Spectron SP 112 Handleiding

Bekijk gratis de handleiding van Spectron SP 112 (2 pagina’s), behorend tot de categorie Autoradio. Deze gids werd als nuttig beoordeeld door 37 mensen en kreeg gemiddeld 4.2 sterren uit 7 reviews. Heb je een vraag over Spectron SP 112 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

SPECTRON BANDPASS SUBWOOFER

Congratulations on your purchase of this SPECTRON bandpass

subwoofer system.

Read and follow the operating and adjustment instructions for

this trunk box subwoofer model given below carefully, to

obtain best possible sound quality and performance from this

product.

KEY FEATURES

ILOADED WITH SPECTRON SP-S10/12 WOOFER

ILARGE CROSS SECTION SLOT PORT FOR HIGH SPL

ICHROMED WOOFER GRILLE WITH BICOLOR

LED ILLUMINATON

IMDF CABINET WITH INTERNAL BRACING

ISPACE SAVING SLOPED REAR WALL DESIGN

ICURVED ACRYLIC WINDOW FOR LOW FLEX

ISPRING-LOADED TERMINAL

For safety and legal reasons, it might be prohibited using the box illumination while operating a car. Restrictions may apply

in certain countries. For making sure to follow all national traffic and vehicle regulations and not to distract drivers attention,

we recommend connecting the box illumination to the interior light of the trunk.

TECHNICAL SPECIFICATIONS

Model: SP-110BP SP112BP

Enclosure type: 10” Bandpass Subwoofer12” Bandpass Subwoofer

Frequency response: 30 Hz – 120 Hz25 Hz – 120 Hz

Nominal impedance: 4 ohms4 ohms

Sensitivity 1W/1m: 90 dB92 dB

Maximum power handling: 400 W500 W

Dimensions WxHxD: 425 x 310 x 225/390 mm485 x 375 x 235/435 mm

PLACEMENT OF BOX

This SPECTRON bandpass model is designed and engineered to be placed in the trunk of the car, to achieve full bass

perfomance and low end extension.

POWER CONNECTION FOR LED ILLUMINATION

Connect the 3.5mm plug with the extension wire to the receptor inside the terminal. Connect the loose ends to an appropriate

switched 12V source like the trunk box illumination, if you intend to use the illumination feature of this product.

AUDIO CONNECTION AND SETTINGS

Before any adjustments are attempted, “treble“, “bass“ and “loudness“ controls of the head-unit must be set to their neutral/zero

position. Your bandpass subwoofer needs a low-pass filtered signal with at least 12dB/oct. slopes for best results.

§Activate the lowpass function of the amp channel(s) driving your bass box.

§Set the lowpass crossover frequency of the channel(s) driving the sub to approx. 80 Hz

§Connect the speaker wire of your sub amp to the speaker terminal on the backside of the sub.

§Increase the input gain of the subwoofer channel, until bass output is loud enough.

„In-phase“ connection of your subwoofer is critical – if your sub plays out of phase, the output at the crossover frequency region

will be depressed due to cancellation effects.

Thus one connection polarity of your sub will give you a „fatter“ and more dynamic bass reproduction in the 80Hz range.

That’s the one to go for.

manual SP-110BP_112BP:manual spectron 012W + WX 28.02.2008 15:06 Uhr Seite 1

Product specificaties