Taylor 3875 Handleiding

Taylor Keukenweegschalen 3875

Lees hieronder de đź“– handleiding in het Nederlandse voor Taylor 3875 (9 pagina's) in de categorie Keukenweegschalen. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
Model 3875
Digital Pocket Scale
Instruction Manual
Thank you for purchasing a Taylor digital pocket scale. Your Taylor® scale is an example of ®
superior design and craftsmanship. Please read this instruction manual carefully before use.
Keep these instructions handy for future reference.
Battery Information
This scale operates on 1 3 volt CR2032 lithium battery (installed). There is a strip under the –
lithium battery cover to prevent battery drain in shipping. Please remove the strip before
continuing with these instructions. Also, some models have a static cling label on the lens to
prevent scratching. Please remove before use.
Replace the battery when the Low Battery warning “Lo” appears on the display, or the readings
grow dim or irregular. To replace the battery:
1. Use one 3 volt CR2032 lithium battery.
2. Remove screw (or screws) from the battery compartment cover on the bottom of the scale
and remove the cover.
3. Remove the old battery from the compartment.
4. Place the new battery with the “+” sign up into the battery compartment.
5. Replace the battery compartment cover and screw(s).
NOTE: Please recycle or dispose of batteries per local regulations.
WARNING: Batteries may pose a choking hazard. As with all small items, do not let children
handle batteries. If swallowed, seek medical attention immediately.
PRECAUTION: Do not dispose of batteries in fire. Batteries may explode or leak. Remove the
battery if the scale will not be used for a long period of time.
General Weighing Operation
1. Place the scale on a hard, level surface.
2. Gently push the LCD readout into the scale and release. The LCD readout will pop out of the
scale for viewing. NOTE: Pop out the LCD before placing items on the scale.
3. Press the “ ” button to turn the scal/TARE e on. The display will - then show “ 1:8888” and
zero when it is ready for use. If the display does not show zero, press the “ ”/TARE button to
reset (tare) the scale to zero.
4. Your scale weighs in pounds/ounces (lb oz) grams (g). or Press the “UNIT” button to change
the units of measurement.
5. Place the item to be weighed on the center of the platform. The weight will display. As you
add weight, the weight displayed increases.
6. The scale will turn off automatically after approximately 1 minute of non-use or if there is no
change in weight after approximately 3 minutes. Press and hold the “ ” button to turn the /TARE
scale off manually.
7. Gently push the LCD readout back into the scale for storage.
Push front of LCD to view or hide screen
Tare Operation
You may wish to weigh ingredients in a bowl or other container (not included). In this case, you
will need to tare, or offset, the weight of the bowl so that only the weight of the ingredients is
displayed.
1. Choose a container that will safely balance on the platform without tipping or falling. Do not
use a heavy container, as this might reduce the maximum capacity of the scale.
2. While the scale is off, place the empty container on the scale platform. Turn the scale on. The
display will turn on and then show zero. The weight of the container has been zeroed out.
3. Add the ingredient to be weighed. The weight of the ingredient alone will display.
4. The weight of additional ingredients may be tared out as well. For example, if you wish to
weigh 1 oz apple and 1 oz banana, place the apple on the scale/in the bowl. Once the correct
amount of apple is weighed, press “ ” until the display is reset to zero. Add the /TARE 1 oz of
banana. Both items have been accurately weighed in the same bowl.
5. When weights have been tared out, the display will show a negative number when the items
are removed from the scale. To reset the scale back to zero for a new measurement, press
“ ” until the display resets to zero./TARE
Precautions
1. Clean exposed parts with a soft, slightly damp cloth. To remove stains, use a mild soap.
Never use detergents, excess water, treated cloths, harsh cleaning agents, or sprays. Avoid
contact with acids, such as citrus juices. DO NOT immerse the electronic scale in water or wash
in a dishwasher.
2. Do not tamper with the scale’s internal components. Doing so will invalidate the warranty on
this unit and may cause damage. The scale contains no user-serviceable parts.
3. Although your scale is designed to be maintenance-free, it contains sensitive electronic parts.
Avoid rough treatment. Treat it with care to ensure the best performance.
4. This scale is intended for home/consumer use only. It is not intended for commercial or
medical use.
5. This scale is designed to read weights up to 6 lb 9 oz x 0.01 oz / 3000 g 0.5 g. To prevent x
damage, do not place more than 6 lb 9 oz / 3 g on it. 000
6. Do not store scale where you store cleaning chemicals. The vapors from some household
products may affect the electronic components of your scale. Do not store scale on its side.
7. This scale is an extremely sensitive weighing device. In order to prevent run down of the
battery, do not store anything on the scale.
8. Do not dispose of batteries in fire. Batteries may explode or leak. Remove the battery if the
scale will not be used for a long period of time.
9. Unstable Warning: Should “ ” appear on the display, this indicates theUNSt scale is unstable.
Place the scale on a hard, level surface during use.
10. Overload Warning: Should “ ” appear on the display during a weighing,O-Ld this indicates
that the maximum weighing capacity of the scale has been exceeded. Remove the weight
immediately; otherwise, permanent damage could occur.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
One (1) Y
One (1) Y
One (1) Y
One (1) YOne (1) Year Limited
ear Limited
ear Limited
ear Limited ear Limited Warranty
Warranty
Warranty
WarrantyWarranty
Taylor® warrants this product to be free from defects in material or workmanship (excluding
batteries) for (1) year for the original purchaser from date of retail purchase. It does not one
cover damages or wear resulting from accident, misuse, abuse, commercial use, or
unauthorized adjustment and/or repair. If service is required, do not return to retailer. Should
this product require service (or replacement at our option), please pack the item carefully and
return it prepaid, along with store receipt showing the date of purchase and a note explaining
reason for return to:
Taylor Precision Products, Inc.
2220 Entrada Del Sol, Suite A
Las Cruces, New Mexico 88001 USA
www.taylorusa.com
There are no expressed warranties except as listed above. This warranty gives you specific
legal rights, and you may have other rights which vary from state to state. For additional product
information, or warranty information outside the USA, please contact us through
www.taylorusa.com.
©2013 Taylor Precision Products, Inc. and its affiliated companies, all rights reserved. Taylor®
and Leading the Way in Accuracy® are registered trademarks of Taylor Precision Products, Inc.
and its affiliated companies. All rights reserved.
Made to our exact specifications in China.
Not legal for trade.
CP3875 11 .13

