Powr-Flite PS900 Handleiding
Powr-Flite
Veegmachine
PS900
Lees hieronder de 📖 handleiding in het Nederlandse voor Powr-Flite PS900 (8 pagina's) in de categorie Veegmachine. Deze handleiding was nuttig voor 4 personen en werd door 2.5 gebruikers gemiddeld met 4.2 sterren beoordeeld
Pagina 1/8
WARNING: OPERATOR MUST READ AND UNDERSTAND THIS MANUAL COMPLETELY
BEFORE OPERATING THIS EQUIPMENT.
Commercial Sweeper
OPERATORS MANUAL AND PARTS LIST
Model PS900
X8792
- 2 -
Unpacking and Assembly
1. Your sweeper is shipped on a pallet. To remove the sweeper, cut the front
side of the box open and fold it under to form a ramp. Roll the sweeper over
the ramp so that the running wheels are still standing on
the pallet.
2. While the machine is in this position, install the side brushes. The side
brushes are located in the dirt container under the side brush plate in the
front exterior portion of the machine. Simply apply light pressure, twisting
the brushes upwards until you feel them lock into place.
NOTE: Do not tip over the machine in this process. There is a danger of
battery acid running out, creating a hazardous condition.
3. Roll the machine from the box and of
f of the pallet.
4. Put the handle in the upright position by pulling it downwards into the two
tappets completely
.
T
ighten with the two thumbscrews.
5. Install and connect the battery cables. Set the
safety switch on the handle to the "0" position.
6. The tool to unlatch the main cover is found inside the dirt collector bin.
Remove the dirt collector and using the tool, unlatch the main cover
.
Connect the positive pole of the battery and tighten with a wrench.
Connect the negative pole of the battery and tighten with a wrench.
The machine is now assembled and ready for operation.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Read all instructions before using this machine.
IMPORTANT SAFETY INSTRUCTIONS
This manual is to ensure that the PS900 is operated correctly. All oper-
ators must read, understand practice the following safety instructions.
Before use, check that the unit and operating equipment are in perfect
condition and are safe to operate. Do not use the machine if it is not in
perfect condition. This vacuum sweeper is intended exclusively for
operation on solid, level and dry surfaces with an inclination not
exceeding 2%.
CAUTION: Use only as described in this manual.
CAUTION: This sweeper must not be used for removing
hazardous materials.
CAUTION: Use only on surfaces indicated in the
operating instructions.
CAUTION: Never leave sweeper unattended while running.
CAUTION: Replace damaged or worn parts with genuine original
equipment parts in order to maintain safety and to
protect your warranty.
CAUTION: Never sweep over surfaces that are wet.
CAUTION: Do not store outdoors.
CAUTION: Keep hair, loose clothing, fingers, and all parts of body
away from openings and moving parts.
CAUTION: Do not reach into or under the machine under any
circumstances when the motor is running.
CAUTION: The hood latch should remain secured in the closed
position except when performing maintenance work.
CAUTION: Switch off the motor and secure the unit before
transporting.
CAUTION: Use only accessories and spare parts that have been
approved by the manufacturer.
CAUTION: Do not spray clean the unit.
CAUTION: Repairs may only be carried out by authorized customer
service centers.
Battery Operated Units
CAUTION:
Remove the battery lug or disconnect the battery before
working on the electrical system of battery-operated
units.
CAUTION: Always keep the batteries clean and dry in order to avoid
leakage current. Protect batteries from contaminants.
CAUTION: Do not place any tools, etc., on the battery to avoid risk
of short-circuiting and explosion.
CAUTION: Do not smoke, generate sparks or use open flame near
a battery or in a charging area.
CAUTION: Use caution when handling battery acid. Comply with
corresponding safety regulations.
CAUTION: Avoid picking up strings, cords, wires or
similar materials.
