Pioneer AVH-X7500BT Handleiding

Pioneer Multimedia AVH-X7500BT

Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer AVH-X7500BT (53 pagina's) in de categorie Multimedia. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/53

Installation Manual

Manuel d installation’

Manuale d installazione’

Manual de instalación

Installationsanleitung

Installatiehandleiding

DVD RDS AV RECEIVER

AUTORADIO AV RDS LECTEUR DE DVD

SINTOLETTORE DVD RDS CON AV

RADIO AV RDS CON DVD

DVD-RDS-AV-EMPFÄNGER

DVD RDS AV-ONTVANGER

AVH-X7500BT

English NederlandsDeutschEspañolItalianoFrançais

WARNING

!To avoid the risk of accident and the potential vio-

lation of applicable laws, no viewing of front seat

video should ever occur while the vehicle is

being driven. Also, rear displays should not be in

a location where they are visibly distracting to

the driver.

!In some countries or states the viewing of images

on a display inside a vehicle even by persons

other than the driver may be illegal. Where such

regulations apply, they must be obeyed and this

unit s DVD features should not be used.’

CAUTION

!PIONEER does not recommend that you in-

stall or service your display unit yourself. In-

stalling or servicing the product may expose

you to risk of electric shock or other hazards.

Refer all installation and servicing of your

display unit to authorized Pioneer service

personnel.

!Do not drill a hole into the engine compart-

ment to connect the yellow cable of the dis-

play unit to the vehicle battery. Engine

vibration may eventually cause the insulation

to fail at the point where the wire passes

from the passenger compartment into the

engine compartment. Take extra care in se-

curing the wire at this point.

!Make sure that cables will not interfere with

moving parts of the vehicle, such as the shift

lever, parking brake or seat sliding mecha-

nism.

WARNING

!LIGHT GREEN LEAD AT POWER CONNEC -

TOR IS DESIGNED TO DETECT PARKED

STATUS AND MUST BE CONNECTED TO

THE POWER SUPPLY SIDE OF THE PARK-

ING BRAKE SWITCH. IMPROPER CON-

NECTION OR USE OF THIS LEAD MAY

VIOLATE APPLICABLE LAW AND MAY RE-

SULT IN SERIOUS INJURY OR DAMAGE.

Important

!This unit cannot be installed in a vehicle

without ACC (accessory) position on the igni-

tion switch.

ACC position No ACC position

!Use of this unit in conditions other than the

following could result in fire or malfunction.

—Vehicles with a 12-volt battery and negative

grounding.

—Speakers with 50 W (output value) and 4 toW

8 (impedance value).W

!To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

—Disconnect the negative terminal of the bat-

tery before installation.

—Secure the wiring with cable clamps or adhe-

sive tape. Wrap adhesive tape around wiring

that comes into contact with metal parts to

protect the wiring.

—Place all cables away from moving parts,

such as the shift lever and seat rails.

—Place all cables away from hot places, such

as near the heater outlet.

—Do not connect the yellow cable to the battery

by passing it through the hole to the engine

compartment.

—Cover any disconnected cable connectors

with insulating tape.

—Do not shorten any cables.

—Never cut the insulation of the power cable of

this unit in order to share the power with

other devices. The current capacity of the

cable is limited.

—Use a fuse of the rating prescribed.

—Never wire the negative speaker cable directly

to ground.

—Never band together negative cables of multi-

ple speakers.

!When this unit is on, control signals are sent

through the blue/white cable. Connect this

cable to the system remote control of an ex-

ternal power amp or the vehicle s auto-anten-’

na relay control terminal (max. 300 mA

12 V DC). If the vehicle is equipped with a

glass antenna, connect it to the antenna

booster power supply terminal.

!Never connect the blue/white cable to the

power terminal of an external power amp.

Also, never connect it to the power terminal

of the auto antenna. Doing so may result in

battery drain or a malfunction.

!The black cable is ground. Ground cables for

this unit and other equipment (especially,

high-current products such as power amps)

must be wired separately. If they are not, an

accidental detachment may result in a fire or

malfunction.

Connecting the units

Section

Connecting the units

Connecting the power cord

Notes:

· Change the initial setting of this unit (refer to the Operation Manual).

The subwoofer output of this unit is monaural.

