Tripp Lite PDUMV15-24 Handleiding

Tripp Lite Stekkerdoos PDUMV15-24

Lees hieronder de 📖 handleiding in het Nederlandse voor Tripp Lite PDUMV15-24 (16 pagina's) in de categorie Stekkerdoos. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16

Owner’s Manual

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

Metered Rack PDU

PDUMV15-24, PDUMV15-36

(Series Number: AG-00E1)

PDUMV20-24, PDUMV20-36, PDUMV20-72

(Series Number: AG-00DD)

Important Safety Instructions 2

Installation 3

Features 4

Warranty & Product Registration 5

Español 6

Français 11

PROTECT YOUR INVESTMENT!

and ultimate peace of mind.

You could also win an

ISOBAR6ULTRA surge protector—

a $50 value!

www.tripplite.com/warranty

14-08-092-933381.indb 1 8/21/2014 10:27:52 AM

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that should be followed

during the installation, operation and storage of this product. Failure to

heed these instructions and warnings may affect the product warranty.

Important Safety Instructions

• The PDU provides the convenience of multiple outlets, but DOES NOT provide surge or line

noise protection for connected equipment.

• The PDU is designed for indoor use only, in a controlled environment, away from excess

moisture, temperature extremes, conductive contaminants, dust or direct sunlight.

• Keep indoor ambient temperature between 32°F and 122°F (0°C and 50°C).

• The PDU must be installed by a qualified technician only.

• Do not attempt to mount the PDU to an insecure or unstable surface.

• Install in accordance with National Electrical Code standards. Be sure to use the proper

overcurrent protection for the installation, in accordance with the plug/equipment rating.

• Connect the PDU to an outlet that is in accordance with your local building codes and that is

adequately protected against excess currents, short circuits and earth faults.

• The electrical outlets supplying power to the equipment should be installed near the equipment

and easily accessible.

• Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that

eliminate the connection to ground.

• Be sure to provide a local disconnect device on any models that are permanently installed

without a plug that is easily accessible.

• Never attempt to install electrical equipment during a thunderstorm.

• Individual equipment connected to the PDU should not draw more current than the individual

PDU’s outlet’s rating.

• The total load connected to the PDU must not exceed the maximum load rating for the PDU.

• Do not attempt to modify the PDU, input plugs or power cables.

• Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable

parts inside.

• Do not attempt to use the PDU if any part of it becomes damaged.

• Use of this equipment in life support applications where failure of this equipment can

reasonably be expected to cause the failure of the life support equipment or to significantly

affect its safety or effectiveness is not recommended. Do not use this equipment in the

presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

14-08-092-933381.indb 2 8/21/2014 10:27:52 AM

PDUMV15-24

and PDUMV15-36

PDUMV20-24, PDUMV20-36

and PDUMV20-72

PDUMV20-24, PDUMV20-36

and PDUMV20-72

Installation

Zero U Rack Configuration. Attach the two mounting

clips supplied with the PDU to the rack enclosure using

the included hardware. The mounting clips should be

attached along a vertical plane at equidistant points which

roughly correspond to the center and ends of the PDU.

The exact mounting configuration may vary depending on

the rack and enclosure. If possible, use pre-existing

mounting points within the enclosure.

Wall or Under-Counter Configuration. Attach the two

mounting clips supplied with the PDU to a wall or similar

flat, secure surface using the included hardware. The

mounting clips should be attached along a vertical or

horizontal plane at equidistant points which roughly

correspond to the center and ends of the PDU. If

possible, use pre-existing mounting points. WARNING: Do

not attempt to mount the PDU with the outlets facing

downward; the mounting clips are not designed to

support the weight of the PDU in that manner.

Zero U Rack Configuration. For toolless mounting:

Position the PDU as desired in the rack enclosure, align

the buttons with the rack mounting slots and slide the

PDU into position.

Note: Mounting buttons come preinstalled with select

models.

Note: Regardless of configuration, the user must

determine the fitness of hardware and procedures before

mounting. The PDU and included hardware are designed

for common rack and rack enclosure types and may not

be appropriate for all applications.

Attach the PDU to the mounting clips. Using an

assistant, place a rear corner of the PDU on the inside

edge of the mounting clips, pivot the PDU toward the

alternate inside edge and snap into place.

Attach the input plug of the PDU to a grounded

outlet. Insert the plug directly into a grounded outlet that

does not share a circuit with a heavy electrical load (such

as an air conditioner or refrigerator).

Attach equipment to the PDU. Do not exceed the load

rating of the PDU. The total electrical current used by the

PDU will be displayed on the digital meter in amperes.

Optional Installation (Models PDUMV20-24,

PDUMV20-36 and PDUMV20-72). The PDU includes an

adapter that converts the L5-20P input plug to a 5-20P

input plug. The adapter is optional; the PDU will work

properly without connecting the adapter.

14-08-092-933381.indb 3 8/21/2014 10:27:54 AM

Product specificaties

Merk:	Tripp Lite
Categorie:	Stekkerdoos
Model:	PDUMV15-24
Kleur van het product:	Zwart
Gewicht:	1240 g
Breedte:	38.1 mm
Diepte:	41.7 mm
Hoogte:	621.5 mm
Snoerlengte:	4.6 m
Gewicht verpakking:	1460 g
Breedte verpakking:	136.9 mm
Diepte verpakking:	61 mm
Hoogte verpakking:	674.9 mm
Materiaal behuizing:	Metaal
LED-indicatoren:	Ja
Beeldscherm:	LED
Land van herkomst:	China
Afmetingen verpakking (BxDxH):	683 x 141 x 56 mm
Certificering:	UL60950-1, CSA60950-1, NOM
Duurzaamheidscertificaten:	RoHS
Hoogte, in bedrijf:	0 - 3000 m
Afmetingen (B x D x H):	44.5 x 32 x 610 mm
Montage:	Verticaal
Stekker:	NEMA 5–15P
(Buitenste) hoofdverpakking hoogte:	694.9 mm
(Buitenste) hoofdverpakking breedte:	430 mm
(Buitenste) hoofdverpakking brutogewicht:	18520 g
(Buitenste) hoofdverpakking lengte:	275.1 mm
Hoeveelheid per (buitenste) hoofdverpakking:	12 stuk(s)
Rackcapaciteit:	0U
Relatieve vochtigheid in bedrijf (V-V):	5 - 95 procent
GTIN (EAN/UPC)-nummer (buitenste) hoofdverpakking:	10037332182859
Aantal AC uitgangen:	8 AC-uitgang(en)
Nominale input voltage:	100-127 V
Stopcontacttypes:	NEMA 5–15R
Stroom (max.):	15 A
PDU types:	Gemeten
Netspanning, in bedrijf:	100-127 V