Smeg PD64ES Handleiding

Smeg Fornuis PD64ES

Lees hieronder de 📖 handleiding in het Nederlandse voor Smeg PD64ES (14 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/14

Contents

THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES WHOSE IDENTIFICATION SYMBOLS

APPEAR ON THE COVER OF THIS MANUAL.

THIS BUILT-IN HOB IS CLASS 3.

qualified technicia

Further information about the products can be found at www.smeg.com

Instructions for safe and proper use

1. Instructions for safe and proper use

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS

ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING

HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING

THE COOKING HOB. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE

CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE.

THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT

REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING

FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED

IMPROPER.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE THE VARIOUS WASTE

MATERIALS AND TAKE THEM TO THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE.

IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE

METHODS REQUIRED BY SAFETY RULES.

THE PLUG TO BE CONNECTED TO THE POWER CABLE AND THE SOCKET MUST BE THE SAME

TYPE AND MUST CONFORM TO CURRENT REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN BUILT IN.

NEVER UNPLUG BY PULLING ON THE CABLE.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE COOKING

HOB, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT FUNCTION,

DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE “ZERO” (OFF) POSITION WHEN YOU

FINISH USING THE HOB.

DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE COOKING HOB

GRIDS.

DO NOT USE RECIPIENTS OR GRIDDLE PLATES THAT EXTEND BEYOND THE EXTERNAL

PERIMETER OF THE HOB.

THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS

POSITIONED VISIBLY UNDER THE CASING, ATTACHED TO THIS MANUAL AND APPLIED TO THE

QUALITY CERTIFICATE.

THE PLATE ON THE CASING MUST NOT BE REMOVED.

THE HOB IS TO BE USED BY ADULTS ONLY. DO NOT LET UNSUPERVISED CHILDREN PLAY WITH

THE HOB.

THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE

ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE).

THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF RETURN AND RECYCLING ON

WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT.

Instructions for the installer

2. Positioning of hob

2.1 Attachment to support structure

Create an opening with the dimensions shown in the figure in the top surface of the

counter, keeping a minimum distance of 50 mm from the rear border. This unit may be

set against walls that are higher than the hob as long as distance (see figure) is

maintained to prevent damage to the walls due to overheating. Make sure there is a

minimum of 750 mm between the hot plate flames and any shelf that may be installed

directly above them. In case of installation on a hollow compartment with doors, a

separating panel has to be placed under the hob. Keep a minimum distance of 10 mm

between the bottom of the unit and the panel surface. The panel has to be easily

removable to allow access in the event of technical service.

Whenever a cooker hood is to be installed above the hob, refer to the instruction

manual to ensure it is installed at the correct distance.

A (mm) B (mm) C (mm) D (mm) E (mm) X (mm) Y (mm) L (mm)

MOD.60 min 220 min 460 min 750 20÷40 min 50 596 555÷560 478÷482

MOD.70 min 280 min 460 min 750 20÷40 min 50 718 555÷560 478÷482

MOD.100 min 280 min 460 min 750 20÷40 min 50 1005 839÷844 480÷484

Product specificaties

Merk:	Smeg
Categorie:	Fornuis
Model:	PD64ES
Apparaatplaatsing:	Ingebouwd
Soort bediening:	Draaiknop
Kleur van het product:	Roestvrijstaal
Ingebouwd display:	Nee
Breedte:	596 mm
Diepte:	510 mm
Hoogte:	38 mm
Soort materiaal (bovenkant):	Roestvrijstaal
Vermogen brander/kookzone 2:	1650 W
Vermogen brander/kookzone 3:	3000 W
Vermogen brander/kookzone 1:	2300 W
Aantal branders/kookzones:	4 zone(s)
Type kookplaat:	Gaskookplaat
Electronische ontsteking:	Ja
Type brander/kookzone 1:	Regulier
Type brander/kookzone 2:	Regulier
Type brander/kookzone 3:	Extra groot
Aantal gaspitten:	4 zone(s)
Aantal elektronische kook zones:	0 zone(s)
Sudder brander/kookzone:	1000 W
Normale brander/kookzone:	1650 W
Controle positie:	Boven voorzijde
Installatie compartiment breedte:	555 mm
Grote brander/kookzone:	2300 W
Aangesloten lading (gas):	7950 W
Materiaal pannensteun:	Roestvrijstaal
Veiligheidsklep:	Ja
Installatie compartiment diepte (min):	478 mm
Extra grote hoge-snelheid kookzone:	3000 W
Type brander/kookzone 4:	Sudderen
Vermogen brander/kookzone 4:	1000 W
Voedingsbron brander/kookzone 1:	Gas
Voedingsbron brander/kookzone 2:	Gas
Voedingsbron brander/kookzone 3:	Gas
Voedingsbron brander/kookzone 4:	Gas
Installatie compartiment diepte (max):	482 mm
Positie brander/kookzone 1:	Links achter
Positie brander/kookzone 2:	Links voor
Positie brander/kookzone 3:	Rechts achter
Positie brander/kookzone 4:	Rechts voor
Kookzone 1 vorm:	Rond
Kookzone 2 vorm:	Rond
Kookzone 3 vorm:	Rond
Kookzone 4 vorm:	Rond
AC-ingangsspanning:	220 - 240 V
AC-ingangsfrequentie:	50 - 60 Hz
Voedingsbron brander/kookzone 5:	Gas
Voedingsbron brander/kookzone 6:	Gas
Type brander/kookzone 5:	Sudderen
Type brander/kookzone 6:	Groot
Positie brander/kookzone 5:	Midden voor
Vermogen brander/kookzone 5:	1000 W
Positie brander/kookzone 6:	Rechts
Vermogen brander/kookzone 6:	3600 W
Kookzone 5 vorm:	Rond
Kookzone 6 vorm:	Rond