan nipple. Ensure drain pan nipple is inside of

angle connector and cap is snug and not cross-

threaded to avoid water leakage.

3. Install the float switch jack by pushing it straight in.

Alarm will sound if pin is not fully inserted. Continue

normal operation.

TOOLS NEEDED

Phillips ScrewdriverFlathead Screwdriver5/16" Wrench

Figure 1

Air Chute

Clamp

Figure 2

Switch Jack

Para Español, vea páginas 8-14.

Pour le français, consulter les pages 15-21.

Collar

Product specificaties