Philips HD4603 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Philips HD4603 (15 pagina's) in de categorie Waterkoker. Deze handleiding was nuttig voor 60 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/15
www.philips.com
ENGLISH 2 - 3
FRANÇAIS 4 - 5
DEUTSCH 6 - 7
NEDERLANDS 8 - 9
ESPAÑOL 10 - 11
ITALIANO 12 - 13
PORTUGUÊS 14 - 15
HD4666, HD4665, HD4603, HD4602
2 3
45
HD4666, HD4665, HD4603, HD4602 4222 001 972312ENGLISH
Introduction.
Dear customer, thank you for buying a Philips kettle. In these instructions for use you
will find all the information you need to enjoy your kettle as long as possible.
General description.
1) On/off switch
2) Pilot light
3) Lid
4) Spout
5) Water-level indicator
6) Base
7) Scale filter
Important.
Read these instructions for use carefully before using the appliance and save them for
future reference.
â——Check if the voltage indicated on the base of the kettle corresponds to the
local mains voltage before you connect the appliance.
â——Only use the kettle in combination with its original base.
â——Always place the base and the kettle on a dry, flat and stable surface.
â——Keep the cord, the base and the appliance away from hot surfaces.
â——Do not use the appliance if the mains cord, the plug, the base or the appliance
itself is damaged.
â——If the mains cord is damaged, it must always be replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to avoid a
hazard.
â——Do not immerse the appliance or the base in water or any other liquid.
â——The kettle is only meant for boiling water. Do not use it to heat up soup or
other liquids or jarred, bottled or tinned food.
â——Boiling water can cause serious burns. Be careful when the kettle contains hot
water.
â——Never fill the kettle beyond the maximum level indication. If the kettle has
been overfilled, boiling water may be ejected from the spout and cause
scalding.
â——Do not open the lid while the water is boiling. Be careful when you open the
lid immediately after the water has boiled: the steam coming out of the kettle
is very hot.
â——Avoid touching the body of the kettle, as it gets very hot during use.Always lift
the kettle by its handle.
â——Keep the appliance and its cord out of the reach of children. Do not let the
mains cord hang over the edge of the table or worktop. Excess cord can be
stored in or around the base of the appliance.
â——Never fill the kettle below the minimum level to prevent the kettle from
boiling dry.
â——HD4603 and HD4666: this rapid-boil kettle can draw up to 13 amps from the
power supply in your home. Make sure that the electrical system in your home
and the circuit to which the kettle is connected can cope with this level of
power consumption. Do not let too many other appliances draw power from
the same circuit while the kettle is being used.
â——Some condensation may appear on the base of the kettle.This is perfectly
normal and does not mean that the kettle has any defects.
â——Depending on the hardness of the water in your area, small spots may appear
on the heating element of your kettle when you use it.This phenomenon is the
result of scale build-up on the heating element and on the inside of the kettle
over time.The harder the water, the faster scale will build up. Scale can occur
in different colours.Although scale is harmless, too much scale can influence
the performance of your kettle. Descale your kettle regularly by following the
instructions given in the chapter 'Descaling'.
Boil-dry protection
This kettle is equipped with boil-dry protection.This device will automatically switch
the kettle off if it is accidentally switched on when there is no water or not enough
water in it.The on/off switch will stay in 'on' position and the pilot light, if available, will
stay on. Switch the kettle off and let it cool down for 10 minutes.Then lift the kettle
from its base to reset the boil-dry protection.The kettle is ready for use again.
Before first use.
â——Remove stickers, if any, from the base or kettle.
â——Place the base on a dry, stable and flat surface.
â——Adjust the length of the cord by winding it round the reel in the base. Pass the
cord through one of the slots in the base (fig. 2).
Before using the kettle for the first time:
1Rinse the kettle with water.
2Fill the kettle with water up to the maximum level and let it boil once (see
'Using the appliance').
3Pour out the hot water and rinse the kettle once more.
Using the appliance.
1Fill the kettle with water either through the spout or through the open lid
(fig. 3).
2 3
4 5
HD4666, HD4665, HD4603, HD46023ENGLISH 4222 001 97231
Filter type
HD4978
HD4985
Kettle type(s)
HD4602 and HD4603
HD4665 and HD4666
2Close the lid.
Make sure that the lid is properly closed to prevent the kettle from boiling dry.
3Place the kettle on its base, put the plug in the wall socket and press the on/off
switch (fig. 4).
The kettle starts heating up.
â——The kettle switches off automatically when the water has reached boiling
point.
â——You can interrupt the boiling process by pressing the on/off switch.
Cleaning and descaling.
Always unplug the appliance before cleaning it.
Do not use any abrasive cleaning agents, scourers etc. to clean the kettle.
Never immerse the kettle or its base in water.
Cleaning the kettle
1Clean the outside of the kettle with a soft, damp cloth moistened with warm
water and some mild cleaning agent.
Scale is not harmful to your health but it may give your drink a powdery taste.The
scale filter prevents scale par ticles from ending up in your drink. Clean the scale filter
regularly.
2The filter can be cleaned:
â——by taking it out of the kettle and gently brushing the filter with a soft nylon
brush under a running tap, or.. (fig. 5).
â——by leaving it in the kettle when descaling the whole appliance, or...
â——in the dishwasher.
Descaling the kettle
Regular descaling will prolong the life of the kettle.
In case of normal use (up to 5 times a day), the following descaling frequency is
recommended:
- Once every 3 months for soft water areas (up to 18 dH).
- Once every month for hard water areas (more than 18 dH).
1Fill the kettle with water up to three-quarters of the maximum level and bring
the water to the boil.
2After the kettle has switched off, add white vinegar (8% acetic acid) to the
maximum level.
3Leave the solution in the kettle overnight.
4Empty the kettle and rinse the inside thoroughly.
5Fill the kettle with clean water and boil the water.
6Empty the kettle and rinse it with clean water again.
â——Repeat the procedure if there is still some scale in the kettle.
You can also use an appropriate descaler. In that case, follow the instructions on the
package of the descaler.
Replacement.
Replacement filters for your kettle can be purchased from your Philips dealer or a
Philips service centre.The table below indicates which filters are suitable for your
electric kettle.
If the kettle, the base or the mains cord of the appliance is damaged, take the base
or the kettle to a service centre authorised by Philips for repair or replacement of
the cord to avoid a hazard.
Guarantee & service.
If you need information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Customer Care Centre in your country (you
will find its phone number in the world-wide guarantee leaflet). If there is no
Customer Care Centre in your country, turn to your local Philips dealer or contact
the Service Department of Philips Domestic Appliances and Personal Care BV.


Product specificaties

Merk: Philips
Categorie: Waterkoker
Model: HD4603

Heb je hulp nodig?

Als je hulp nodig hebt met Philips HD4603 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Waterkoker Philips

Handleiding Waterkoker

Nieuwste handleidingen voor Waterkoker