- 3 -
Starting Up/Operating
1. Lower the two side brushes by pushing the thumb washer forward with
your foot until the brushes just touch the floor. (see fig. #1)
2. Adjust the height of the main sweeping brush so that the brush tips only
touch the floor lightly. The adjustment handle is on the left side of the
machine (under the dirt collector.) If the brushes are adjusted too low, this
will increase the wear on the brushes and the gear components, as well as
power consumption.
(see fig. #2)
Position 1 – the highest brush position (for new, unworn rollers)
Position 5 – the lowest brush position (for worn brushes or very uneven
floors for a short period of time).
3. Turn the sweeper on by placing the safety switch on the handle to the
"1" position. (see fig. #3)
The LED’s over the switch will indicate how much of a charge is in the battery.
Green Light Sweeper is ready for operation.
Yellow Light Sweeper needs to be charged.
Red Light Turn the machine off immediately
(Turn the safety switch to "0") to keep the battery
from loosing its charge.
The safety switch will automatically turn off "0" if the motor is being overloaded.
If the motor load should become significantly higher, for example as a result of a
blockage or excessive resistance in the drive, the switch will go to the "0" posi-
tion and the sweeper will turn off. After eliminating the malfunction, the machine
may be restarted.
4. The sweeper starts moving when you carefully pull the handle towards you.
You can adjust speed by increasing or decreasing pressure on the handle.
For more areas with a heavier concentration of debris, the sweeper should
be pushed more slowly to achieve the optimum cleaning effect. Loosen the
grip on the handle slightly when going around curves to lower the speed in
the curve. To move the sweeper backwards, decrease pressure on the
handle and pull the machine in the desired location.
5. After you have finished sweeping, shut off the machine
(turn safety switch to "0.") (see fig. #3)
6. The filters must be cleaned after every use of the machine, prior to emptying
the dirt collector. There is a small knob located on top of the filter, in the
area of the dirt collector handle. Move the knob back and forth a number of
times. A vibrating mechanism will come on, loosening dirt that is sitting
between the lamellas so that it will fall directly into the dirt collector. If there
is stubborn dirt, clean the filter with a brush or remove the filter and
tap slightly.
(see fig. #4)
7. Always remove the dirt collector using both hands. Put one hand in the front
handle area in the middle of the machine. Put the other hand on the upper
edge from behind. Lift the container upwards from behind. It is easiest
to empty the dirt collector over the side edge. (see fig. #5 & 6)
8. The side brushes must be put in the ‘up’ position to alleviate the load on
them and ensure they are long lasting. Push the thumb washers backward
with your foot until the brushes clear the floor. (see fig. #7)
9. The battery should be charged after each use. This will guarantee that you
will always have a machine that is ready for operation. The charging socket
is located on the lower side of the operating console. Insert the charging
plug and connect charger. Follow instructing from charger for charging
times and cautions. (see fig. #8)
➊
➋
➌
➍
➎
➏
➐
➑
Product specificaties
| Merk: | Powr-Flite |
| Categorie: | Veegmachine |
| Model: | PS900 |
Heb je hulp nodig?
Als je hulp nodig hebt met Powr-Flite PS900 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Veegmachine Powr-Flite
9 Juni 2025
9 Juni 2025
Handleiding Veegmachine
- Veegmachine Karcher
- Veegmachine Scheppach
- Veegmachine Viper
- Veegmachine Mytee
- Veegmachine Tornado
- Veegmachine Lavorwash
- Veegmachine Sun Joe
- Veegmachine Haier
- Veegmachine Lavor
- Veegmachine Texas
- Veegmachine Taski
- Veegmachine Hyundai
- Veegmachine Vonroc
- Veegmachine Anova
- Veegmachine Blodgett
Nieuwste handleidingen voor Veegmachine
9 Juni 2025
9 Juni 2025
9 Juni 2025
9 Juni 2025
3 Juni 2025
21 Mei 2025
17 Mei 2025
9 Maart 2025
7 December 2024
15 November 2024