SE Electronics Gemini II Handleiding

SE Electronics Microfoon Gemini II

Lees hieronder de 📖 handleiding in het Nederlandse voor SE Electronics Gemini II (32 pagina's) in de categorie Microfoon. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32

Gemini II

U s e r M a n u a l

User Manual - EN

Thank you

Thank you for choosing an sE microphone! In addition to some basic safety precautions, this manual

includes details and specifications that we hope will assist you in getting the most out of your Gemini II.

Please take a few minutes to read through it.

Capturing great audio is our passion. We sincerely hope you’ll enjoy the sound of this mic as much as we

enjoyed designing and building it for you.

Happy Tracking,

The sE Team

Brief Description

The Gemini II is our homage to the classic era of valve microphones. We wanted to create something

uniquely modern and versatile, while preserving the larger-than-life sonic legacy that defined tube mics of

decades past. This large-diaphragm cardioid condenser has that signature warmth and weight to its sound,

courtesy of a 12AX7 input valve, while boasting an unattenuated presence range. Where most microphones

have an output transformer, we have instead added a 12AU7 valve, giving the Gemini II the pristine top end

that you’d expect from an expensive solid-state mic. Vocal tones recorded with the Gemini II sound polished,

and ready to take front and center in your mix.

The Gemini II isn’t only for vocals, though. We’ve equipped it with a switchable low cut filter, as well as a

switchable -10dB pad, allowing it to shine on a variety of sources. In the drum room, on an acoustic guitar,

capturing the boom of timpani, or the intimacy of a cello, the Gemini II will not let you down.

All sE microphones are built by hand at our headquarters in Shanghai. We take pride in the attention to detail

under which our products are crafted, therefore the entirety of manufacturing is done in our own facilities. We

also test and measure the tubes for each Gemini II to ensure optimal performance.

What’s in the box

Your Gemini II includes a custom flight case to safely transport the microphone and its necessary

accessories. If anything is missing, please contact your sE Electronics dealer for assistance.

• Gemini II microphone

• Custom shock-mount

• 8-pin cable

• Power supply

• IEC power cable

Controls

The Gemini II features both an Attenuation Switch and a Low-Cut Switch.

Attenuation Switch

The is located on the front-left side of the microphone. When

Attenuation

Attenuation Attenuation Switch

Switch

SwitchSwitch

engaged, the incoming signal is reduced by , helping prevent signal distortion and 10dB

preamplifier clipping when capturing audio at close proximity and/or high sound

pressure levels.

Low-Cut Switch

The is located on the front-right side of the microphone, inserting a low-cut

Low

LowLow-Cut Switc

-Cut Switc

-Cut Switc-Cut Switch

filter at 0Hz when engaged. When switched to the left, the filter is removed for a flat 15

frequency response. This low-cut switch is useful for reducing wind noise, plosives, footfall

noise or rumble that ght adversely affect the recorded signal. Additionally, e low-cut mi th

filter will minimize the proximity effect when - placing the microphone a “close miking,” i.e.

very short distance from the source.

Powering

The included floor box contains the outboard power supply for the Gemini II . No

No No phantom

phantom

phantom phantom power

power

power power is

is is required

required

requiredrequired

from an interface or microphone preamplifier.

Before powering on, connect all required cables (IEC to power, XLR to preamplifier or interface, and 8-pin

cable from floor box to microphone). Then turn the power on via the switch on the back of the Gemini II floor

box.

For best performance, we recommend allowing approximately 15 minutes of “warm up” time before

recording. This allows the tubes within the Gemini II to heat up and stabilize and reduces the risk of unwanted

noise or distortion on your recordings.

Risk of damage

Do not connect the microphone to any power supply other than the included Gemini II

power supply. Do no

Do no

Do noDo not apply phantom voltage

t apply phantom voltage

t apply phantom voltaget apply phantom voltage (+48VDC) from an external interface or

preamplifier. This is the only way to ensure safe and reliable operati . on

Safety and maintenance

Risk of damage

Please make sure that the piece of equipment to which your microphone and PSU will

be connected fulfils the safety regulations enforced in your country and is fitted with a

ground lead.

Cleaning the microphone

The microphone should only be cleaned with a dry, soft cloth. It is best stored in the supplied wooden

presentation box.

Product specificaties

Merk:	SE Electronics
Categorie:	Microfoon
Model:	Gemini II
Kleur van het product:	Goud
Soort:	Microfoon voor studio's
Type verpakking:	Doos
Connectiviteitstechnologie:	Bedraad
Plug and play:	Ja
Opbergetui:	Ja
Aansluiting:	mini XLR (3-pin)
Signaal/ruis-verhouding:	81 dB
Microphone direction type:	Cardioïde
Gevoeligheid microfoon:	145 dB
Frequentie microfoon:	20 - 20000 Hz
Microphone input impedance:	200 Ohm
Gewicht microfoon:	1180 g
Gevoeligheid (1 kHz):	40 mV/Pa
Equivalent geluidsniveau:	13 dB