Rockustics PavaRocci SweetSpot Handleiding
Pagina's 2 Speaker
Bekijk de handleiding van Rockustics PavaRocci SweetSpot gratis online of download de PDF. 25 mensen vonden deze handleiding nuttig. Vraag over dit model? Stel een vraag
SweetSpot™ Speakers
INSTALL INSTRUCTIONS
© 2021 MSE Audio. Rev. 02.19.2021
Ultra-Fidelity Outdoor Speakers
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / [email protected]
Please read the following instructions carefully before installing
your Rockustics
®
Sweetspot™ speaker. If you have any questions
regarding installation that are not answered in the following
directions, please contact your local sound contractor or the
Rockustics
®
/MSE Audio
®
technical support team.
Rockustics Sweetspot speakers are designed to combine
a stereo signal (left and right channel) into a single speaker
to provide a full audio experience from one speaker. The
Sweetspot speakers are equipped with dual voice coil woofers
and dual tweeters so they can merge left and right signal inputs
into great sounding audio from a single unit. Sweetspot models
are ideal for places where there is not enough room for stereo
speakers - or where it is impractical to use stereo speakers due
to the installation constraints.
Basic Wiring
1) Locate the speaker wires on the underside of the speaker.
If necessary, strip and trim the wire ends.
2) Connect the two speaker wire channels to the input signal
wire ():Diagram A
Channel 1: Red = positive, Black = ground
Channel 2: Blue = positive, Brown = ground
3) Use the supplied silicone wire nut to connect the leads.
Rockustics recommends using 14ga or heavier Direct
Burial cable for the connection between the amplier and
the speakers.
NOTE: The provided wire nuts are meant for permanent instal-
lation use only. If you are temporarily wiring the speakers, do not
use these wire nuts. In the event you have used the wire nuts, and
need to re-wire your system, do not attempt to unscrew the nuts.
Instead, clip the wires below the nut, and follow the steps in the
Basic Wiring section with a new pair of waterproof wire nuts (these
are available at most hardware stores).
Planter Set Up
(Diagram B) Fill planter with pea-gravel to approximately 2”
above the black insert box to ensure proper drainage. Gently
rock the planter from side to side so that gravel lles in the
gaps, providing ample coverage of the black insert box. Af-
ter lling with pea-gravel, top with soil, and continue planting
as you would any normal planter. Be sure to use the proper
amount of pea-gravel and soil to ll the planter; the soil and
gravel are important to the acoustic properties of the planter
and assist with the proper bass reproduction.
Diagram A
Diagram B
Product specificaties
| Merk: | Rockustics |
| Categorie: | Speaker |
| Model: | PavaRocci SweetSpot |
Heb je hulp nodig?
Als je hulp nodig hebt met Rockustics PavaRocci SweetSpot stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Speaker Rockustics
Rockustics Cherry Bomb Handleiding Rockustics BlockRock Handleiding Rockustics Coconutz Handleiding Rockustics OmniPlanter 8.0 Handleiding Rockustics SquareRoot 6.5 Handleiding Rockustics SquareRoot 6.5 TC Handleiding Rockustics PunkRock Handleiding Rockustics SquareRoot SweetSpot 6.5 TC Handleiding
Alle Rockustics Speaker handleidingen
Populair in Speaker
Rockustics StoneHenge II-S/T Handleiding Rockustics OmniPlanter 6.5 Handleiding Rockustics StoneHenge II-S Handleiding
Handleiding Speaker
Nieuwste handleidingen voor Speaker
Redragon Dora GS512 Handleiding Redragon Anvil GS520 Handleiding Redragon Connie GS814 Handleiding Kramer WM-8P-SUB Handleiding LG XBOOM Power 9000 Handleiding LG MF-FE411B Handleiding Redragon Adiemus GS560 Handleiding Tracer Poweraudio Crystal 60 BT TWS Handleiding Monitor Audio Silver 500 8G Handleiding Garmin Fusion MS-RA70 Handleiding