Ryobi RLT5027 Handleiding

Ryobi Grastrimmer RLT5027

Lees hieronder de 📖 handleiding in het Nederlandse voor Ryobi RLT5027 (24 pagina's) in de categorie Grastrimmer. Deze handleiding was nuttig voor 60 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24

RLT5027

ORIGINAL INSTRUCTIONS

Electric Lawn

Trimmer/Edge

Trimmer

Important!

It is essential that you read the instructions in this manual before assembling,

operating, and maintaining the product.

Subject to technical modification.

Safety, performance, and dependability have been given

top priority in the design of your electric lawn trimmer/edge

trimmer.

INTENDED USE

The product is only intended for use outdoors.

The product is designed for cutting grass, light weeds

and other similar vegetation at or about ground level.

The cutting plane should be approximately parallel to the

ground surface when trimming and approximately vertical

when edging.

The product should not be used to cut or trim hedges,

bushes or other vegetation where the

cutting plane is not at or about ground surface level.

GENERAL SAFETY WARNINGS

WARNING

When using the product, the safety rules must be

followed. For your own safety and that of bystanders,

please read these instructions before operating the

product. Please keep the instruction safe for later use.

WARNING

This power tool is not intended to be used by children

or persons with reduced physical, mental or sensory

capabilities. Children should be adequately supervised

to ensure they do not play with the power tool.

WARNING

Some regions have regulations that restrict the use of

the product. Check with your local authority for advice.

TRAINING

■Never allow children or people unfamiliar with these

instructions to use the product. Local regulations may

restrict the age of the operator.

■Read the instructions carefully. Be familiar with all

controls and the proper use of the machine.

■Keep bystanders, children and pets 15 m away from

the area of operation. Stop the product if anyone enters

the area.

■Never use the product when you are tired, ill or under

the influence of alcohol, drugs or medicine.

■Keep in mind that the operator or user is responsible

for accidents or hazards occurring to other people or

their property.

ELECTRICAL SAFETY

■Power plugs must match the outlet. Never modify the

plug in any way. Do not use any adapter plugs with

earthed (grounded) power tools. Unmodified plugs and

matching outlets will reduce risk of electric shock.

■Avoid unintentional starting. Always check that the

switch is in Off position before plugging in the product

to the power supply. Do not carry a plugged in product

with your finger on the switch.

■Avoid body contact with earthed or grounded surfaces,

such as pipes, radiators, ranges and refrigerators.

There is an increased risk of electric shock if your body

is earthed or grounded.

■Do not expose this product to rain or wet conditions.

Water entering an appliance will increase the risk of

electric shock

■Electrical power should be supplied via a residual

current device (RCD) with a tripping current of not more

than 30 mA.

■Before every use, examine the power cord for damage.

If there are signs of damage, it must be replaced by at

an Authorized Service Centre. Always uncoil the power

cord during use, coiled cables can overheat.

■If you need to use an extension cable ensure it is

suitable for outdoor use and has a current capacity

sufficient to supply your tool, check it before every

use for damage, always uncoil it during use because

coiled cables can overheat. Damaged extension cables

should not be repaired, they should be replaced with an

equivalent type.

■Do not use the product if the electric cables are

damaged or worn.

■If the power cord or extension cable becomes

damaged during use, disconnect from the power supply

immediately. Do not touch the electric cables until the

power supply has been disconnected.

■Make sure the power cord is positioned so that it

cannot be damaged by the cutting means and will not

be stepped on, tripped over or otherwise subjected to

damage or stress.

■Never pick up or carry the product by the electric cable.

■Never pull by the power cord to disconnect from the

power supply.

■Keep the power cord away from heat, oil and sharp

edges.

■Make sure voltage is correct for your product. A

nameplate on the product indicates the unit’s voltage.

Never connect the product to an AC voltage that differs

from this voltage.

■Make sure the switch is in Off position before

disconnecting from power supply.

PREPARATION

■Wear full eye and hearing protection while operating the

product. If working in an area where there is a risk of

falling objects, head protection must be worn.

■Hearing protection may restrict the operators ability

to hear warning sounds, pay particular attention to

potential hazards around and inside the working area.

■Wear heavy long trousers, boots, and gloves. Do not

wear loose fitting clothing, short trousers, jewellery of

any kind, or use with bare feet.

■Secure long hair so it is above shoulder level to prevent

entanglement in moving parts.

■Before use and after any impact, check that there are

no damaged parts. A defective switch or any part that

is damaged or worn should be properly repaired or

Product specificaties

Merk:	Ryobi
Categorie:	Grastrimmer
Model:	RLT5027
Kleur van het product:	Groen
Gewicht:	2800 g
Stroombron:	Elektrisch AC
Vermogen:	500 W
Snijdiameter (max):	1.5 mm
Verticale rand-snijden hoek:	90 °