Product specificaties

Merk: Taylor
Categorie: Keukenweegschalen
Model: 3875

Heb je hulp nodig?

Als je hulp nodig hebt met Taylor 3875 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Keukenweegschalen Taylor

Taylor

Taylor 3804-44 Handleiding

3 Oktober 2022
Taylor

Taylor 3890 Handleiding

3 Oktober 2022
Taylor

Taylor 3710-21 Handleiding

3 Oktober 2022
Taylor

Taylor 3875 Handleiding

3 Oktober 2022

Handleiding Keukenweegschalen

Nieuwste handleidingen voor Keukenweegschalen

Scarlett

Scarlett SC-1215 Handleiding

3 Oktober 2022
Zelmer

Zelmer 34Z052 Handleiding

3 Oktober 2022
Vox

Vox KW0201 Handleiding

3 Oktober 2022
Inventum

Inventum WS200B Handleiding

3 Oktober 2022
Beurer

Beurer KS 61 Handleiding

3 Oktober 2022
Sinbo

Sinbo SKS 4520 Handleiding

3 Oktober 2022
AcuRite

AcuRite 00932 Handleiding

3 Oktober 2022
Medisana

Medisana KS 220 Handleiding

3 Oktober 2022
Zelmer

Zelmer KS1500 Handleiding

3 Oktober 2022
Soehnle

Soehnle 65432 8 Prima Handleiding

3 Oktober 2022