· When using a subwoofer of 70 W (2 ) , be sure to connect with Violet Ω

and Violet/black leads of this unit. Do not connect anything to Green

and Green/black leads.

Connection method

1. Clamp the lead. 2. Clamp firmly with

needle-nosed pliers.

Note:

· The position of the parking brake switch depends on the vehicle model. For details,

consult the vehicle Owner ’s Manual or dealer.

Yellow/black

If you use an equipment with Mute function, wire this lead to the Audio Mute lead on

that equipment. If not, keep the Audio Mute lead free of any connections.

Light green

Used to detect the ON/OFF status of the parking brake. This lead

must be connected to the power supply side of the parking brake

switch.

Blue/white

Connect to system control terminal of the

power amp (max. 300 mA 12 V DC).

Blue/white (6*)

Connect to auto-antenna relay control terminal

(max. 300 mA 12 V DC).

The pin position of the ISO

connector will differ depending on

the type of vehicle. Connect 5* and

6* when Pin 5 is an antenna control

type. In another type of vehicle,

never connect 5* and 6*.

Blue/white (5*)

Ground side

Power supply side

Parking brake

switch

ISO connector

Note:

In some vehicles, the ISO connector may be divided into

two. In this case, be sure to connect to both connectors.

Note:

Depending on the kind of vehicle,

the function of 2* and 4* may be

different. In this case, be sure to

connect 1* to 4* and 3* to 2*.

Yellow (2*)

Back-up

(or accessory)

Yellow (1*)

Connect to the constant 12 V

supply terminal.

Connect leads of the same

color to each other.

Red (4*)

Accessory

(or back-up)

Red (3*)

Connect to terminal controlled by

ignition switch (12 V DC).

Black (chassis ground)

Connect to a clean, paint-free metal location.

Orange/white

Connect to lighting switch terminal.

Violet/white

Of the two lead wires connected to the back lamp, connect the one in which the

voltage changes when the gear shift is in the REVERSE (R) position. This connection

enables the unit to sense whether the car is moving forwards or backwards.

Speaker leads

White: Front left

White/black: Front left

Gray: Front right

Gray/black: Front right

Green: Rear left or subwoofer

Green/black: Rear left or subwoofer

Violet: Rear right or subwoofer

Violet/black: Rear right or subwoofer

Microphone

4 m

Microphone input

This product

Antenna input

AUX jack (3.5 ø)

( )AUX IN

Use a mini plug cable to connect

with auxiliary device.

RGB input

Navigation system

(AVIC-F250(sold

separately))

Please contact your dealer to

inquire about the connectable

navigation unit.

Insert the 26 pin cable in the direction

indicated in the figure.

26 pin cable (Supplied with navigation unit)

Wired remote input

Hard-wired remote control adapter can be connected (sold separately).

17 cm

Fuse (10 A)

English

Connecting the units

Section

Connecting the units

Product specificaties

Merk:	Pioneer
Categorie:	Multimedia
Model:	AVH-X7500BT
Kleur van het product:	Zwart
Ingebouwd display:	Ja
Bluetooth:	Ja
Beeldschermdiagonaal:	7 "
Resolutie:	800 x 480 Pixels
Touchscreen:	Ja
Bluetooth-profielen:	A2DP, AVRCP, HFP, SPP
Ondersteund audioformaat:	AAC, MP3, WMA
Ondersteunde videoformaten:	DIVX
Volumeregeling:	Draaiknop
Ondersteund beeldformaat:	JPG
Beeldverhouding:	16:9
Ingebouwde audio decoders:	Dolby Digital
Equalizer-instellingen:	Ja
AV-uitgang:	Ja
Horizontaal draaibaar:	50 - 110 °
Audio-uitgangskanalen:	4.0 kanalen
AV-ingang:	Ja
MP3 afspelen:	Ja
D/A-converter:	96 kHz/24-bit
Optische drive type:	CD, CD-R, CD-RW, DVD, DVD+R, DVD+RW, DVD-RW
Aantal optische schijven:	1 schijven
USB direct afspelen:	Ja
CD-R afspelen:	Ja
CD-RW afspelen:	Ja
Afstandsbediening inbegrepen:	Nee
Te gebruiken met een iPod:	Ja
Type beeldscherm:	LCD
DVD Audio playback:	Ja
Maximaal vermogen per kanaal:	50 W
Line outputs (RCA):	3
DVD Video playback:	Ja