StarTech.com ET90110SM30 Handleiding

Bekijk gratis de handleiding van StarTech.com ET90110SM30 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 4 mensen en kreeg gemiddeld 4.9 sterren uit 7 reviews. Heb je een vraag over StarTech.com ET90110SM30 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Introduction

Thank you for purchasing a StarTech.com Single-Mode Media

Converter.This product offers a cost-effective method of bridging

two Ethernet networks using single-mode fiber optic cable, at dis-

tances up to 30km (~19 miles).

Features

•Simple installation and use

•Supports full or half-duplex operating modes

•Supports loop-back testing

Before You Begin

System Requirements

•Fiber Cable

•10Base-T;Cat 3, 4 or 5 or 100Base-Tx, Cat 5 or 6 cable

•Power source

Contents (per unit)

•Media Converter (1)

•12V DC Power Adapter (1)

•Instruction manual (1)

Basic Setup

1. Connect the fiber interface cable to the Unit. Using UTPcable,

connect the ethernet connection to the RJ45 jack.

2. Set the switch (full/half) according to the specifications of Duplex

your equipment.

Media Converter Connections

The following example illustrates the connection scheme when

connecting from a 10Base-T/100Base-TX port of one hub to a

100Base-FX port of another hub, through the fiber converter:

The following example illustrates the connection scheme when con-

necting from a 10Base-T/100Base-TX port of one hub to a 10Base-

T/100BASE-TX Network Interface Card (NIC) in a computer through

the fiber converter:

Front Panel DIP Switch Settings

1.Full/ Half:

The Fiber and UTP Duplex will be configured in Full-duplex or Half-

duplex.*This switch includes an “Auto Reset”function so the

power-reset is not necessary when any modification is made

here.

2.NORM / LBT - Loop-back test :

(NORM = Not Active, LBTON = Active) If the local sidePlease note:

loop-back test is active, then LEDs (except PWR) will all blink

rapidly and refresh to display the remote side status.

10/100 Single Mode Media Converter (SC – 30km)

ET90110SM30

LEDFunctionStateStatus

PWRPower Indicator

On

Off

Blinking

Converter has power

Converter has no power

LB testing & Get CPEstatus function enabled

Fiber

Full

Mode display

On

Off

Fiber side Full Duplex mode

Half-duplex mode

LinkFiber link

On

Off

Blinking

The fiber link is ok

No link, or the link is faulty

Receiving data on the fiber

100Link Speed

On

Off

100Mbps Link Speed

10Mbps Link Speed

FullMode display

On

Off

Ethernet side Full Duplex mode

Half Duplex mode

LAN

Link

Ethernet Link

On

Off

Blinking

The UTPlink is ok

No link, or the link is faulty

Receiving data on Ethernet

LEDIndicators

The following diagram and chart outline the meaning of each LED

located on the media converter(s):

Fiber Connection

Fiber Cable

100BASE-TX

UTPConnection

RJ-45 to HUB

connection

Fiber Transceiver

connection

Fiber Cable

100BASE-TX

UTPConnection

FULL

LBTON

HALF

Fiber Full

PWR

100

Full

Link

LAN Link

Cont’d on reverse

NORM

Product specificaties